DLA A-A-59769 A-2013 RESISTOR NETWORKS BALL GRID ARRAY TERMINATORS GENERAL REQUIREMENTS FOR.pdf

1、Beneficial comments, recommendations, additions, deletions, clarification, etc. and any data that may improve this document should be sent to: DLA Land and Maritime, ATTN: VAT, Post Office Box 3990, Columbus, Ohio 43218-3990 or by email Resistordla.mil. Since contact information can change, you may

2、want to verify the currency of this address information using the ASSIST Online database at https:/assist.dla.mil/. AMSC N/A FSC 5905 INCH-POUND A-A-59769A 22 January 2013 SUPERSEDING A-A-59769 15 April 2005 COMMERCIAL ITEM DESCRIPTION RESISTOR NETWORKS, BALL GRID ARRAY TERMINATORS GENERAL REQUIREME

3、NTS FOR The General Services Administration has authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers the general requirements for a resistor network, ball grid array terminator. These resistors networks provide serie

4、s and parallel termination between the source and the receiver. Requirements for specific resistor networks are covered in the individual CID specification sheets. The resistor networks covered by this CID are intended for commercial/industrial applications. 2. CLASSIFICATION/PART OR IDENTIFICATION

5、NUMBER (PIN). This CID uses a classification system which is included in the PIN as shown in the following example (see 7.1). AA59769 01 -001 CID number Applicable CID specification sheet (two digits) Dash number (see applicable CID specification sheet) 3. SALIENT CHARACTERISTICS 3.1 Interface and p

6、hysical dimensions. The resistors supplied to this CID shall be as specified on the applicable CID specification sheet. 3.1.1 CID specification sheet. The family of resistor networks shall be in accordance with the requirements specified herein and the applicable CID specification sheet. In the even

7、t of a conflict between the general CID and the applicable CID specification sheet, that latter will govern. 3.2 Operating ambient temperature. The operating ambient temperature shall be as specified on the applicable CID sheet. 3.3 Marking. Resistors supplied to this CID shall be marked with the ma

8、nufacturers (MFRs) standard commercial PIN. The PIN marked on the unit pack shall be the CID PIN. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59769A 2 3.4 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or e

9、nvironmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and promotes economically advantageous life cycle costs. 3.5 Workmanship. Resistor shall be processed in such a manner as to be

10、uniform in quality and shall be free from other defects that will affect life, serviceability, or appearance. 4. REGULATORY REQUIREMENTS The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition R

11、egulation (FAR). 5. PRODUCT CONFORMANCE PROVISIONS 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the com

12、mercial market. The Government reserves the right to require proof of such conformance. 6. PACKAGING Preservation, packing, and marking shall be as specified in the contract or order. 7. NOTES 7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this CID. See section

13、 2 for PIN format example. 7.2 Environmentally preferable material. Environmentally preferable materials should be used to the maximum extent possible to meet the requirements of this specification. As of the dating of this document, the U.S. Environmental Protection Agency (EPA) is focusing efforts

14、 on reducing 31 priority chemicals. The list of chemicals and additional information is available on their website http:/www.epa.gov/osw/hazard/wastemin/priority.htm. Use of these materials should be minimized or eliminated unless needed to meet the requirements specified herein (see Section 3). 7.3

15、 Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these resistors to DLA Land and Maritime under the Military Parts Control Advisory Group (MPCAG) evaluation program, CAGE code 58536 should be used. 7.4 Source of documents. FEDERAL REGULATIONS

16、 FAR 23.403 - Federal Acquisition Regulations (FAR) - Use of Recovered Materials. (Copies of these documents are available online at https:/assist.dla.mil/quicksearch/ or from the DLA Document Services Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.) Provided by IHSNot for

17、ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-59769A 3 7.5 Ordering data. The contract or order should specify the following: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Packaging requirements. d. Lead types. 7.6 Government us

18、ers. To acquire information on obtaining these resistors from the Government inventory system, contact DLA Land and Maritime, ATTN: DLA Land and Maritime-FMX, Post Office Box 3990, Columbus, OH 43216-5000, or telephone (614) 692-3677. 7.7 Changes from previous issue. The margins of this CID are mark

19、ed with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document base

20、d on the entire content irrespective of the marginal notations and relationship to the last previous issue. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: Custodians: GSA - FAS Navy - EC DLA -CC Preparing Activity: DLA - CC Project 5905-2010-026 NOTE: The activities listed above were intere

21、sted in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-