ASTM F2462-2005 Standard Practice for Operation and Maintenance of Sewers with Optical Fiber Systems《带光纤系统的下水道的运行和维护的标准实施规程》.pdf

1、Designation: F 2462 05Standard Practice forOperation and Maintenance of Sewers with Optical FiberSystems1This standard is issued under the fixed designation F 2462; the number immediately following the designation indicates the year oforiginal adoption or, in the case of revision, the year of last r

2、evision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon (e) indicates an editorial change since the last revision or reapproval.1. Scope1.1 This practice applies to the operation and maintenanceof sewers with a subsequent installation of optical fiber cableper Pr

3、actice F 2303.1.2 This practice applies to gravity flow storm sewers,sanitary sewers, and combined sewers.1.3 This practice does not apply to force mains, siphons orother pressurized sewers.1.4 This standard does not purport to address all of thesafety concerns, if any, associated with its use. It i

4、s theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:2F 2303 Practice for Selection of Gravity Sewers Suitable forInstallation of Optica

5、l Fiber Cable and Conduits2.2 ANSI Standard:3ANSI Z117.1-2003 Safety Requirements for ConfinedSpaces2.3 IEC Standards:4IEC 60825-1 Ed. 1.2, en 2001 Safety of Laser ProductsPart 1: Equipment Classification, Requirements and Us-ers GuideIEC 60050-731 Electrotechnical Vocabulary: Optical FiberCommunica

6、tions2.4 Federal Standard:5OSHA Regulation 29 CFR Part 1910.146 Permit-RequiredConfined Spaces3. Terminology3.1 Definitions:3.1.1 conduit, ntubing used to house optical fiber cablethat is connected to, but separate from, a sewer pipeline.3.1.2 O4.1.2 Emergency response procedures, including sewagesp

7、ill control, emergency sewer pipeline repair, and communi-cation procedures;1This practice is under the jurisdiction of ASTM Committee F36 on Technologyand Underground Utilities and is the direct responsibility of Subcommittee F36.10on Installation and Operation of Fiber Optic Cables in Existing Sew

8、ers.Current edition approved Feb. 1, 2005. Published February 2005.2For referenced ASTM standards, visit the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM we

9、bsite.3Available from American National Standards Institute (ANSI), 25 W. 43rd St.,4th Floor, New York, NY 10036.4Available from the International Electrotechnical Commission, 3 rue deVaremb, P.O. Box 131, CH-1211, Geneva 20, Switzerland.5Available from U.S. Government Printing Office Superintendent

10、 of Documents,732 N. Capitol St., NW, Mail Stop: SDE, Washington, DC 20401.1Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959, United States.4.1.3 Routine sewer O sewer pipeline repairs; periodic sewerinspection; sewer pipeline cleaning;4.1.4 Routine

11、optical fiber system O4.1.5 Cable and conduit marking; and4.1.6 Worker qualification.5. Significance and Use5.1 This is intended to outline O and6.3.2.2 Where assistance by the optical fiber cable ownermay be necessary.6.4 Routine Operating Procedures:6.4.1 Notification:6.4.1.1 The sewer operator an

12、d fiber cable system ownershould notify the other entity as far in advance as possible forplanned, routine operations.6.4.1.2 Improper cable repair or maintenance proceduresmay damage the sewer or optical fiber system, creating anunsafe situation. Because of this risk, the fiber cable systemowner mu

13、st notify the sewer pipeline operator as to the natureof the intended repair or maintenance and verify whether seweroperator supervision or oversight is required during the repairor maintenance.6.4.2 Extended Duration Access (4 hours+) to Sewer Vaultsby Optical Fiber System OwnerWhen accessing a sew

14、ervault or sewer manhole, the optical fiber cable owner mustprovide the sewer pipeline operator with at least 48 hours priornotice. If re-cabling, replacing the conduit or other extendeddurations repairs are contemplated, the optical fiber systemowner must provide with that notice, written repair pr

15、ocedures,the duration and hours that the vault or manhole is beingaccessed and other requirements which may be locally required(traffic control plans, odor control, and so forth).6.4.3 Sewer Service ConnectionsThe optical fiber cableowner must provide the sewer pipeline operator with preferredmethod

16、s for adding sewer service connections. In the absenceof those preferences, the sewer pipeline operator may use anycustomary method.6.4.4 Sewer Pipeline Maintenance and RehabilitationTheoptical fiber cable owner must provide the sewer pipelineoperator with preferred methods for chemicals used for od

17、or,grease or root control, mechanical cleaning methods forblockages or roots, hydraulic cleaning or flushing methods,pipeline and manhole rehabilitation techniques, and so forth. Inthe absence of those preferences, the sewer pipeline operatormay use any customary method.6.5 Mutual Advice:6.5.1 Durin

18、g any inspection, the sewer pipeline operator oroptical fiber cable owner should advise the other of anydamage observed in the others facilities. Items that requireattention by the sewer pipeline operator include infiltration,flooded manholes, root intrusions, and so forth. Items thatrequire attenti

19、on of the optical fiber cable owner include vaultF2462052lid damage, crimps, open splice cases, standing water, pinches,nicks, or cuts in cable jacketing.6.6 Marking and Identification:6.6.1 VaultsIn sewer reaches containing optical fibercables, each sewer access (vault) must be clearly and conspicu

20、ously identified as containing optical fiber cables. A contactnumber must be provided where the optical fiber cable owneror sewer pipeline operator may access further instructions onhow to safely proceed.6.6.2 ConduitConduit containing optical fiber cable (lo-cated outside of the pipeline) must be

21、clearly and uniquelymarked to minimize the chances that the pipeline operator willinadvertently damage the cable by cutting or pinching opera-tions.7. O7.1.2 Safety procedures and personal protective equipmentfor accessing a sewer vault;7.1.3 The designated emergency notification contact(s) forthe s

22、ewer operator and optical fiber cable owner;7.1.4 The designated routine notification contact(s) for thesewer operator and optical fiber cable owner;7.1.5 Activities that are routine sewer O7.1.6 Activities that are routine optical fiber cable O7.1.7 Target times for advance notifications;7.1.8 Any

23、desire for the sewer pipeline operator or opticalfiber cable owner to observe the others field operations;7.1.9 Preferred methods for adding new house connectionsto the sewer;7.1.10 Preferred methods for sewer cleaning and mainte-nance;7.1.11 Preferred methods for sewer pipeline and manholerehabilit

24、ation;7.1.12 Types of sealants, solvents, coatings, and otherclasses of materials that may be installed inside sewer pipelinesystems;7.1.13 Any local or regional permit and inspection require-ments;7.1.14 Any subsequent revisions that are agreed upon byboth parties; and7.1.15 Other items which enhan

25、ces the O fiber installation method; operations andmaintenance; optical fiber; sewer gas; sewers;telecommunicationsASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly ad

26、vised that determination of the validity of any such patent rights, and the riskof infringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, eithe

27、r reapproved or withdrawn. Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend.

28、If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org).F2462053