DLA A-A-59352 A-2011 BATTERY DRY BA-223 U.pdf

1、Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data that may improve this document should be sent to: DLA Land and Maritime, Columbus, ATTN: VAT, P.O. Box 3990, Columbus, OH 43218-3990, or email mailto:CircuitProtectdscc.dla.mil. Since contact information c

2、an change you may want to verify the currency of the address information using the ASSIST Online database at https:/assist.daps.dla.mil. AMSC N/A FSC 6135 INCH-POUND A-A-59352A 15 October 2011 SUPERSEDING A-A-59352 12 October 2000 COMMERCIAL ITEM DESCRIPTION BATTERY, DRY, BA-223/U The General Servic

3、es Administration has authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers the general requirements for a +22.5/45 V dc dry-cell battery. The battery is intended for use in portable electronic and communication equip

4、ment, flashlights, test equipment, and radio sets powered by non-rechargeable dry cell batteries. 2. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This CID uses a classification system that is included in the PIN. The PIN shall be AA59352 (see 7.1). 3. SALIENT CHARACTERISTICS. 3.1 Interface an

5、d physical dimensions. Batteries supplied to this CID shall be as specified herein and shall meet the requirements of NEMA C18.1M Part 1 (see figure 1). 3.2 Voltage rating. The battery shall provide two nominal voltages: +22.5 V dc and +45 V dc. 3.3 Weight. The battery weight shall not exceed 3 poun

6、ds, 4 ounces. 3.4 Cell type. Cells shall meet the requirements of ANSI Number 1191SO of NEMA C18.1M, Part 1. 3.5 Dimensions. The batter shall meet the dimensional requirements shown in figure 1. 3.6 Marking. Batteries supplied to this CID shall be marked with the manufacturers (MFRs) standard commer

7、cial PIN. (NOTE: The part number marked on the unit pack shall be the CID PIN.) 3.7 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the

8、 operational and maintenance requirements, and promotes economically advantageous life cycle costs. 3.8 Workmanship. Batteries shall be processed in such a manner as to be uniform in quality and shall be free from other defects that will affect life, serviceability, or appearance.Provided by IHSNot

9、for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59352A 2 FIGURE 1. Configuration and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59352A 3 NOTES: 1. Dimensions are in inches. 2. Unless otherwise s

10、pecified, tolerance is .063 inch (1.59 mm). FIGURE 1. Configuration and dimensions. Ltr Inches mm Min Max Min Max A .438 - 11.11 - B 5.250 5.375 133.35 136.54 C 1.968 2.094 50.00 53.19 D 4.000 4.126 101.60 104.80 E 1.218 1.344 30.94 34.14 F 2.500 2.626 63.50 66.69 G 1.000 1.126 25.39 28.59 H .473 .5

11、98 12.01 15.19 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59352A 4 4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with 23.403 of the Federal Acquis

12、ition Regulation (FAR). 5. PRODUCT CONFORMANCE PROVISIONS. 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in

13、 the commercial market. The Government reserves the right to require proof of such conformance. 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. 7. NOTES. 7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this CID. S

14、ee section 2 for PIN. 7.2 Environmentally preferable material. Environmentally preferable materials should be used to the maximum extent possible to meet the requirements of this specification. As of the dating of this document, the U.S. Environmentally Protection Agency (EPA) is focusing efforts on

15、 reducing 31 priority chemicals. The list of chemicals and additional information is available on their website http:/www.epa.gov/osw/hazard/wastemin/priority.htm. Included in the EPA list of 31 priority chemicals are cadmium, lead, and mercury. Use of these materials on the list should be minimized

16、 or eliminated unless needed to meet the requirements specified herein (see Section 3). 7.3 Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these circuit breakers to DLA Land and Maritime under the Military Parts Control Advisory Group (MPCAG

17、) evaluation program, CAGE code 58536 should be used. 7.4 Source of documents. FEDERAL REGULATIONS FAR - Federal Acquisition Regulations (FAR). (Copies of this document are available online at http:/www.acquisition.gov/comp/far/index.html from the U.S. Government Printing Office, 732 North Capital S

18、treet, NW, Washington D.C. 20401-0001). Other Publications NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA) NEMA C18.1M PART 1 - Portable Primary Cells and Batteries with Aqueous Electrolyte. (Copies of this document are available online at http:/www.nema.org/ or from the National Electrical Man

19、ufacturers Association, 1300 North 17thStreet, Rosslyn, Virginia 22209-3811). (Industry association specifications and standards are generally available for reference from libraries. They are also distributed among technical groups and using Federal agencies.) 7.5 Ordering data. The contract or orde

20、r should specify the following: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Packaging requirements. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59352A 5 7.6 Commercial products. As part of the market a

21、nalysis and research effort, this CID was coordinated with the following manufacturers of commercial products. At the time of CID preparation and coordination, these manufacturers were known to have commercial products that would meet the requirements of this CID. (NOTE: This information should not

22、be considered as a list of approved manufacturers or be used to restrict acquisition to only the manufacturers shown.) MFRs CAGE MFRs name and address 51828 Bren-Tronics Incorporated 10 Brayton Court Commack, NY 11725-3197 Phone number: (631) 499-5155 Facsimile number (631) 499-5504 E-mail: mailto:

23、Uniform Resource Locator (URL): 7.7 Part number (P/N) supersession data. These CID PINs supersede the following MFRs P/Ns as shown. This information is being provided to assist in reducing proliferation in the Government inventory system. TABLE II. P/N supersession data. CID PIN MFRs P/N 1/ CAGE 51

24、828 AA59263 BT-70159 1/ The manufacturers P/N shall not be used for acquisition to the requirements of this CID. At the time of preparation of this CID, the aforementioned commercial products were reviewed and could be replaced by the CID PIN shown. For actual part marking requirements see 3.6. 7.8

25、Government users. To acquire information on obtaining these batteries from the Government inventory system, contact Defense Supply Center, Columbus, ATTN: FLC, Post Office Box 3990, Columbus, OH 43218-3990, or telephone (614) 692-3342. 7.8.1 National Stock Number (NSN). This CID is associated with N

26、SN 6135-00-100-0464. Other NSNs may also correspond with this document. For up to date information on assigned NSNs, please contact the aforementioned DLA Land and Maritime office (See 7.8). 7.9 Changes from previous issue. Marginal notations are not used in this revision to identify changes with re

27、spect to the previous issue due to the extensiveness of the changes. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59352A 6 MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FAS Custodians: Army - CR Preparing activity: Navy - SH DL

28、A - CC DLA - CC Review Activities: Project 6135-2011-005 Army - AR Navy - MC, YD NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-