BS 6571-8-1997 Vehicle parking control equipment - Specification for pre-purchased parking vouchers《停车控制设备 预购停车凭单规范》.pdf

1、| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | BRITISH STANDARD BS 6571 : Part 8 : 1997 I

2、CS 93.080.30 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW Vehicle parking control equipment Part 8. Specification for pre-purchased parking vouchersBS 6571 : Part 8 : 1997 This British Standard, having been prepared under the direction of the Sector Board for Building and C

3、ivil Engineering, was published under the authority of the Standards Board and comes into effect on 15 October 1997 BSI 1997 The following BSI references relate to the work on this standard: Committee reference B/509/20 Draft for comment 96/104937 DC ISBN 0 580 27976 6 Amendments issued since public

4、ation Amd. No. Date Text affected Committees responsible for this British Standard The preparation of this British Standard was entrusted by Technical Committee B/509, Road equipment, to Subcommittee B/509/20, Vehicle parking control equipment, upon which the following bodies were represented: Assoc

5、iation of Chief Police Officers of England and Wales Association of District Councils Association of London Authorities Association of Metropolitan Authorities British Parking Association Department of Transport (Highways Agency) Institution of Civil Engineers Insitution of Highways and Transportati

6、on Parking Committee for London Royal Automobile Club Co-opted membersBS 6571 : Part 8 : 1997 BSI 1997 i Contents Page Committees responsible Inside front cover Foreword ii Specification 1 Scope 1 2 References 1 3 Definitions 1 4 General requirements 1 5 Physical requirements 2 6 Validation format 2

7、 7 Security 2 Annexes A (informative) A typical set of instructions and conditions of use 3 B (normative) Method of test for curl in paper and board under exposure to normal conditions 3 List of references Inside back coverii BSI 1997 BS 6571 : Part 8 : 1997 Foreword This Part of BS 6571 has been pr

8、epared by Subcommittee B/509/20. It is a new Part of BS 6571. Other Parts of BS 6571 are as follows: Part 1 : Specification for coin operated clockwork parking meters Part 2 : Specification for electrically powered parking meters Part 3 : Specification for pay and display equipment Part 4 : Specific

9、ation for barrier type parking control equipment Part 5 : Guide to the requirements for non-coin operated apparatus for use with parking control Part 6 : Specification for pay-on-foot parking control equipment Part 7 : Specification for parking discs Further Parts are under consideration, in particu

10、lar: Part 9 : Specification for in-car electronic devices Part 10 : Code of practice for ancillary parking equipment and parking signs Whilst it is not within the scope of this standard, attention is drawn to the guidance of the Design Council on the aesthetic qualities of street furniture. Product

11、certification. Users of this British Standard are advised to consider the desirability of third party certification of product conformity with this British Standard, based on testing and continuing product surveillance, which may be coupled with assessment of a suppliers quality systems against the

12、appropriate Part of BS EN ISO 9000, Quality management and quality assurance standards. Enquiries as to the availability of third party certification schemes are forwarded by BSI to the Association of British Certification Bodies. If a third party certification scheme does not already exist, users s

13、hould consider approaching an appropriate body from the list of Association members. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and ii, pages 1 to 4, an inside ba

14、ck cover and a back cover. BSI 1997 1 BS 6571 : Part 8 : 1997 Specification 1 Scope This Part of BS 6571 specifies the requirements for pre-purchased parking vouchers which are validated and displayed in the vehicle as evidence of payment or permission to park at the time of parking. It excludes per

15、mits issued for disabled drivers under statutory regulations even if paid for, as these are covered by Part 7. It also excludes season tickets, location permits and status permits, e.g. business or resident permits which are valid for more than one parking act. 2 References 2.1 Normative references

16、This Part of BS 6571 incorporates, by dated or undated reference, provisions from other publications. These normative references are made at the appropriate places in the text and the cited publications are listed on the inside back cover. For dated references, only the edition cited applies; any su

17、bsequent amendments to or revisions of the cited publication apply to this Part of BS 6571 only when incorporated in the reference by amendment or revision. For undated references, the latest edition of the cited publication applies, together with any amendments. 2.2 Informative references This Part

