BS EN ISO 105-B04-1997 Textiles Tests for colour fastness Colour fastness to artificial weathering Xenon arc fading lamp test《纺织品 颜色牢度试验 耐人工风化色牢度 氙弧灯试验》.pdf

1、BRITISH STANDARD BS EN ISO 105-B04:1997 Textiles Tests for colour fastness Part B04: Colour fastness to artificial weathering: Xenon arc fading lamp test (ISO 105-B04:1994) The European Standard EN ISO 105-B04:1997 has the status of a British Standard ICS 59.080.01BSEN ISO 105-B04:1997 This British

2、Standard, having been prepared under the directionof the Sector Board forMaterials and Chemicals, waspublished under the authorityof the Standards Boardand comes into effect on 15August1997 BSI 09-1999 ISBN 0 580 27819 0 National foreword This British Standard is the English language version of ENIS

3、O105-B04:1997. It is identical with ISO105-B04:1994. It supersedes the corresponding method in BS1006:1990 which is withdrawn by amendment. The UK participation in its preparation was entrusted by Technical Committee TCI/25, Chemical properties, to Subcommittee TCI/25/-/10, Colour fastness, which ha

4、s the responsibility to: aid enquirers to understand the text; present to the responsible international/European committee any enquiries on the interpretation, or proposals for change, and keep the UK interests informed; monitor related international and European developments and promulgate them in

5、the UK. A list of organizations represented on this subcommittee can be obtained on request to its secretary. Cross-references Attention is drawn to the fact that Annex ZA lists normative references to international publications with their corresponding European publications. The British Standards w

6、hich implement these international or European publications may be found in the BSI Standards Catalogue under the section entitled “International Standards Correspondence Index”, or using the “Find” facility of the BSI Standards Electronic Catalogue. A British Standard does not purport to include al

7、l the necessary provisions of a contract. Users of British Standards are responsible for their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Summary of pages This document comprises a front cover, an inside front cover, pages i and

8、 ii, theEN ISO title page, page 2, the ISO title page, pages ii to iv, pages 1 to 6, aninside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover. Amendments

9、 issued since publication Amd. No. Date CommentsBSEN ISO 105-B04:1997 BSI 09-1999 i Contents Page National foreword Inside front cover Foreword 2 Foreword iii Text of ISO 105-B04 1ii blankEUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN ISO 105-B04 April 1997 ICS 59.080.01 Descriptors: See ISO d

10、ocument English version Textiles Tests for colour fastness Part B04: Colour fastness to artificial weathering: Xenonarc fading lamp test (ISO 105-B04:1994) Textiles Essais de solidit des teintures Partie B04: Solidit des teintures aux intempries artificielles: Lampe arc au xnon (ISO 105-B04:1994) Te

11、xtilien Farbechtheitsprfungen Teil B04: Farbechtheit gegen knstliche Bewetterung: Xenonbogenlicht (ISO 105-B04:1994) This European Standard was approved by CEN on 1997-03-28. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this Euro

12、pean Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. The European Standards exist in three official versions (English,

13、 French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Denmark, Finla

14、nd, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central Secretariat: rue de Stassart 36, B-1050 Bru

15、ssels 1997 CEN ALL rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. EN ISO 105-B04:1997 EEN ISO 105-B04:1997 BSI 09-1999 2 Foreword The text of the International Standard from Technical Committee ISO/TC38 “Textiles” of the International Organi

16、zation for Standardization (ISO) has been taken over as an European Standard by Technical Committee CEN/TC245 “Textiles and textile products”, the secretariat of which is held by BSI. This European Standard shall be given the status of a national standard, either by publication of an identical text

17、or by endorsement, at the latest by October1997, and conflicting national standards shall be withdrawn at the latest by October1997. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austr

18、ia, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. Endorsement notice The text of the International Standard ISO105-B04:1994has been approved by CEN as a European Standard with

19、out any modification. NOTENormative references to International Standards are listed in Annex ZA (normative).EN ISO 105-B04:1997 ii BSI 09-1999 Contents Page Foreword iii 1 Scope 1 2 Normative references 1 3 Principle 1 4 Reference materials and apparatus 1 5 Test specimens 2 6 Procedure 2 7 Assessm

20、ent of colour fastness to weathering 3 8 Test report 4 Annex A (informative) General information on colour fastness to light 5 Annex B (informative) Additional information concerning radiometers 6 Annex ZA (normative) Normative references to international publications with their relevant European pu

21、blications Inside back coverEN ISO 105-B04:1997 BSI 09-1999 iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical co

22、mmittees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with th

23、e International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least75% of the mem

24、ber bodies casting a vote. International Standard ISO105-B04was prepared by Technical Committee ISO/TC38, Textiles, Subcommittee SC 1, Tests for coloured textiles and colorants. This fourth edition cancels and replaces the third edition (ISO 105-B04:1988), of which it constitutes a technical revisio

25、n. ISO105was previously published in thirteen “parts”, each designated by a letter (e.g. “Part A”), with publication dates between1978and 1985. Each part contained a series of “sections”, each designated by the respective part letter and by a two-digit serial number (e.g. “Section A01”). These secti

26、ons are now being republished as separate documents, themselves designated “parts” but retaining their earlier alphanumeric designations. A complete list of these parts is given in ISO 105-A01. Annex A and Annex B of this part of ISO105are for information only.iv blankEN ISO 105-B04:1997 BSI 09-1999

27、 1 1 Scope This part of ISO105specifies a method intended for determining the resistance of the colour of textiles of all kinds, except loose fibres, to the action of weather as determined by exposure to simulated weathering conditions in a cabinet equipped with a xenon arc lamp. This method can be

28、used to determine if a textile is wet light-sensitive. NOTE 1General information on colour fastness to light is given in Annex A. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this part of ISO 105. At the time of pub

