BS 5722-1984 Specification for flammability performance of fabrics and fabric assemblies used in sleepwear and dressing gowns《睡衣与晨衣用织物与织物制品的可燃性规范》.pdf

1、BRITISH STANDARD BS 5722:1984 Specification for Flammability performance of fabrics and fabric assemblies used in sleepwear and dressing gownsBS5722:1984 This British Standard, having been prepared under the directionof the Clothing Standards Committee, was published under the authority ofthe Board

2、of BSI and comes intoeffect on 31 August 1984 BSI 07-1999 First published January 1979 First revision August 1984 The following BSI references relate to the work on this standard: Committee reference TCM/41 Draft for comment 83/37998 DC ISBN 0 580 14012 1 Committees responsible for this British Stan

3、dard The preparation of this British Standard was entrusted by the Clothing Standards Committee (CLM/-) to Technical Committee CLM/11 upon which the following bodies were represented: The following bodies were also represented in the drafting of the standard, through subcommittees and panels: Associ

4、ation of British Launderers and Furnishing Fabrics Association Cleaners Ltd. Home Laundering Consultative Council Association of Manufacturers of Domestic International Wool Secretariat Electrical Appliances Knitted Textile Dyers Federation British Clothing Industry Association Knitting Industries F

5、ederation Ltd. British Lace Federation Mail Order Traders Association of British Leather Manufacturers Research Great Britain Association Man-made Fibres Producers Committee British Retailers Association Ministry of Defence British Textile Rental Association National Association of Teachers of Home

6、Co-operative Wholesale Society Ltd. Economics Ltd. Confederation of British Wool Textiles Limited National Childrens Wear Association Consumer Standards Advisory Committee Soap and Detergent Industry Association of BSI Society of Dyers and Colourists Consumers Association Textile Institute Drapers C

7、hamber of Trade Textile Research Council British Burn Association Department of Trade and Industry British Nonwoven Manufacturers (Consumer Safety Unit, CCS Division) Association Home Office British Textile Employers Association Institute of Trading Standards Chemical Industries Association Administ

8、ration Co-operative Union Medical Research Council Department of Health and Social Security Royal Society for the Prevention of Accidents Amendments issued since publication Amd. No. Date of issue CommentsBS5722:1984 BSI 07-1999 i Contents Page Committees responsible Inside front cover Foreword ii 1

9、 Scope 1 2 Definitions 1 3 Flammability performance 1 4 Identification 2 Appendix A Sampling 3 Publications referred to Inside back coverBS5722:1984 ii BSI 07-1999 Foreword This revision of this British Standard has been prepared under the direction of the Clothing Standards Committee and the 1979 e

10、dition of this standard is now withdrawn. The scope of BS 5722 has been extended to include fabrics for dressing gowns and other changes have been introduced as a result of discussions concerning current UK legislation. The performance specification in BS 3121 is cited in the Nightdresses (Safety) R

11、egulations 1967 (SI 1967 No. 839), and it is expected that BS 5722 will form a basis for a revision of those Regulations. The committee responsible for the publication of BS 5438 has strongly indicated that general performance specifications are not appropriate, may possibly be misleading and should

12、 not be prepared. Instead of such specifications, it has recommended that individual performance specifications for defined end uses be produced. For that reason, this standard is limited in application to fabric and fabric assemblies for use in sleepwear and dressing gowns. It is essential that bot

13、h professional and home makers of garments are aware that the use of certain trims, accessories and sewing threads can have an adverse effect on the flammability of a garment. The use of different fabrics to produce a multi-layer garment can also have a similar effect and if such a design is to be u

14、sed, it is important to test the fabrics in the same combination as they will be used. If a degree of protection from flame is required, as much care is necessary with the design of the garment as with the main fabric. The importance of design is stressed in Shirley Institute Publication S17 “The fl

15、ammability of apparel fabrics and assemblies”, in PD 2777, and in the Standards Association of Australia publication AS 1249 “Childrens night clothes having reduced fire hazard”. It should be noted that this standard is intended to apply to fabrics and fabric assemblies used in the manufacture of sl

16、eepwear for use in normal circumstances. Where the sleepwear is intended for use in circumstances in which garments are frequently worn during daytime by wearers who are partially or completely immobile, different performance levels will often be more appropriate. Attention is drawn to the fact that

17、 the following statement is required to be an item of the test report specified in BS 5438. “The results may not apply to situations where there is restricted air supply or prolonged exposure to large sources of intense heat as in a conflagration”. This statement should be borne in mind when use is

18、made of this standard. A fabric complying with the requirements of the standard may not give protection against exposure to large sources of heat but it is intended to give protection against rapid flame spread arising from accidental contact with small sources of ignition. Attention is drawn to the

19、 Health and Safety at Work etc. Act 1974, and the need to ensure that the tests specified in this standard are carried out under suitable environmental conditions to provide adequate protection to personnel. A British Standard does not purport to include all the necessary provisions of a contract. U

20、sers of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, pages1 to 4, an inside back cover and

21、a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover.BS5722:1984 BSI 07-1999 1 1 Scope This British Standard specifies flammability performance requirements for fabrics, inc

22、luding multi-layer fabrics and fabric assemblies, for use in the production of sleepwear and dressing gowns. NOTEThe titles of the publications referred to in this standard are listed on the inside back cover. 2 Definitions For the purposes of this British Standard the following definitions apply. 2

23、.1 multi-layer fabric a fabric produced from a series of separate layers, intimately combined at a stage prior to garment production, e.g. quilted fabrics 2.2 fabric assembly a series of fabrics combined loosely at the garment manufacturing stage 2.3 sleepwear nightdresses, pyjamas and other similar