18、 of BS 6751 refers to other publications that provide information or guidance. Editions of these publications current at the time of issue of this standard are listed on the inside back cover, but reference should be made to the latest editions. 3 Definitions For the purposes of this Part of BS 6571

19、 the following definitions apply. 3.1 parking place An area within which parking is permitted under specified conditions. 3.2 parking space An area within a parking place laid out for one or several vehicles. 3.3 parking authority The organization legally responsible for the parking place. 3.4 parki

20、ng tariff The amount charged for a specific period of time. 3.5 parking unit A variable in which the value of a parking voucher may be measured, recorded and sold. 3.6 parking voucher A passive device purchased in advance, which can be validated for inspection to permit the vehicle to park in accord

21、ance with specified conditions. 3.7 parking voucher value An amount in pounds and pence or parking units pre-printed on the parking voucher. 3.8 validation format The factors indicated on the parking voucher which are required to be validated at the time of use in accordance with the specified instr

22、uctions for use of the parking place. 3.9 validation The process by which the parking voucher is distinctly and permanently validated by the user. 3.10 initial parking time The period of parking permitted by the conditions of use of the parking place following the validation and display of the parki

23、ng voucher(s). 3.11 voucher zone An area into which each entrance for vehicular traffic has been indicated by a Voucher Parking Zone sign and in which, except where there is provision of parking places in at least one of which vouchers may be used, every road has been marked with No waiting or No lo

24、ading restrictions. 4 General requirements 4.1 Layout 4.1.1 Front face On the front face of the parking voucher the following shall be printed: a) the name of the parking authority; b) a scheme logo; c) information on the validation format; d) a statement requesting compliance with any instructions

25、on the reverse; e) the validation format (see clause 6); f) the value of the voucher (see 3.7); g) a serial number unique within each parking authority and for each voucher value (see 7.2); h) zone(s) in which the voucher may be used if relevant; i) a statement indicating that misuse of the voucher

26、is an offence.2 BSI 1997 BS 6571 : Part 8 : 1997 4.1.2 Back face On the back face of the parking voucher shall be printed full instructions for its use. The remainder of the back face may be used for advertising or any other purpose authorized by the parking authority. The instructions shall include

27、 the following: a) at what time the voucher is to be used; NOTE 1. This may direct the voucher user to another source for this information, e.g. street signs. b) how the voucher or vouchers (when more than one is allowed) is/are to be validated; c) how the voucher or vouchers (when more than one is

28、allowed) is/are to be displayed; d) circumstances in which an offence/contravention occurs. NOTE 2. A typical set of instructions and conditions of use are set out in annex A. 5 Physical requirements 5.1 Curl The average curl of the voucher shall not exceed 12 mm when tested in accordance with annex

29、 B. 5.2 Shape The voucher shall be rectangular with the long edge vertical when displayed. 5.3 Size The displayed length of the voucher shall be between 120 mm and 260 mm and the width of the voucher shall be between 75 mm and 110 mm. Any perforated, pre-creased or indented length for folding over o

30、r for securing the voucher in a block or pad of vouchers shall be additional to this. 5.4 Display A voucher which is required to be displayed by bending over the top of a wind-down window shall have a length for this purpose additional to that specified in 5.3 of not less than 10 mm and not greater

31、than 20 mm. This length may have printed on it any of the required information specified in 4.1.1 c) and d). The line on which it is intended to be bent shall be indicated clearly and indented to facilitate correct display. 6 Validation format 6.1 The validation format shall include the month, the d

32、ay of the week and the date of the month. It may also include the year and zone(s) if required by the parking authority. NOTE. It is not generally considered necessary to include both the year and day of the week, since either by itself will ensure non-repetition within 5 years when taken together w

33、ith the day of the month. 6.2 If the period of parking is for less than one day, the validation format shall include the time of day in hours and minutes as specified in 6.3 e), or a specified period or periods of the day (e.g. 8.30 am to 2 pm). 6.3 The above factors when used shall be printed on th

34、e front face of the parking voucher as follows: a) the year if abbreviated shall be to the last two digits and shall have the description YEAR; b) the month if abbreviated shall be to JAN, FEB, MAR, APR, MAY, JUN, JUL, AUG, SEP, OCT, NOV, DEC and shall have the description MONTH; c) the day of the m

35、onth shall have the description DATE; d) the day of the week if abbreviated shall be to MON, TUE, WED, THU, FRI, SAT, SUN and shall have the description DAY; e) if the time of day is indicated in hours and minutes, these may be shown separately or together and they shall have the description HOUR an

36、d MINUTES. Hours may be shown in either 12 hour or 24 hour format. Minutes shall be shown at 5 min intervals, 0-55. 6.4 The minimum height of letters and numbers shall be as follows: a) 8 mm for voucher value numbers; b) 3 mm for other numbers and upper case letters; c) 2 mm for lower case letters.

