BS ISO 6668-2008 Green coffee - Preparation of samples for use in sensory analysis《生咖啡 感官分析用样品的制备》.pdf

1、BS ISO 6668:2008ICS 67.140.20; 67.240NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBRITISH STANDARDGreen coffee Preparation of samplesfor use in sensoryanalysisThis British Standardwas published under theauthority of the StandardsPolicy and StrategyCommittee on 31 July 2008 B

2、SI 2008ISBN 978 0 580 57347 7Amendments/corrigenda issued since publicationDate CommentsBS ISO 6668:2008National forewordThis British Standard is the UK implementation of ISO 6668:2008. Itsupersedes BS 6379-4:1991 which is withdrawn.The UK participation in its preparation was entrusted to TechnicalC

3、ommittee AW/15, Coffee.A list of organizations represented on this committee can be obtained onrequest to its secretary.This publication does not purport to include all the necessary provisionsof a contract. Users are responsible for its correct application.Compliance with a British Standard cannot

4、confer immunityfrom legal obligations.BS ISO 6668:2008Reference numberISO 6668:2008(E)ISO 2008INTERNATIONAL STANDARD ISO6668Second edition2008-06-01Green coffee Preparation of samples for use in sensory analysis Caf vert Prparation des chantillons en vue de lanalyse sensorielle BS ISO 6668:2008ISO 6

5、668:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading

6、 this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the Genera

7、l Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given b

8、elow. COPYRIGHT PROTECTED DOCUMENT ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the add

9、ress below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2008 All rights reservedBS ISO 6668:2008ISO 6668:2008(E) ISO 200

10、8 All rights reserved iiiForeword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested i

11、n a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commis

12、sion (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical

13、 committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall

14、 not be held responsible for identifying any or all such patent rights. ISO 6668 was prepared by Technical Committee ISO/TC 34, Food products, Subcommittee SC 15, Coffee. This second edition cancels and replaces the first edition (ISO 6668:1991), which has been technically revised. It also incorpora

15、tes the Technical Corrigendum ISO 6668:1991/Cor.1:2000. BS ISO 6668:2008BS ISO 6668:2008INTERNATIONAL STANDARD ISO 6668:2008(E) ISO 2008 All rights reserved 1Green coffee Preparation of samples for use in sensory analysis 1 Scope This International Standard specifies a method for the roasting of gre

16、en coffee, grinding the roasted coffee, and the preparation from the ground coffee of a beverage to be used in sensory analysis. The sensory analysis carried out following this preparation may be used to determine the acceptance or rejection of a shipment of coffee, subject to agreement between the

17、parties concerned. Generally, the sample will require a light roast for assessment of defects, and a medium roast for assessment of flavour and colour. A beverage prepared in accordance with this International Standard can be used not only for purposes of quality control, but also for purposes of co

18、mparative assessment of different samples, in which case an identical procedure can be followed for each of the samples. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated

19、 references, the latest edition of the referenced document (including any amendments) applies. ISO 565, Test sieves Metal wire cloth, perforated metal plate and electroformed sheet Nominal sizes of openings ISO 3696, Water for analytical laboratory use Specification and test methods ISO 4072, Green

20、coffee in bags Sampling 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 beverage solution prepared by the extraction of soluble substances from roast and ground coffee, using freshly boiled water, under the conditions specified in this Intern

21、ational Standard 3.2 roasted ground coffee roast and ground coffee R b) the method used, including reference to this International Standard; c) the roasting temperature and roasting time applied; d) all operating details not specified in this International Standard or regarded as optional, together

22、with details of any incidents which may have influenced the beverage quality with respect to its sensory properties. BS ISO 6668:2008BS ISO 6668:2008ISO 6668:2008(E) ICS 67.140.20; 67.240 Price based on 4 pages ISO 2008 All rights reserved BS ISO 6668:2008This page has been intentionally left blank

23、BS ISO6668:2008BSI GroupHeadquarters 389Chiswick High Road,London, W4 4AL, UKTel +44 (0)20 8996 9001Fax +44 (0)20 8996 - British Standards InstitutionBSI is the independent national body responsible for preparing BritishStandards. It presents the UK view on standards in Europe and at theinternation

24、al level. It is incorporated by Royal Charter.RevisionsBritish Standards are updated by amendment or revision. Users of BritishStandards should make sure that they possess the latest amendments oreditions.It is the constant aim of BSI to improve the quality of our products and services.We would be g

25、rateful if anyone finding an inaccuracy or ambiguity while usingthis British Standard would inform the Secretary of the technical committeeresponsible, the identity of which can be found on the inside front cover. Tel:+44 (0)20 8996 9000. Fax: +44 (0)20 8996 7400.BSI offers members an individual upd

26、ating service called PLUS which ensuresthat subscribers automatically receive the latest editions of standards.Buying standardsOrders for all BSI, international and foreign standards publications should beaddressed to Customer Services. Tel: +44 (0)20 8996 9001. Fax: +44 (0)20 89967001 Email: You m

27、ay also buy directly using a debit/creditcard from the BSI Shop on the Website http:/ response to orders for international standards, it is BSI policy to supply theBSI implementation of those that have been published as British Standards,unless otherwise requested.Information on standardsBSI provide

28、s a wide range of information on national, European andinternational standards through its Library and its Technical Help to ExportersService. Various BSI electronic information services are also available whichgive details on all its products and services. Contact Information Centre. Tel:+44 (0)20

29、8996 7111 Fax: +44 (0)20 8996 7048 Email: Subscribing members of BSI are kept up to date with standards developmentsand receive substantial discounts on the purchase price of standards. For detailsof these and other benefits contact Membership Administration. Tel: +44 (0)208996 7002 Fax: +44 (0)20 8

30、996 7001 Email: Information regarding online access to British Standards via British StandardsOnline can be found at http:/ information about BSI is available on the BSI website at http:/CopyrightCopyright subsists in all BSI publications. BSI also holds the copyright, in theUK, of the publications

31、of the international standardization bodies. Except aspermitted under the Copyright, Designs and Patents Act 1988 no extract maybe reproduced, stored in a retrieval system or transmitted in any form or by anymeans electronic, photocopying, recording or otherwise without prior writtenpermission from

32、BSI.This does not preclude the free use, in the course of implementing the standard,of necessary details such as symbols, and size, type or grade designations. Ifthese details are to be used for any other purpose than implementation then theprior written permission of BSI must be obtained.Details and advice can be obtained from the Copyright and Licensing Manager.Tel: +44 (0)20 8996 7070 Email: