CSA P 3-2015 Testing method for measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heaters (Third Edition).pdf

1、P.3-15Testing method for measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heatersLegal Notice for StandardsCanadian Standards Association (operating as “CSA Group”) develops standards through a consensus standards development process approved by the Sta

2、ndards Council of Canada. This process brings together volunteers representing varied viewpoints and interests to achieve consensus and develop a standard. Although CSA Group administers the process and establishes rules to promote fairness in achieving consensus, it does not independently test, eva

3、luate, or verify the content of standards.Disclaimer and exclusion of liabilityThis document is provided without any representations, warranties, or conditions of any kind, express or implied, including, without limitation, implied warranties or conditions concerning this documents fitness for a par

4、ticular purpose or use, its merchantability, or its non-infringement of any third partys intellectual property rights. CSA Group does not warrant the accuracy, completeness, or currency of any of the information published in this document. CSA Group makes no representations or warranties regarding t

5、his documents compliance with any applicable statute, rule, or regulation.IN NO EVENT SHALL CSA GROUP, ITS VOLUNTEERS, MEMBERS, SUBSIDIARIES, OR AFFILIATED COMPANIES, OR THEIR EMPLOYEES, DIRECTORS, OR OFFICERS, BE LIABLE FOR ANY DIRECT, INDIRECT, OR INCIDENTAL DAMAGES, INJURY, LOSS, COSTS, OR EXPENS

6、ES, HOWSOEVER CAUSED, INCLUDING BUT NOT LIMITED TO SPECIAL OR CONSEQUENTIAL DAMAGES, LOST REVENUE, BUSINESS INTERRUPTION, LOST OR DAMAGED DATA, OR ANY OTHER COMMERCIAL OR ECONOMIC LOSS, WHETHER BASED IN CONTRACT, TORT (INCLUDING NEGLIGENCE), OR ANY OTHER THEORY OF LIABILITY, ARISING OUT OF OR RESULT

7、ING FROM ACCESS TO OR POSSESSION OR USE OF THIS DOCUMENT, EVEN IF CSA GROUP HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, INJURY, LOSS, COSTS, OR EXPENSES.In publishing and making this document available, CSA Group is not undertaking to render professional or other services for or on behalf o

8、f any person or entity or to perform any duty owed by any person or entity to another person or entity. The information in this document is directed to those who have the appropriate degree of experience to use and apply its contents, and CSA Group accepts no responsibility whatsoever arising in any

9、 way from any and all use of or reliance on the information contained in this document.CSA Group is a private not-for-profit company that publishes voluntary standards and related documents. CSA Group has no power, nor does it undertake, to enforce compliance with the contents of the standards or ot

10、her documents it publishes.Intellectual property rights and ownershipAs between CSA Group and the users of this document (whether it be in printed or electronic form), CSA Group is the owner, or the authorized licensee, of all works contained herein that are protected by copyright, all trade-marks (

11、except as otherwise noted to the contrary), and all inventions and trade secrets that may be contained in this document, whether or not such inventions and trade secrets are protected by patents and applications for patents. Without limitation, the unauthorized use, modification, copying, or disclos

12、ure of this document may violate laws that protect CSA Groups and/or others intellectual property and may give rise to a right in CSA Group and/or others to seek legal redress for such use, modification, copying, or disclosure. To the extent permitted by licence or by law, CSA Group reserves all int

13、ellectual property rights in this document.Patent rightsAttention is drawn to the possibility that some of the elements of this standard may be the subject of patent rights. CSA Group shall not be held responsible for identifying any or all such patent rights. Users of this standard are expressly ad

14、vised that determination of the validity of any such patent rights is entirely their own responsibility.Authorized use of this documentThis document is being provided by CSA Group for informational and non-commercial use only. The user of this document is authorized to do only the following:If this

15、document is in electronic form: load this document onto a computer for the sole purpose of reviewing it; search and browse this document; and print this document if it is in PDF format.Limited copies of this document in print or paper form may be distributed only to persons who are authorized by CSA

16、 Group to have such copies, and only if this Legal Notice appears on each such copy.In addition, users may not and may not permit others to alter this document in any way or remove this Legal Notice from the attached standard; sell this document without authorization from CSA Group; or make an elect

17、ronic copy of this document.If you do not agree with any of the terms and conditions contained in this Legal Notice, you may not load or use this document or make any copies of the contents hereof, and if you do make such copies, you are required to destroy them immediately. Use of this document con

