BS EN ISO 105-S01-1996 Textiles Tests for colour fastness Colour fastness to vulcanization Hot air《纺织品 色牢度试验 第S01部分 耐硫化的色牢度 热空气》.pdf

1、BRITISH STANDARD BS EN ISO 105-S01:1996 Textiles Tests for colour fastness Part S01: Colour fastness to vulcanization: Hot air The European Standard ENISO105-S01:1995 has the status of a BritishStandard ICS 59.080.10BSENISO105-S01:1996 This British Standard, having been prepared under the directiono

2、f the Sector Board forMaterials and Chemicals, waspublished under the authorityof the Standards Boardand comes into effect on 15February1996 BSI 11-1999 The following BSI references relate to the work on this standard: Committee reference TCI/25 Draft announced in BSI News February1995 ISBN 0 580 23

3、979 9 Committees responsible for this British Standard The preparation of this British Standard was entrusted to Technical Committee TCI/25, Chemical properties, upon which the following bodies were represented: Association of Consulting Scientists Association of Suppliers to the British Clothing In

4、dustry British Apparel and Textile Confederation British Clothing Industry Association British Measurement and Testing Association British Retail Consortium Chemical Industries Association Consumer Policy Committee of BSI Fabric Care Research Association Ltd. Home Laundering Consultative Council Int

5、ernational Wool Secretariat Mail Order Traders Association Ministry of Defence National Wool Textile Export Corporation SATRA Footwear Technology Centre Soap and Detergent Industry Association Society of Dyers and Colourists Textile Finishers Association Participation in the detailed technical work

6、was undertaken by the Society of Dyers and Colourists Amendments issued since publication Amd. No. Date CommentsBSENISO105-S01:1996 BSI 11-1999 i Contents Page Committees responsible Inside front cover National foreword ii Foreword 2 1 Scope 3 2 Normative references 3 3 Principle 3 4 Apparatus and m

7、aterials 3 5 Test specimen 3 6 Procedure 3 7 Test report 3 Annex ZA (normative) Normative references to international publications with their relevant European publications 4 List of references Inside back coverBSENISO105-S01:1996 ii BSI 11-1999 National foreword This British Standard has been prepa

8、red by Technical Committee TCI/25 and is the English language version of ENISO105-S01:1995 Textiles Tests for colour fastness Part S01 Colour fastness to vulcanization: Hot air, published by the European Committee for Standardization (CEN). It was derived by CEN from ISO105-S01:1993, published by th

9、e International Organization for Standardization (ISO). This British Standard supersedes the corresponding method in BS1006:1990, which is withdrawn by amendment. A British Standard does not purport to include all the necessary provisions of a contract. Users of British Standards are responsible for

10、 their correct application. Compliance with a British Standard does not of itself confer immunity from legal obligations. Cross-references Publication referred to Corresponding British Standard ISO 105-A01:1989 BS EN ISO 105 Textiles Tests for colour fastness Part A01:1996 General principles of test

11、ing ISO 105-A02:1993 BS EN 20105 Textiles Tests for colour fastness Part A02:1995 Grey scale for assessing change in colour ISO 139:1973 BS EN 20139:1992 Textiles Standard atmospheres for conditioning and testing Summary of pages This document comprises a front cover, an inside front cover, pages i

12、and ii, theEN ISO title page, pages 2 to 4, an inside back cover and a back cover. This standard has been updated (see copyright date) and may have had amendments incorporated. This will be indicated in the amendment table on the inside front cover.EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM E

13、N ISO 105-S01 November 1995 ICS 59.080.10 Descriptors: Textiles, dyes, tests, vulcanizing tests, determination, colour fastness English version Textiles Tests for colour fastness Part S01: Colour fastness to vulcanization: Hot air (ISO 105-S01:1993) Textiles Essais de solidit des teintures Partie S0

14、1: Solidit la vulcanisation: Air chaud (ISO 105-S01:1993) Textilien Farbechtheitsprfungen Teil S01: Farbechtheit gegen Vulkanisieren: Heiluft (ISO 105-S01:1993) This European Standard was approved by CEN on1995-07-28. CEN members are bound to comply with the CEN/CENELEC Internal Regulations which st

15、ipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. This European Standard

16、 exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions. CEN members are the national standard

17、s bodies of Austria, Belgium, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom. CEN European Committee for Standardization Comit Europen de Normalisation Europisches Komitee fr Normung Central

18、 Secretariat: rue de Stassart 36, B-1050 Brussels 1995 All rights of reproduction and communication in any form and by any means reserved in all countries to CEN and its members Ref. No. EN ISO 105-S01:1995 EENISO105-S01:1995 BSI 11-1999 2 Foreword The text of the International Standard from ISO/TC3

19、8, Textiles, of the International Organization for Standardization (ISO) has been taken over as a European Standard by the Technical Committee CEN/TC248, Textiles and textile products. This European Standard shall be given the status of a national standard, either by publication of an identical text

20、 or by endorsement, at the latest by May1996, and conflicting national standards shall be withdrawn at the latest by May1996. According to CEN/CENELEC Internal Regulations, the following countries are bound to implement this European Standard: Austria, Belgium, Denmark, Finland, France, Germany, Gre

21、ece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. NOTENormative references to International Standards are listed inAnnex ZA (normative).ENISO105-S01:1995 BSI 11-1999 3 1 Scope This part of ISO105 specifies a method for determi

22、ning the resistance of the colour of textiles of all kinds and in all forms to the action of a typical rubber compound, such as may be used in the proofing industry, and to its decomposition products, during vulcanization in hot air. 2 Normative references The following standards contain provisions

