CAN CGSB-43 168-2014 Bulk packaging for computer equipment.pdf

1、CGSB-43.168-2014Bulk packaging for computer equipmentICS 55.040CGSB StandardThe CANADIAN GENERAL STANDARDS BOARD (CGSB), under whose auspices this standard has been developed, is a government agency within Public Works and Government Services Canada. CGSB is engaged in the production of voluntary st

2、andards in a wide range of subject areas through the media of standards committees and the consensus process. The standards committees are composed of representatives of relevant interests including producers, consumers and other users, retailers, governments, educational institutions, technical, pr

3、ofessional and trade societies, and research and testing organizations. Any given standard is developed on the consensus of views expressed by such representatives. CGSB has been accredited by the Standards Council of Canada as a national standards-development organization. The standards that it dev

4、elops and offers as National Standards of Canada conform to the criteria and procedures established for this purpose by the Standards Council of Canada. In addition to standards it publishes as National Standards, CGSB produces standards to meet particular needs, in response to requests from a varie

5、ty of sources in both the public and private sectors. Both CGSB standards and CGSB national standards are developed in conformance with the policies described in the CGSB Policy and Procedures Manual for the Development and Maintenance of Standards. CGSB standards are subject to review and revision

6、to ensure that they keep abreast of technological progress. CGSB will initiate the review of this standard within five years of the date of publication. Suggestions for their improvement, which are always welcome, should be brought to the notice of the standards committees concerned. Changes to stan

7、dards are issued either as separate amendment sheets or in new editions of standards. An up-to-date listing of CGSB standards, including details on latest issues and amendments, and ordering instructions, is found in the CGSB Catalogue at our Web site www.tpsgc -pwgsc.gc.ca/ ongc-cgsb along with mor

8、e information about CGSB products and services. Although the intended primary application of this standard is stated in its Scope, it is important to note that it remains the responsibility of the users of the standard to judge its suitability for their particular purpose. The testing and evaluation

9、 of a product against this standard may require the use of materials and/or equipment that could be hazardous. This document does not purport to address all the safety aspects associated with its use. Anyone using this standard has the responsibility to consult the appropriate authorities and to est

10、ablish appropriate health and safety practices in conjunction with any applicable regulatory requirements prior to its use. CGSB neither assumes nor accepts any responsibility for any injury or damage that may occur during or as the result of tests, wherever performed. Attention is drawn to the poss

11、ibility that some of the elements of this Canadian standard may be the subject of patent rights. CGSB shall not be held responsible for identifying any or all such patent rights. Users of this standard are expressly advised that determination of the validity of any such patent rights is entirely the

12、ir own responsibility. Further information on CGSB and its services and standards may be obtained from: The Manager Standards Division Canadian General Standards Board Gatineau, Canada K1A 1G6 How to order Publications: by telephone 819-956-0425 or 1- 800-665-2472 by fax 819-956-5740 by mail CGSB Sa

13、les Centre Gatineau, Canada K1A 1G6 in person Place du Portage Phase III, 6B1 11 Laurier Street Gatineau, Quebec by email ncr.cgsb-ongctpsgc-pwgsc.gc.ca on the Web www.tpsgc-pwgsc.gc.ca/ongc-cgsb Canadian General Standards Board CGSB-43.168-2014 Bulk packaging for computer equipmentCETTE NORME DE LO

14、NGC EST DISPONIBLE EN VERSIONSFRANAISE ET ANGLAISE.Prepared by theCanadian General Standards Board Published February 2014 by the Canadian General Standards Board Gatineau, Canada K1A 1G6 HER MAJESTY THE QUEEN IN RIGHT OF CANADA, as represented by the Minister of Public Works and Government Services

15、, the Minister responsible for the Canadian General Standards Board (2014). No part of this publication may be reproduced in any form without the prior permission of the publisher.CGSB-43.168-2014CANADIAN GENERAL STANDARDS BOARDCommittee on Bulk packaging for Computer Equipment(Voting membership at

16、date of approval)Chair (non-voting)Gouault, J-P.1Industry CanadaGeneral interest categoryBerry, F. Public Works and Government CanadaIbell, J.R. Public Works and Government CanadaOSullivan, P. Smith InduspacVanderpol, M. Environment CanadaYeh, H. Canadian Information Technology Providers Association

17、 Producer categoryAvila, M. MDG ComputersCoates, C. Phillips (MMD)Maddix, W. Apple ComputerMaddock, P. Panasonic Canada Inc.McAllister, D. LenovoPerkins, R. Northern MicroShrivastava , P. Dell Canada Inc.User categoryFagan, C. Industry CanadaFerris, C. Toronto District School BoardKirk, I. Public Wo

