DLA A A 55563 8B A VALID NOTICE 1-2011 HOLDER ELECTRICAL CARD METAL CARD GUIDE OPEN ENDED WITHOUT FLARED ENTRY WITH 3 MOUNTING HOLES.pdf

1、INCH-POUND AA55563/8B 8 December 2011 Superseding AA55563/8A 31 January 2002 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET HOLDER, ELECTRICAL CARD, METAL CARD GUIDE, OPEN ENDED, WITHOUT FLARED ENTRY, WITH 3 MOUNTING HOLES The General Services Administration has authorized the use of this commercia

2、l item description (CID) for all federal agencies. The complete requirements for procuring electrical card holders described herein shall consist of this document and the latest issue in effect of AA55563. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This commercial item description (CID) spe

3、cification sheet uses a classification system which is included in the Part Identification Number (PIN) as shown in the following example (see notes). AA55563 CID number /08 Applicable CID specification sheet Material # Card holder width/ board thickness (see table I) $ Overall length (see table II)

4、 AA55563/08#$ AA55563/08#$ base material is beryllium copper 1/4 hard; card holder width/board thickness, dimension “D“, is .33 inch (8.38 mm), dimension “T“ is .0937 inch (2.29 mm), commonly known as having a board thickness of “3/32”, the overall length is 2.0 inches (50.80 mm), dimension “L“; and

5、 the finish is black ebonal. 2/ The manufacturers P/N shall not be used for procurement to the requirements of this CID specification sheet. At the time of preparation of this CID, the aforementioned commercial products were reviewed and could be replaced by the CID PINs shown. For actual part marki

6、ng requirements, see the marking paragraph of AA55563. 3/ Finish materials designator “C“, “D“, “E“, “F“, “H“, “J“, “K“, or “R“ are available for this material type (see finish for a description of the designators). 4/ MFG CAGE 18915 the series type is “35C1“, (with center mounting hole and flare) t

7、he letters “B“, “BH“, or “CR“ denotes material type, the letter “T“ denotes card holder width/board thickness, the numbers “4“ through “15“ denotes card holder lengths, and the letter “F“ denotes finish material. 5/ MFG CAGE 65884 catalog PINs are the same as this CID sheet. The character “#“ denote

8、s the card holder width/board thickness and needs to be replaced with the appropriate PIN designator from table I. The character “&“ finish material and shall be replaced with the appropriate PIN designator (see finish). See 1/ above. Provided by IHSNot for ResaleNo reproduction or networking permit

9、ted without license from IHS-,-,-AA55563/8B 7 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: Custodians: GSA FAS Navy EC Air Force 99 Preparing Activity DLA CC DLA CC Project 59982011018 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-