23、which, through reference in this text, constitute provisions of this part of ISO105. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of ISO105 are encouraged to investigate the possibility of applying

24、the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 105-A01:1989, Textiles Tests for colour fastness Part A01: General principles of testing. ISO 105-A02:1993, Textiles Tests for colour fastness Part A02

25、: Grey scale for assessing change in colour. ISO 139:1973, Textiles Standard atmospheres for conditioning and testing. 3 Principle A specimen of the textile is heated in direct contact with an (initially) unvulcanized rubber compound. The change in colour of the specimen is assessed with the grey sc

26、ale. 4 Apparatus and materials 4.1 Oven, maintained at125 C 2 C, with a fan to ensure uniformity of air temperature. 4.2 Sheet of uncured rubber compound, 2,5mm 1,5mm thick, consisting of the following: 100 parts pale crepe; 5 parts zinc oxide; 1 part stearic acid; 2 parts sulfur; 1 part mercaptoben

27、zothiazole; 0,2 parts zinc diethyldithiocarbamate; 15 parts titanium oxide; 75 parts barium sulfate. If it is necessary to transport the rubber compound, cover it with thin polyethylene film. NOTE 1It should be borne in mind that this test employs a basic rubber compound. Other compounding ingredien

28、ts are frequently used in production and may have specific effects on colour fastness not revealed by this test. 4.3 Grey scale for assessing change in colour, complying with ISO105-A02. 4.4 Petroleum ether 5 Test specimen 5.1 Remove any polyethylene film from the sheet of uncured rubber compound(4.

29、2) and moisten the compound with petroleum ether(4.4). 5.2 If the textile to be tested is fabric, place a specimen measuring40mm 100mm on the sheet of uncured rubber compound. To ensure a uniform degree of adhesion, “roll” the specimen on to the rubber with a metal roller. 5.3 If the textile to be t

30、ested is yarn, knit it into a fabric and use a specimen measuring40mm 100mm, or stick a number of lengths flat and side by side on the rubber sheet to obtain the specified area of40mm 100mm. 5.4 If the textile to be tested is loose fibre, comb and compress enough of it to form a sheet measuring40mm

31、100mm and stick this to the rubber sheet (see5.2). 6 Procedure 6.1 Hang the composite specimen in the oven(4.1) for30min at125 C 2 C. 6.2 Cool the composite specimen for4h in a standard atmosphere for testing complying with ISO139. 6.3 Assess the change in colour of the treated specimen by comparing

32、 it with a piece of the original dyeing laid on a sheet of vulcanized rubber, using the grey scale(4.3). 7 Test report The test report shall include the following particulars: a) the number and date of publication of this part of ISO105, i.e.ISO105-S01:1993; b) all details necessary for the identifi

33、cation of the sample tested; c) the numerical rating for change in colour of the test specimen.ENISO105-S01:1995 4 BSI 11-1999 Annex ZA (normative) Normative references to international publications with their relevant European publications This European Standard incorporates by dated or undated ref

34、erence, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorpo

35、rated in it by amendment or revision. For undated references the latest edition of the publication referred to applies. Publication Year Title EN Year ISO 105-A01 1994 Textiles Tests for colour fastness PartA01: General principles of testing EN ISO 105-A01 1994 ISO 105-A02 1993 Textiles Tests for co

36、lour fastness Part A02: Grey scale for assessing change in colour EN 20105-A02 1994 ISO 139 1973 Textiles Standard atmospheres for conditioning andtesting EN 20139 1992BSENISO105-S01:1996 BSI 11-1999 List of references See national foreword.BS EN ISO 105-S01:1996 BSI 389 Chiswick High Road London W4

37、 4AL BSIBritishStandardsInstitution BSI is the independent national body responsible for preparing BritishStandards. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter. Revisions BritishStandards are updated by amendment or revision. Us

38、ers of BritishStandards should make sure that they possess the latest amendments or editions. It is the constant aim of BSI to improve the quality of our products and services. We would be grateful if anyone finding an inaccuracy or ambiguity while using this BritishStandard would inform the Secreta

39、ry of the technical committee responsible, the identity of which can be found on the inside front cover. Tel:02089969000. Fax:02089967400. BSI offers members an individual updating service called PLUS which ensures that subscribers automatically receive the latest editions of standards. Buying stand

40、ards Orders for all BSI, international and foreign standards publications should be addressed to Customer Services. Tel:02089969001. Fax:02089967001. In response to orders for international standards, it is BSI policy to supply the BSI implementation of those that have been published as BritishStand

41、ards, unless otherwise requested. Information on standards BSI provides a wide range of information on national, European and international standards through its Library and its Technical Help to Exporters Service. Various BSI electronic information services are also available which give details on

42、all its products and services. Contact the Information Centre. Tel:02089967111. Fax:02089967048. Subscribing members of BSI are kept up to date with standards developments and receive substantial discounts on the purchase price of standards. For details of these and other benefits contact Membership

43、 Administration. Tel:02089967002. Fax:02089967001. Copyright Copyright subsists in all BSI publications. BSI also holds the copyright, in the UK, of the publications of the international standardization bodies. Except as permitted under the Copyright, Designs and Patents Act 1988 no extract may be r

44、eproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the free use, in the course of implementing the standard, of necessary details such as symbols, and si

45、ze, type or grade designations. If these details are to be used for any other purpose than implementation then the prior written permission of BSI must be obtained. If permission is granted, the terms may include royalty payments or a licensing agreement. Details and advice can be obtained from the Copyright Manager. Tel:02089967070.