37、7 Security 7.1 Forgery/counterfeiting The parking voucher shall have a level of security against forgery and counterfeiting appropriate to its value and as determined by the parking authority. 7.2 Serial number For each parking authority every voucher shall be printed with a unique serial number whi

38、ch may be alpha/numeric. 7.3 Protection against abuse Where a parking voucher is required to be cancelled by rubbing off a latex patch or by other means there shall be a clear visual contrast between: a) the patch and the area behind it; b) the area behind the patch and the printing on that area; c)

39、 the area behind the patch and the adjacent part of the voucher.BS 6571 : Part 8 : 1997 BSI 1997 3 1) This may be omitted if required. Annexes Annex A (informative) A typical set of instructions and conditions of use The following are recommended sets of instructions and conditions for use which wou

40、ld be placed on the back face of the voucher. Diagrams indicating the method of validation and display may also be present. Instructions for use On arrival at the parking place: CHECK bay (or street) signs for: voucher parking logo; the name of the parking authority; hours of operation; maximum park

41、ing time allowed; parking tariff. VALIDATE one or two vouchers (or other number as determined by the parking authority) as appropriate by scratching off five panels to indicate your time of arrival: month; date (of month); day (of week); hour (of day); minutes (to next 5 min). DISPLAY the clearly va

42、lidated voucher(s), up to the maximum parking time allowed, inside your vehicle against the side window nearest the kerb with the front face outward, (or place with front face up on your dashboard 1) ), so that the voucher(s) can be read easily from outside your vehicle. If two (or more) vouchers ar

43、e displayed, they must be marked identically and displayed side by side. Principal conditions of use (If the parking scheme is operating under the terms of the Road Traffic Regulation Act 1984 and subsequent amendments): You are liable to an excess charge (of X) if you park beyond the time purchased

44、 up to the excess period of Y hours. NOTE. A parking authority may wish not to put the actual value of the excess charge to give the opportunity of changing it without having to print new vouchers. It is an OFFENCE: to indicate false arrival information; to display further vouchers after arrival; no

45、t to display a validated voucher or vouchers in the voucher zone (unless exempt); to park beyond the excess period; to return to the same parking place within Z hours; to display more than N vouchers. (If the parking scheme is operating under the terms of the Road Traffic Act 1991): You are liable t

46、o a penalty charge if you: a) park beyond the selected parking period; b) falsely indicate the time of arrival; c) replace the initial vouchers; d) return to the same parking place within Z hour(s) of leaving; e) do not display a voucher; f) display more than N vouchers; g) display further vouchers

47、after arrival. Annex B (normative) Method of test for curl in paper and board under exposure to normal conditions B.1 Principle The voucher is placed on a bench in a controlled atmosphere and any tendency for upward curl is measured. This test is a modified version of the RTM 31 developed by the Bri

48、tish Paper and Board Industry Federation Test Methods Committee 1. The method is suitable for most papers and boards. B.2 Apparatus B.2.1 Measuring rule, graduated in millimetres with no ungraduated margin. B.3 Test conditions B.3.1 Conditioning atmosphere controlled at (50 2) % relative humidity an

49、d 23 C 1 C as specified in BS EN 20187 (see note). NOTE. If required, this method may be used in any atmospheric condition within the range 30 % to 65 % relative humidity so long as the conditions are stable for the duration of the test. B.4 Procedure Place two vouchers on a flat surface in the conditioning atmosphere so that one has its front face uppermost and the other has its back face uppermost. Allow the test pieces to condition for at least 15 min. Measure the curl by placing the rule vertically close to each corner in turn and