18、rks and Government CanadaSecretary (non-voting)Long, R. Canadian General Standards Board1 General interest CGSB 2014 All rights reservedAcknowledgment is made for the translation of this Canadian General Standards Board standard by the Translation Bureau of Public Works and Government Services Canad

19、a.CGSB-43.168-2014i CGSB 2014 All rights reservedContentsIntroduction ii1 Scope . 12 Normative references . 13 Terms and definitions 24 General requirements 34.1 Packaging 34.1.1 Material 34.1.2 Sustainability 34.1.3 Transport . 34.1.4 Facilities access . 34.1.5 Functionality . 35 Detailed requireme

20、nts 35.1 Packaging 35.1.1 Minimum capacity per bulk packaging container . 35.1.2 Dimensions . 45.1.3 Engineering requirements . 45.1.4 Environmental criteria 55.1.5 Delivery and logistics . 56 Packaging and marking . 67 Inspection 67.1 Sampling . 67.2 Testing . 6Annex A informative Glossary of compu

21、ter equipment types 7Bibliography . 8PageiiCGSB-43.168-2014 CGSB 2014 All rights reservedIntroductionThis standard sets out requirements for the performance aspects of the design of bulk packaging for computer equipment. These performance requirements provide accommodation so that the computer equip

22、ment is protected while ensuring that environmental, risk and cost-based factors are met. Suitable packaging is necessary to protect and transport computer equipment safely to ensure the fragile components are secured. However, the amount of packaging required to protect this equipment is often desi

23、gned for single-use, and the packaging is often not recyclable or reusable. The large amount of computer equipment purchased creates enormous packaging waste. This has resulted in an increased demand by both governments and private industry for environmentally preferable packaging that conforms to p

24、erformance requirements.This standard supports the Canadian national economy by providing clear and precise attributes specifically aimed at bulk packaging for computer equipment. This standard protects consumers by specifying bulk packaging quality expectations. Further, the standard supports green

25、 procurement initiatives and sustainable development by clearly stating how environmental packaging criteria shall be implemented. The fundamental goal of this standard is to ensure that bulk packaging is designed in such a way that the computer equipment is protected for transport and that the pack

26、aging can be easily reused/recycled/returned to reduce the cost to the supplier and recipient while promoting environmental responsibility.Units of measurement used in this standard are given in metric units with yard/pound equivalents shown in brackets, as exemplified by a 130 mm (5.25 in) drive ba

27、y. Computer equipment industry standard measurement nomenclature is expressed in yard/pound units therefore SI units are presented as rounded values of the industry measurement.This standard was prepared by the CGSB Committee on bulk packaging for computer equipment and has been formally approved by

28、 the Committee.CGSB-43.168-20141 CGSB 2014 All rights reservedBulk packaging for computer equipment1 ScopeThis standard specifies the performance requirements related to the bulk packaging used for computer equipment procured by the Canadian federal government.This standard consists of four main sec

29、tions.Section 4 specifies general requirements for packaging including material, sustainability, transport, facilities access and functionality.Section 5 specifies detailed requirements for packaging properties including minimum capacity per bulk packaging container, dimensions, engineering requirem

30、ents, environmental criteria and delivery and logistics.Section 6 pertains to packaging and marking. Section 7 pertains to inspection including sampling and testing.The testing and evaluation of a product against this standard may require the use of materials and equipment that could be hazardous. T

31、his standard does not purport to address all the safety aspects associated with its use. Anyone using this standard has the responsibility to consult the appropriate authorities and to establish appropriate health and safety practices in conjunction with any applicable regulatory requirements prior

32、to its use.2 Normative referencesThe following normative documents contain provisions that, through reference in this text, constitute provisions of this CGSB Standard. The referenced documents may be obtained from the sources noted below.NOTE The addresses provided below were valid at the date of p

33、ublication of this standard.An undated reference is to the latest edition or revision of the reference or document in question, unless otherwise specified by the authority applying this standard. A dated reference is to the specified revision or edition of the reference or document in question. Howe

34、ver, parties to agreements based on this CGSB Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. 2.1 Canadian General Standards Board (CGSB)CAN/CGSB-43.22-2001 Corrugated fibreboard products (withdrawn 2012).2.1.1 S

35、ourceThe above may be obtained from the Canadian General Standards Board, Sales Centre, Gatineau, Canada K1A 1G6. Telephone 819-956-0425 or 1-800-665-2472. Fax 819-956-5740. E-mail ncr.cgsb-ongctpsgc-pwgsc.gc.ca. Web site www.tpsgc-pwgsc.gc.ca/ongc-cgsb.2.2 Institute of Electrical and Electronics En

