DLA MIL-DTL-28875 10 B-2010 AMPLIFIERS RADIO-FREQUENCY AND MICROWAVE SOLID-STATE WIDEBAND TO CONFIGURATION.pdf

1、AMSC N/A FSC 5996 MIL-DTL-28875/10B 15 June 2010 SUPERSEDING MIL-DTL-28875/10A 24 August 2000 DETAIL SPECIFICATION SHEET AMPLIFIERS, RADIO-FREQUENCY AND MICROWAVE, SOLID-STATE, WIDEBAND, TO CONFIGURATION This specification is approved for use by all Departments and Agencies of the Department of Defe

2、nse. The requirements for acquiring the amplifiers described herein shall consist of this specification sheet and MIL-DTL-28875. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only (1.00 inch = 25.4 mm). FIGURE 1. Dimensions and configuration. INCH-POUND

3、Inches Millimeters Max Min Max Min B N/A .17 N/A 4.32 C .455 .445 11.56 11.30D .510 .490 12.95 12.45 E .019 .016 .48 .41 F .160 .140 4.06 3.56 G .310 .290 7.87 7.37 H .160 .140 4.06 3.56 J .310 .290 7.87 7.37 K .05 N/A 1.3 N/A Provided by IHSNot for ResaleNo reproduction or networking permitted with

4、out license from IHS-,-,-TABLE I. Electrical characteristics (25C unless otherwise specified). Dash No. Frequency range DC input power Gain (dB) Gain flatness (dB) RF output power (dBm) VSWR Max Noise figure (dB) Intercept point 3rdorder (dBm) Har-monic output (dBc) Gain versus temp. (dB) RF input p

5、ower (mW) Iso- lation (dB) Phase linearity (deg) (MHz) Voltage Curr. Max (mA) Min Max Min IN OUT Max Min Max Min Max S1 01 S2 N 2-250 15 Nom 55 29 1.0 +7 2.0:1 2.0:1 5.5 +17 N/A 1.0 +60 N/A N/A S1 02 S2 N 2-250 15 Nom 98 13 1.0 +20.0 2.0:1 2.0:1 7 +30 N/A 1.0 +13 N/A N/A S1 03 S2 N 5-250 +15 1% 40 2

6、9 1.0 +7.0 2.0:1 2.0:1 5.5 +21 N/A 1.0 +17 N/A N/A S1 04 S2 N 5-1000 +15 1% 29 13 1.0 +6.0 2.0:1 2.0:1 7 +21 N/A 1.0 +17 N/A N/A S1 05 S2 N 100-1000 +15 1% 34 14 1.0 +5.0 2.0:1 2.0:1 7 +18 N/A 1.0 +17 N/A N/A MIL-DTL-28875/10B2 Provided by IHSNot for ResaleNo reproduction or networking permitted wit

7、hout license from IHS-,-,-MIL-DTL 28875/10B 3 TABLE II. Dimension, physical and environmental characteristics. Dash number Dimension A in inches (mm) Max Mass Max (Grams) Temperature range Burn-in temperature (case temp) Seal Salt Operating case temp Nonoperating S1 01 S2 N .22 (5.6) 3.1 -54/+100C -

8、62/+125C +100C Hermetic N/A S1 02 S2 N .22 (5.6) 3.1 -54/+100C -62/+125C +100C Hermetic N/A S1 03 S2 N .22 (5.6) 3.1 -54/+100C -62/+125C +100C Hermetic Applicable S1 04 S2 N .18 (4.6) 3.1 -54/+100C -62/+125C +125C Hermetic N/A S1 05 S2 N .22 (5.6) 3.1 -54/+100C -62/+125C +125C Hermetic N/A REQUIREME

9、NTS: Dimensions and configuration: See figure 1 and table II. Electrical characteristics: See table I. Physical and environmental characteristics: See table II. Part number. M28875/10-(dash number from tables I and II). Provided by IHSNot for ResaleNo reproduction or networking permitted without lic

10、ense from IHS-,-,-MIL-DTL 28875/10B 4 Referenced documents. This specification sheet only references MIL-DTL-28875. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government ass

11、umes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodian: Preparing activity: Arm

12、y - CR DLA - CC Navy - EC Air Force - 85 (Project 5996-2010-004) DLA - CC Review activities: Army - AV, MI Navy - AS, MC, OS, SH Air Force - 19, 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil/. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-