18、stitutes your acceptance of the terms and conditions of this Legal Notice.Standards Update ServiceP.3-15December 2015Title: Testing method for measuring energy consumption and determining efficiencies of gas- fired and fuel oil-fired water heatersTo register for e-mail notification about any updates

19、 to this publication go to shop.csa.ca click on CSA Update ServiceThe List ID that you will need to register for updates to this publication is 2424120.If you require assistance, please e-mail techsupportcsagroup.org or call 416-747-2233.Visit CSA Groups policy on privacy at www.csagroup.org/legal t

20、o find out how we protect your personal information.ISBN 978-1-4883-0180-3 2015 CSA Group All rights reserved. No part of this publication may be reproduced in any form whatsoever without the prior permission of the publisher.Published in December 2015 by CSA Group A not-for-profit private sector or

21、ganization 178 Rexdale Boulevard, Toronto, Ontario, Canada M9W 1R3 To purchase standards and related publications, visit our Online Store at shop.csa.caor call toll-free 1-800-463-6727 or 416-747-4044.TMA trade-mar k of the Canadian S tandards Association, operating as “CSA Group”Testing method for

22、measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heatersP.3-15P.3-15Testing method for measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heatersDecember 2015 2015 CSA Group 1ContentsTechnical Committee on En

23、ergy Efficiency and Related Performance of Fuel-Burning Appliances and Equipment 3Subcommittee on Gas-Fired Storage Waters Heaters Efficiency 6Preface 81 Scope 102 Reference publications 113 Definitions and symbols 123.1 Definitions 123.2 Symbols 154 Test conditions 184.1 Installation 184.1.1 Genera

24、l requirements 184.1.2 Water heating mounting 184.1.3 Water inlet and outlet configuration 184.2 Vent requirements 194.3 Water temperatures and pressure 204.3.1 General requirements 204.3.2 Outlet water temperature 204.3.3 Set-point temperature 204.4 Energy supply 204.4.1 Electrical supply 204.4.2 G

25、as supply 204.5 Thermocouple installation 214.5.2 Inlet and outlet water temperature measurements 224.5.3 Ambient temperature measurement 224.5.4 Energy-saving device 224.6 Energy consumption measurement 224.6.1 General requirements 224.6.2 Electrical energy consumption 224.6.3 Gas consumption 224.6

26、.4 Fuel oil consumption 224.7 Environment 234.7.1 General requirements 234.7.2 Relative humidity 234.7.3 Air temperature 234.8 Equipment precision and accuracy 234.8.1 General requirements 234.8.2 Temperature difference 234.8.3 Temperature measurement 235 Test procedures and measurements 24P.3-15Tes

27、ting method for measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heatersDecember 2015 2015 CSA Group 25.1 Operational mode selection 245.2 Determination of storage tank volume 245.3 Power input determination 245.4 Setting the tank thermostat and outlet

28、water temperature 255.4.1 Preparing the water heater 255.5 Mean tank temperature measurement 265.6 Soak-in period for water heaters with rated storage volumes greater than or equal to 7.6 L (2.0 US gal) 265.7 Delivery capacity test 275.7.1 Maximum L/min (gpm) rating test for flow activated water hea

29、ters 275.7.2 First hour rating test for non-flow activated storage water heaters 275.8 Twenty-four hour simulated-use test 285.8.1 Selection of draw pattern 285.8.2 Test sequence for water heaters with rated storage volumes greater than or equal to 7.6 L (2.0 US gal) 285.8.3 Standby loss test measur

30、ed between draw clusters 295.8.4 Standby loss test measured after draw clusters 305.8.5 Completion of 24 h simulated-use test 305.8.6 Test sequence for water heaters with rated storage volume less than 7.6 L (2.0 US gal) 306 Calculation of derived results from test measurements 316.1 Water heater de

31、livery capacity classification 316.2 First-hour rating 316.3 Maximum L/min (GPM) rating 326.4 Recovery efficiency 336.5 Hourly standby heat losses 346.6 Daily water heating energy consumption 356.7 Adjusted daily water heating energy consumption 356.8 Uniform energy factor 376.9 Annual energy consum

32、ption 376.10 Annual electrical energy consumption 386.11 Annual fossil fuel energy consumption 386.12 Computations for water heaters with rated storage volume less than 7.6 L (2 US gal) 386.12.1 Recovery efficiency 386.12.2 Daily water heating energy consumption 396.12.3 Uniform energy factor 406.12

33、.4 Annual energy consumption 416.12.5 Annual electrical energy consumption 416.12.6 Annual fossil fuel energy consumption 417 Sampling plan 42Annex A (informative) Density and specific heat of water 61Annex B (informative) Thermocouple position and capacity determination procedure for storage water