36、gineers (IEEE)IEEE-1680.1 2009 IEEE standard for environmental assessment of personal computer products, including notebook personal computers, desktop personal computers, and personal computer displays.2CGSB-43.168-2014 CGSB 2014 All rights reserved2.2.1 SourceThe above may be obtained from IHS Glo

37、bal Canada Ltd., 200-1331 MacLeod Trail SE, Calgary, Alberta T2G 0K3, telephone 613-237-4250 or 1-800-267-8220, fax 613-237-4251, Web site .2.3 International Safe Transit Association (ISTA)Procedure 1A: Packaged-products weighing 150 lb (68 Kg) or less. Basic requirements: fixed displacement vibrati

38、on and shock testing.Procedure 3E: Unitized loads of same product. Basic requirements: atmospheric conditioning, compression, random vibration and shock testing.2.3.1 SourceThe above may be obtained from International Safe Transit Association, ISTA, 1400 Abbot Road, Suite 160 East Lansing, Michigan

39、48823-1900 U.S.A., telephone 517-333-3437, fax 517-333-3813, e-mail ISTAISTA.org, Web site www.ista.org/.2.4 International Standards for Phytosanitary Measures (ISPM)ISPM 15 Regulation of wood packaging material in international trade.2.4.1 SourceThe above may be obtained as a pdf from the Internati

40、onal Plant Protection Convention International Standards for Phytosanitary Measures (ISPMs), www.ippc.int/index.php?id=ispms2.5 Technical Association of the Pulp and Paper Industry (TAPPI)T810 om-11 Bursting strength of corrugated boardT811 om-07 Edgewise compressive strength of corrugated fiberboar

41、d (short column test).2.5.1 SourceThe above may be obtained from Technical Association of the Pulp and Paper Industry, TAPPI Inc., P.O. Box 933644, Atlanta, GA 31193-3644, U.S.A., telephone 1-800-446-9431 (Canada), 1-800-332-8686 (U.S.A.), 770-446-1400 (Worldwide), fax 770-209-7206, e-mail membercon

42、nectiontappi.org, Web site www.tappi.org/.3 Terms and definitions For the purposes of this CGSB Standard, the following terms and definitions apply.3.1bulk packaging large quantities of products packaged together in accordance with 5.1. 3.2computer equipmentthese products include, but are not limite

43、d to desktops, notebooks, display devices, small servers and peripheral equipment such as mice, keyboards and printers.CGSB-43.168-20143 CGSB 2014 All rights reserved3.3packaging products made of any materials, which meet the specifications set out by this standard, to be used for the containment, p

44、rotection, handling, delivery and preservation of goods from the producer to the user or consumer. This applies to both materials used for external protection of the bulk package as well as internal packaging used to protect/separate individual items within the bulk package.4 General requirements 4.

45、1 Packaging4.1.1 MaterialThe materials selected for use in bulk packaging for computer equipment shall be readily recyclable using available current material recovery methodologies.4.1.2 SustainabilityMajor components of bulk packaging materials include but are not limited to corrugated fibreboard a

46、nd wood materials. Major components of bulk packaging materials shall be re-usable for shipping purposes.4.1.3 TransportBulk packaging for computer equipment shall be able to be shipped using conventionally accepted logistic processes in accordance with laws and regulations.4.1.4 Facilities accessBu

47、lk packaging shall be able to be readily transported through current facilities infrastructure without hindrance of access to the purchasers computer equipment distribution location.4.1.5 FunctionalityBulk packaging configurations shall be such that economic use of available space for packing comput

48、er components is encouraged while suitably protecting computer equipment from damage. 5 Detailed requirements5.1 Packaging5.1.1 Minimum capacity per bulk packaging containera. For small form factor (SFF) desktops, bulk package shall accommodate a minimum of eight systems.b. For tower form factor (TF

49、F) desktops, bulk package shall accommodate a minimum of four systems.c. For notebooks, bulk package shall accommodate a minimum of eight systems.d. Display devices, bulk package shall accommodate a minimum of ten devices.4CGSB-43.168-2014 CGSB 2014 All rights reserved5.1.2 Dimensions5.1.2.1 PalletizationBulk package shall fit on a standard shipping pallet of 122 x 102 x 15 cm (48 x 40 x 6 in) with no overhang.5.1.3 Engineering requirements5.1.3.1 PackagingBulk packaging shall be engineered to conform to ISTA Procedur