29、lication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of ISO105are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of

30、currently valid International Standards. ISO 105-A01:1994, Textiles Tests for colour fastness Part A01: General principles of testing. ISO 105-A02:1993, Textiles Tests for colour fastness Part A02: Grey scale for assessing change in colour. ISO 105-B01:1994, Textiles Tests for colour fastness Part B

31、01: Colour fastness to light: Daylight. ISO 105-B02:1994, Textiles Tests for colour fastness Part B02: Colour fastness to artificial light: Xenon arc fading lamp test. 3 Principle Specimens of the textile are exposed under specified conditions to light from a xenon arc lamp and to water spray. At th

32、e same time, eight dyed blue wool references are exposed to light but are protected from water spray by a sheet of window-glass. The fastness is assessed by comparing the change in colour of the specimen with that of the references. If the method is used to determine if a textile is wet light-sensit

33、ive (see 4.3.1), the simultaneous exposure of references is unnecessary. In this case the assessment is performed by comparison with the grey scale in accordance with ISO 105-A02. 4 Reference materials and apparatus 4.1 Blue wool references The reference materials used in this test are those blue wo

34、ol references specified in ISO 105-A01 and ISO 105-A02, and subclause 4.1.1 of ISO B01:1994. 4.2 Apparatus 4.2.1 Xenon arc lamp apparatus 4.2.1.1 Light source, in a well-ventilated exposure chamber. The light source is a xenon arc lamp of correlated colour temperature5500 K to6500 K. 4.2.1.2 Light f

35、ilter, placed between the light source and the specimens and references so that the ultraviolet spectrum is steadily reduced. The glass used shall have a transmission of0% between290nm and300nm, rising to at least90% between380nm and750nm. 4.2.1.3 Heat filters, placed between the light source and th

36、e specimens and references so that the amount of infrared radiation is steadily reduced. The spectrum of the xenon arc contains an appreciable amount of infrared radiation which should be minimized by the heat filters to satisfy the temperature conditions. The filters shall be cleaned regularly to a

37、void undesirable reduction in light intensity by dirt. 4.2.2 Radiometer (when available/specified), for measuring irradiance and radiant exposure. Since irradiance at the test specimen face can vary as a function of lamp intensity and lamp-to-specimen distance, a monitoring radiometer may be used to

38、 control uniformity of exposure. The radiometer permits exposure to an established level of irradiation (radiant energy flux per unit area) at a point in the plane of the specimen rack (see Annex B). 4.2.3 Opaque cardboard, or other thin opaque material, for example thin sheet aluminium or cardboard

39、 covered with aluminium foil, or, in the case of pile fabrics, a cover that avoids surface compression. 4.2.4 Grey scale for assessing change in colour, in accordance with ISO 105-A02. 4.3 Exposure conditions The test specimens and the blue wool references are exposed simultaneously in the apparatus

40、 (4.2.1), the specimens to both light and water spray, and the references to light only. The air temperature in the chamber shall be measured with a thermometer whose sensitive portion is shielded from the direct radiation of the arc. The temperature in the test chamber shall not exceed40 C during t

41、he drying period. The temperature of the black panel, which is measured in the centre and under the same illumination as the specimens, shall not exceed that of the test chamber by more than20 C at the maximum drying period (black panel temperature, see ISO 105-B02:1994, subclause 4.2.3).EN ISO 105-

42、B04:1997 2 BSI 09-1999 The variation in light intensity over the area covered by specimens and references shall not exceed 10% of the mean. 4.3.1 Exposure of test specimens The specimens shall be subjected to the following accurately adjusted, reproducible weathering cycle: duration of spraying: 1 m

43、in; duration of drying: 29 min. For spraying the specimens, only completely ion-free water shall be used. It should be especially noted that this water shall not contain any metal salts. Tubing, tanks and spray jets shall be of corrosion-resistant material. If the method is used to determine if a te

44、xtile is wet light-sensitive, the weathering cycle shall be repeated for a total of16h testing. The specimens shall be mounted on a suitable holder. The specimens shall completely enclose the holder and the side to be assessed shall not be in contact with metal plates, other specimens, or backing fa

45、bric. NOTE 2The holders described in Textil-Rundschau, 18 (1963) 2, 76, photo 2, left, may be used. The manufacturer of these holders also supplies a case to protect the references. 4.3.2 Exposure of colour fastness references The blue wool references (4.1) shall be protected from the water spray by

46、 a shield of glass whilst being exposed to light from the same xenon arc lamp as the specimens. The transmission of the glass shall be0% between310nm and320nm, rising to at least90% between380nm and750nm. The glass case shall be well ventilated, i.e. there shall be an opening at the top and another

47、at the bottom to allow good circulation of air. 5 Test specimens 5.1 If the textile to be tested is fabric, prepare two specimens, each of a suitable size, mounted on holders or other equipment which will fit the weathering test equipment. 5.2 If the textile to be tested is yarn, knit or weave it in

48、to fabric and treat it as described in 5.1. Loose fibres are not suitable for weathering tests. 5.3 Mount strips of blue wool references on cardboard, (4.2.3), cover one-third of each as described in ISO 105-B02:1994, 7.2.1.2 and fix the mounted references under glass according to 4.3.2. 5.4 Unexpos

49、ed samples of original fabric identical to those being tested are required as references for comparison with the specimens during weathering. 6 Procedure 6.1 Procedure common to methods 1, 2 and 3 6.1.1 Place the specimens mounted on the holders (see 4.3.1) in the apparatus and expose them continuously to weathering following method 1, 2 or3 (see 6.2 to 6.4). 6.1.2 At the same time, expose the mounted and partially covered blue wool references (see 4.1 and5.3) to light in the glass case of the same apparatus (see 4.3.