DLA MIL-DTL-3933 17 D-2011 ATTENUATORS FIXED SPACE LEVEL NON SPACE LEVEL COAXIAL LINE (TNC CONNECTORS) FREQUENCY RANGE DC TO 18 GHz CLASS IV LOW POWER.pdf

1、AMSC N/A FSC 5985 MIL-DTL-3933/17D 7 April 2011 SUPERSEDING MIL-DTL-3933/17C 20 January 2009 DETAIL SPECIFICATION SHEET ATTENUATORS, FIXED, SPACE LEVEL, NON SPACE LEVEL, COAXIAL LINE (TNC CONNECTORS), FREQUENCY RANGE: DC TO 18 GHz, CLASS IV, LOW POWER This specification is approved for use by all De

2、partments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-3933. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Metric equivalents are in

3、parentheses. FIGURE 1. Dimensions and configuration. INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3933/17D 2 ENGINEERING DATA: Operating frequency range: DC to 4.5 GHz for PINs M3933/17-01 through -06; DC to 18 GHz for PINs M393

4、3/17- 07 through -24. Test frequency ranges for SWR and attenuation measurements, measured or recorded, when using an Automatic Network Analyzer (ANA) or equivalent: 100 MHz (or lower) to 4.5 GHz for PINs M3933/17-01 through -06; 100 MHz (or lower) to 18 GHz for PINs M3933/17-07 through -24. Basic t

5、est frequencies for sensitive measurements like connector repeatability, temperature sensitivity, power sensitivity and any other measurements where a delta spec is imposed: 2.0 GHz for PINs M3933/17-01 through -06; 8.0 GHz for PINs M3933/17-07 through -24. Operating temperature range: -55C to 125C.

6、 Maximum weight: See table I. REQUIREMENTS: Dimensions and configuration: See figure 1. Nominal impedance: 50 ohms. Attenuation: See table I. Stability and sensitivity: Maximum change in attenuation after: Up to 10 dB, inclusive (dB) Over 10 dB (dB/dB) Temperature change or thermal shock 0.5 0.05 Vi

7、bration or shock 0.5 0.05 Moisture resistance or salt spray 0.5 0.05 Peak power 0.5 0.05 Frequency sensitivity, maximum: 0.4 dB/dB/GHz. Temperature sensitivity of attenuation, maximum: 0.0006 dB/dB/C. Power: See table I. Power sensitivity for full input power, maximum: 0.005 dB/dB/Watt. VSWR: See ta

8、ble I. Connector repeatability, maximum variation in attenuation: 0.04 dB. Part or Identifying Number (PIN): M3933/17- (and dash number from table I with three device level designators are space level (T), screened (S) and non-screened (N) options). Provided by IHSNot for ResaleNo reproduction or ne

9、tworking permitted without license from IHS-,-,-AMSC N/A FSC 5985 TABLE I. Electrical characteristics. Dash number Attenuation dB Maximum power input at 25C VSWR maximum 1/ Weight (oz) Max Dimension A (inches) maximum Nominal Deviation DC to 4.5 GHz DC to 4.0 GHz 4.0 to 8.0 GHz 8.0 to 12.4 GHz 12.4

10、to 18.0 GHz DC to 4.5 GHz DC to 18 GHz AV (W) 3/ (continuously) Peak 2/ (kW) 01 N S T 1 0.3 - 4 0.2 1.25:1 - - - - 3.0 - 02 N S T 2 0.4 - 4 0.2 1.25:1 - - - - 3.0 - 03 N S T 3 0.4 - 4 0.2 1.25:1 - - - - 3.0 - 04 N S T 4 0.4 - 4 0.2 1.25:1 - - - - 3.0 - 05 N S T 5 0.4 - 4 0.2 1.25:1 - - - - 3.0 - 06

11、N S T 6 0.4 - 4 0.2 1.25:1 - - - - 3.0 - 07 N S T 20 - 0.6 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 08 N S T 30 - 0.9 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 09 N S T 1 - 0.4 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 10 N S T 2 - 0.4 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 11 N S T 3 - 0.4 2 0.

12、2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 12 N S T 4 - 0.4 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - See footnotes at end of table. MIL-DTL-3933/17D3Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-TABLE I. Electrical characteristics - Continued. Dash num

13、ber Attenuation dB Maximum power input at 25C VSWR maximum 1/ Weight (oz) Max Dimension A (inches) maximum Nominal Deviation DC to 4.5 GHz DC to 4.0 GHz 4.0 to 8.0 GHz 8.0 to 12.4 GHz 12.4 to 18.0 GHz DC to 4.5 GHz DC to 18 GHz AV (W) 3/ (continuously) Peak 2/ (kW) 13 N S T 5 - 0.4 2 0.2 - 1.15:1 1.

14、20:1 1.25:1 1.35:1 3.0 - 14 N S T 6 - 0.4 2 0.2 - 1.15:1 1.20:1 1.15:1 1.35:1 3.0 - 15 N S T 7 - 0.5 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 16 N S T 8 - 0.5 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 17 N S T 10 - 0.5 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 18 N S T 12 - 0.5 2 0.2 - 1.15:1 1.20:

15、1 1.25:1 1.35:1 3.0 - 19 N S T 15 - 0.5 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 20 N S T 25 - 0.8 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 21 N S T 35 - 0.9 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 22 N S T 40 - 1.0 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 23 N S T 50 - 1.4 2 0.2 - 1.15:1 1.20:

16、1 1.25:1 1.35:1 3.0 - 24 N S T 60 - 1.5 2 0.2 - 1.15:1 1.20:1 1.25:1 1.35:1 3.0 - 1/ VSWR value is for both ends. 2/ Peak power for a duty cycle of 5 x 10-4, maximum pulse duration of 5 microseconds. 3/ Power input is derated linearly to 0.5 watts at +125C. MIL-DTL-3933/17D4Provided by IHSNot for Re

17、saleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-3933/17D 5 Referenced documents. In addition to MIL-DTL-3933, this specification sheet references MIL-PRF-39012/26 MIL-PRF-39012/27 Marginal notations are not used in this revision to identify changes with respect to th

18、e previous issue due to the extent of the changes. Custodians: Preparing activity: Army - CR DLA - CC Navy EC Air Force - 85 (Project 5985-2010-015) DLA - CC Review activities: Army - MI Navy - AS, MC, SH Air Force - 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-