34、heater tanks 88Annex C (informative) Canadian summer/winter maximum water flow rates 91Annex D (informative) Rationale for revising the CSA P.3 Performance Standard 92P.3-15Testing method for measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heatersDecem

35、ber 2015 2015 CSA Group 3Technical Committee on Energy Efficiency and Related Performance of Fuel-Burning Appliances and EquipmentJ. Overall Toronto, Ontario Category: General InterestChairM. Thomas Natural Resources Canada CANMET Energy, Ottawa, Ontario Category: General InterestVice-ChairD.F. Brad

36、ley FortisBC Energy Inc. (FEI), Surrey, British Columbia Category: User InterestR.L. Cane Caneta Research Inc. / Caneta Energy, Mississauga, Ontario Category: General InterestR. Cochrane Natural Resources Canada, Ottawa, Ontario Category: Regulatory AuthorityB.G. Diggens MJS Mechanical Ltd., Calgary

37、, Alberta AssociateJ.P. Gamache Ministre des Ressources naturelles, Qubec, Qubec Category: Regulatory AuthorityT. Gottschalk Hearth Patio andb) an update of the outlet water temperature requirement to better reflect conditions encountered in typical field installations.This Standard is considered su

38、itable for use for conformity assessment within the stated scope of the Standard.CSA Group acknowledges that the development of this Standard was made possible, in part, by the financial support of Natural Resources Canada (NRCan), the Ontario Ministry of Energy (OME), and Efficiency Nova Scotia (EN

39、S).This Standard was prepared by the Subcommittee on Gas-Fired Storage Water Heaters Efficiency, under the jurisdiction of the Technical Committee on Energy Efficiency and Related performance of Fuel- Burning Appliances and Equipment, and will be formally approved by the Technical Committee. It will

40、 be submitted to the Standards Council of Canada for approval as a National Standard of Canada.Notes: 1) Use of the singular does not exclude the plural (and vice versa) when the sense allows.2) Although the intended primary application of this Standard is stated in its Scope, it is important to not

41、e that it remains the responsibility of the users of the Standard to judge its suitability for their particular purpose.3) This Standard was developed by consensus, which is defined by CSA Policy governing standardization Code of good practice for standardization as “substantial agreement. Consensus

42、 implies much more than a simple majority, but not necessarily unanimity”. It is consistent with this definition that a member may be included in the Technical Committee list and yet not be in full agreement with all clauses of this Standard.4) To submit a request for interpretation of this Standard

43、, please send the following information to inquiriescsagroup.org and include “Request for interpretation” in the subject line: a) define the problem, making reference to the specific clause, and, where appropriate, include an illustrative sketch;b) provide an explanation of circumstances surrounding

44、 the actual field condition; andc) where possible, phrase the request in such a way that a specific “yes” or “no” answer will address the issue. Committee interpretations are processed in accordance with the CSA Directives and guidelines P.3-15Testing method for measuring energy consumption and dete

45、rmining efficiencies of gas-fired and fuel oil-fired water heatersDecember 2015 2015 CSA Group 9governing standardization and are available on the Current Standards Activities page at standardsactivities.csa.ca.5) This Standard is subject to review five years from the date of publication and suggest

46、ions for its improvement will be referred to the appropriate committee. To submit a proposal for change, please send the following information to inquiriescsagroup.org and include “Proposal for change” in the subject line: a) Standard designation (number);b) relevant clause, table, and/or figure num

47、ber;c) wording of the proposed change; andd) rationale for the change.P.3-15Testing method for measuring energy consumption and determining efficiencies of gas-fired and fuel oil-fired water heatersDecember 2015 2015 CSA Group 10P.3-15Testing method for measuring energy consumption and determining e

48、fficiencies of gas-fired and fuel oil-fired water heaters1 Scope1.1 This Standard describes the test procedures required to perform a 24 h simulated-use test. This Standard also provides the calculations required to determine the first-hour rating, maximum flow rate, recovery efficiency, standby los

49、s, daily water heating energy consumption, uniform energy factor, and annual energy consumption for gas-fired and fuel oil-fired water heaters.1.2 This Standard applies to:a) Gas-fired storage water heaters i) with rated storage capacity up to and including 454 L (120 US gal);ii) having rated inputs up to and including 30.77 kW (105 000 Btu/h); andiii) designed to provide outlet hot water at a controlled temperature up to and including 82 C (180F);b) Fuel oil-fired storage water heaters i) with rated storage capacity up to and including 454 L (120 US