DLA A-A-55563 18 A-2012 HOLDER ELECTRICAL CARD METAL CARD GUIDE LOW PROFILE OPEN ENDED WITHOUT FLARED ENTRY WITH 3 MOUNTING HOLES.pdf

1、INCHPOUND AA55563/18A 22 October 2012 Superseding AA55563/18 11 December 2002 COMMERCIAL ITEM DESCRIPTION SPECIFICATION SHEET HOLDER, ELECTRICAL CARD, METAL CARD GUIDE, LOW PROFILE, OPEN ENDED, WITHOUT FLARED ENTRY, WITH 3 MOUNTING HOLES, The General Services Administration has authorized the use of

2、 this commercial item description (CID) for all federal agencies. The complete requirements for procuring electrical card holders described herein shall consist of this document and the latest issue in effect of AA55563. CLASSIFICATION/PART IDENTIFICATION NUMBER (PIN). This commercial item descripti

3、on (CID) specification sheet uses a classification system which is included in the Part Identification Number (PIN) as shown in the following example (see notes). AA55563 CID number /18 Applicable CID sheet Material # Card holder width/board thickness $ $ Length AA55563/18#$ AA55563/18#$& 1/ Manufac

4、turers 2/ Material type () Card holder width/board thickness Overall length ($) Finish (&) CAGE 18915 4/ D # 20 G 35C2CRT4 D # 25 G 35C2CRT5 D # 30 G 35C2CRT6 D # 35 G 35C2CRT7 D # 40 G 35C2CRT8 D # 45 G 35C2CRT9 D # 50 G 35C2CRT10 D # 55 G 35C2CRT11 D # 60 G 35C2CRT12 1/ The at sign () denotes mate

5、rial type, pound sign (#) denotes card holder width/board thickness, dimension “T“ (see figure 1 herein), dollar signs ($) denotes overall length dimension “L“ (see figure 1 herein and AA55563) and the ampersand (&) denotes finish. 2/ The manufacturers P/N shall not be used for procurement to the re

6、quirements of this CID specification sheet. At the time of preparation of this CID, the aforementioned commercial products were reviewed and could be replaced by the CID PINs shown. For actual part marking requirements, see the marking paragraph of AA55563. 3/ Manufacturer CAGE 18915 superseded part

7、 number is constructed as follows: The series type is “35C2“ (with center hole), the letters “B“, “BH“, and “CR“ denotes material type, the letter “T“ denotes card holder width/board thickness, the numbers “4“ through “12“ denotes card holder lengths, and the letter “F“ denotes finish material. Chan

8、ges from previous issue. Asterisks are not used in this revision to identify changes with respect to the previous revision, due to the extensiveness of the changes. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: Custodians: GSA FAS Army CR Navy EC Preparing Activity Air Force 85 DLA CC DLA

9、CC Project 59982012036 Review activity: Air Force 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-