24、 garments intended to be worn next to the skin, normally in bed 2.4 dressing gown a garment primarily intended to be worn over sleepwear but including housecoats and other similar garments 3 Flammability performance 3.1 General 3.1.1 Samples shall comply with the requirements of 3.2.1 or 3.2.2 but i

25、f a sample fails to comply with3.2.2 then the performance requirements of3.2.1 shall apply, i.e. fabrics may be approved but not failed by the requirements of 3.2.2. Only the face of the fabric shall be tested, if this is apparent. If it is not apparent, only that face which is shown by pre-testing

26、to spread flame or spread flame the faster shall be tested. NOTE 1Guidance on selection of samples is given in Appendix A. NOTE 2Where garments are to be produced from a fabric assembly or from a multi-layer fabric, it is essential to test the fabrics in the combination in which they will be used. 3

27、.1.2 Single layer fabrics and fabric assemblies shall be submitted to the appropriate cleansing procedure described in BS 5651, depending on the information given on the care of the fabric, e.g. on the care label or in the garment specification. For multi-layer fabrics or for fabrics composed entire

28、ly of pure finish nylon, polyester or modacrylic fibre, i.e. with no added finish, the sample shall be submitted to one cycle only of the appropriate cleansing procedure described in BS 5651, depending on the information given on the care of the fabric, e.g. on the care label or in the garment speci

29、fication. For fabrics to be used in the manufacture of disposable products which are not capable of being cleansed, no durability procedures shall be carried out. 3.2 Performance requirements 3.2.1 Three specimens shall be tested in the machine direction and three in the cross direction in accordanc

30、e with test 3 of BS 5438 using a 10 s flame application time, except that the vertical trip threads shall not be used. None of the six specimens shall sever the 300 mm trip thread in less than 25 s. None of the six specimens shall sever the 600 mm trip thread in less than 50 s. If any one of the six

31、 specimens tested fails to comply with either performance requirement, then a further six specimens shall be tested. None of the second group of specimens shall fail either of the performance requirements. NOTEAttention is drawn to the procedure for testing short specimens and to the limitations on

32、the use of results from such specimens (see 11.8 and 11.9 of BS 5438:1976). 3.2.2 Three specimens shall be tested in the machine direction and three in the cross direction in accordance with test 2 of BS 5438 using a 10 s flame application time. No part of any hole nor any part of the lowest boundar

33、y of any flame shall reach the upper edge or either vertical edge of any specimen. If any one specimen does not comply with this requirement then, in accordance with B.5 of BS 5438:1976, eithera) or b) below applies. a) A further six specimens shall be tested in accordance with test 2 of BS 5438 and

34、 all six specimens shall comply with the requirement in the preceding paragraph but if any one specimen fails to comply then a further six specimens shall be tested in accordance with test 3 of BS 5438, and the requirements of 3.2.1 shall apply. b) A further six specimens shall be tested in accordan

35、ce with test 3 of BS 5438, and the requirements of 3.2.1 shall apply.BS5722:1984 2 BSI 07-1999 4 Identification A fabric for which compliance is claimed with the requirements of this standard shall be supplied with the following information. a) The manufacturers name, trade-mark or other identifying

36、 mark. b) The statement “Flammability complies with BS 5722:1984” 1) . NOTEIt is essential that this statement is not used in any description of a garment. c) Instructions on any special precautions to be taken concerning care, including cleansing of the garment to be manufactured from the fabric, p

37、referably using an appropriate care labelling symbol and taking account of the durability procedure used. If the fabric is intended for use in the manufacture of disposable products which are not capable of being cleansed, this shall be stated. NOTEAttention is drawn to the fact that any claim refer

38、ring to the flammability of garments will need to satisfy the requirements of the Nightdresses and Dressing Gowns (Safety) Regulations 1985. Attention is also drawn to the fact that it is essential that any claims concerning the flammability of fabrics satisfy the requirements of the Fabrics (Misdes

39、criptions) Act and any Regulations made thereunder. 1) Marking BS 5722:1984 on or in relation to a product is a claim by the manufacturer that the product has been manufactured to the requirements of the standard. The accuracy of such a claim is therefore solely the manufacturers responsibility. Enq

40、uiries as to the availability of third party certification to support such claims should be addressed to the Director, Quality Assurance Division, BSI, Maylands Avenue, Hemel Hempstead, Herts HP2 4SQ for certification marks administered by BSI or to the appropriate authority for other certification

41、marks.BS5722:1984 BSI 07-1999 3 Appendix A Sampling At least one sample shall be taken, of sufficient size to provide the specimens for the test, from each finishing batch or from every 5 000 m. NOTE 1Alternative frequencies of testing may be agreed between the supplier and the purchaser. NOTE 2The

42、term “batch” is defined in BS 4778. For the purposes of this standard, if different process routes are followed, e.g. different colour ways of a base fabric, the resultant fabrics should be regarded as being from different batches.4 blankBS5722:1984 BSI 07-1999 Publications referred to BS 3121, Perf

43、ormance requirements of fabrics described as of low flammability 2) . BS 4778, Glossary of terms used in quality assurance (including reliability and maintainability terms). BS 5438, Methods of test for flammability of vertically oriented textile fabrics and fabric assemblies subjected to a small ig

44、niting flame. BS 5651, Cleansing and wetting procedures for use in the assessment of the effect of cleansing and wetting on the flammability of textile fabrics and fabric assemblies. PD 2777, Fabric flammability burning accidents and the relevance of BS 5438 2) . 2) Referred to in the foreword only.

45、BS 5722:1984 BSI 389 Chiswick High Road London W4 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions BritishS

46、tandards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while us

47、ing this BritishStandard would inform the Secretary of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. Fax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically recei

48、ve the latest editions of standards. Buying standards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:02089969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI implementation

49、of those that have been published as BritishStandards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase p