BS EN 15919-2011 Fertilizers Extraction of phosphorus soluble in 2 % formic acid《肥料 溶于2%甲酸的磷的萃取》.pdf

1、raising standards worldwideNO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Standards PublicationBS EN 15919:2011Fertilizers Extraction ofphosphorus soluble in 2 %formic acidBS EN 15919:2011 BRITISH STANDARDNational forewordThis British Standard is the UK implementation of E

2、N 15919:2011. Itsupersedes DD CEN/TS 15919:2009 which is withdrawn.The UK participation in its preparation was entrusted to TechnicalCommittee CII/37, Fertilisers and related chemicals.A list of organizations represented on this committee can beobtained on request to its secretary.This publication d

3、oes not purport to include all the necessaryprovisions of a contract. Users are responsible for its correctapplication. BSI 2011ISBN 978 0 580 72725 2ICS 65.080Compliance with a British Standard cannot confer immunity fromlegal obligations.This British Standard was published under the authority of t

4、heStandards Policy and Strategy Committee on 30 June 2011.Amendments issued since publicationDate Text affectedBS EN 15919:2011EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 15919 June 2011 ICS 65.080 Supersedes CEN/TS 15919:2009English Version Fertilizers - Extraction of phosphorus soluble in

5、 2 % formic acid Engrais - Extraction du phosphore soluble dans lacide formique 2 % Dngemittel - Extraktion des in 2%iger Ameisensure lslichen Phosphors This European Standard was approved by CEN on 29 April 2011. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipul

6、ate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CEN member. This European St

7、andard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions. CEN members are the n

8、ational standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Swit

9、zerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels 2011 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No.

10、 EN 15919:2011: EBS EN 15919:2011EN 15919:2011 (E) 2 Contents Page Foreword 3 1 Scope 4 2 Normative references 4 3 Terms and definitions .4 4 Sampling .4 5 Principle 4 6 Reagents .4 7 Apparatus .4 8 Procedure .5 Bibliography 6 BS EN 15919:2011EN 15919:2011 (E) 3 Foreword This document (EN 15919:2011

11、) has been prepared by Technical Committee CEN/TC 260 “Fertilizers and liming materials”, the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by December 2011, an

12、d conflicting national standards shall be withdrawn at the latest by December 2011. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. Th

13、is document supersedes CEN/TS 15919:2009. This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to i

14、mplement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden,

15、 Switzerland and the United Kingdom. BS EN 15919:2011EN 15919:2011 (E) 4 1 Scope This document specifies the procedure for the determination of phosphorus soluble in 2 % formic acid (20 g per litre). The method is applicable to soft natural phosphates exclusively. 2 Normative references The followin

16、g referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 1482-2, Fertilizers and liming materials Sampling and samp

17、le preparation Part 2: Sample preparation EN 12944-1:1999, Fertilizers and liming materials and soil improvers Vocabulary Part 1: General terms EN 12944-2:1999, Fertilizers and liming materials and soil improvers Vocabulary Part 2: Terms relating to fertilizers CEN/TS 15959, Fertilizers Determinatio

18、n of extracted phosphorus 3 Terms and definitions For the purposes of this document, the terms and definitions given in EN 12944-1:1999 and EN 12944-2:1999 apply. 4 Sampling Sampling is not part of the method specified in this document. A recommended sampling method is given in EN 1482-1. Sample pre

19、paration shall be carried out in accordance with EN 1482-2. Grinding is recommended for homogeneity reasons. 5 Principle To differentiate between hard natural phosphates and soft natural phosphates, phosphorus soluble in formic acid is extracted from the test portion with a 2 % formic acid solution

20、under specified conditions. 6 Reagents 6.1 Water, distilled or demineralised. 6.2 Formic acid, 2 % ( = 20 g/l). Make 82 ml of formic acid (concentration 98 % to 100 %; d20= 1,22 g/ml) up to 5 l with distilled water. 7 Apparatus 7.1 Common laboratory equipment and glassware. BS EN 15919:2011EN 15919:

21、2011 (E) 5 7.2 500 ml graduated flask, with a wide neck (e.g. Stohmann). 7.3 Rotary shaker, 35 turns to 40 turns per min. 7.4 Dry pleated filter, free from phosphates. 8 Procedure 8.1 Test portion Weigh, to the nearest 0,001 g, 5 g of the laboratory sample and place it in a dry 500 ml graduated flas

22、k (7.2). 8.2 Extraction While continuously rotating the flask by hand, add formic acid (6.2) to the test portion at (20 1) C until it is approximately 1 cm below the graduation mark and make up to the volume with formic acid (6.2). Close the flask with a rubber stopper and shake for 30 min at (20 2)

23、 C on a rotary shaker (7.3). Filter the solution through a dry pleated filter (7.4) into a dry glass receptacle. Discard the first portion of the filtrate. Continue the filtering until a sufficient quantity of filtrate is obtained to carry out the phosphorus determination according to CEN/TS 15959.

24、BS EN 15919:2011EN 15919:2011 (E) 6 Bibliography 1 EN 1482-1, Fertilizers and liming materials Sampling and sample preparation Part 1: Sampling 2 Regulation (EC) No 2003/2003 of the European Parliament and of the Council of 13 October 2003 relating to fertilisers, Official Journal L 304, 21/11/2003,

25、 P. 0001-0194, Annex IV, method 3.1.2 This page deliberately left blankBSI is the independent national body responsible for preparing British Standardsand other standards-related publications, information and services. It presents the UK view on standards in Europe and at the international level. It

26、 is incorporated by Royal Charter.British Standards Institution (BSI)raising standards worldwideBSI Group Headquarters389 Chiswick High Road London W4 4AL UKTel +44 (0)20 8996 9001Fax +44 (0)20 8996 Standards are updated by amendment or revision. Users of British Stan-dards should make sure that th

27、ey possess the latest amendments or editions.It is the constant aim of BSI to improve the quality of our products and serv-ices. We would be grateful if anyone finding an inaccuracy or ambiguity whileusing this British Standard would inform the Secretary of the technical com-mittee responsible, the

28、identity of which can be found on the inside frontcover.Tel: +44 (0)20 8996 9001 Fax: +44 (0)20 8996 7001BSI offers Members an individual updating service called PLUS which ensuresthat subscribers automatically receive the latest editions of standards.Tel: +44 (0)20 8996 7669 Fax: +44 (0)20 8996 700

29、1Email: Buying standardsYou may buy PDF and hard copy versions of standards directly using acredit card from the BSI Shop on the website addition all orders for BSI, international and foreign standards publicationscan be addressed to BSI Customer Services.Tel: +44 (0)20 8996 9001 Fax: +44 (0)20 899

30、6 7001Email: In response to orders for international standards, it is BSI policy tosupply the BSI implementation of those that have been publishedas British Standards, unless otherwise requested.Information on standardsBSI provides a wide range of information on national, Europeanand international s

31、tandards through its Knowledge Centre.Tel: +44 (0)20 8996 7004 Fax: +44 (0)20 8996 7005Email: Various BSI electronic information services are also available whichgive details on all its products and services. Tel: +44 (0)20 8996 7111 Fax: +44 (0)20 8996 7048Email: BSI Subscribing Members are kept up

32、 to date with standardsdevelopments and receive substantial discounts on the purchase priceof standards. For details of these and other benefits contact Membership Ad-ministration. Tel: +44 (0)20 8996 7002 Fax: +44 (0)20 8996 7001 Email: Information regarding online access to British Standards via

33、BritishStandards Online can be found at information about BSI is available on the BSI website at www.bsi- subsists in all BSI publications. BSI also holds the copyright,in the UK, of the publications of the international standardization bodies. Ex-cept as permitted under the Copyright, Designs and

34、Patents Act 1988 no ex-tract may be reproduced, stored in a retrieval system or transmitted in anyform or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the freeuse, in the course of implementing the standard of necessa

35、ry details such assymbols, and size, type or grade designations. If these details are to be usedfor any other purpose than implementation then the prior written permissionof BSI must be obtained. Details and advice can be obtained from the Copy-right & Licensing Manager.Tel: +44 (0)20 8996 7070Email: