DLA MIL-DTL-642 11 C-2013 PLUGS TELEPHONE (TYPE PJ-636).pdf

1、 MIL-DTL-642/11C 08 August 2013 SUPERSEDING MIL-DTL-642/11B 9 June 2003 DETAIL SPECIFICATION SHEET PLUGS, TELEPHONE (TYPE PJ-636) This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall con

2、sist of this specification sheet and MIL-P-642. FIGURE 1. Dimensions and configurations. AMSC N/A FSC 5935 INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-642/11C 2 FIGURE 1. Dimensions and configurations - Continued. Provided by I

3、HSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-642/11C 3 Inch/mm conversion chart Inches mm Inches mm Inches mm .002 .05 .165 4.19 .885 22.48 .003 .08 .187 4.75 .980 24.89 .005 .13 .244 6.20 1.000 25.40 .008 .20 .250 6.35 1.109 28.17 .015 .38 .500 12.70

4、1.187 30.15 .046 1.17 .625 15.88 1.468 37.29 .062 1.57 .687 17.45 3.062 77.77 .145 3.68 .843 21.41 NOTES: 1. Dimensions are in inches. 2. Metric equivalents (to nearest .01 mm) are given for general information only. 3. Unless otherwise specified, tolerance is .010 (0.25 mm). 4. After assembly, the

5、eccentricity between the end of the shank and the tip of the plug shall not exceed .008 (.20 mm) TIR (total indicator reading). 5. Thread shall be in accordance with FED-STD-H28. 6. Screw MS35214-22 in accordance with NASM35214. FIGURE 1. Dimensions and configurations - Continued. Provided by IHSNot

6、 for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-642/11C 4 REQUIREMENTS Dimensions and configurations: See figure 1. Shell: Shall be metal. Part or Identifying Number (PIN): M642/11-1. Changes from previous issue. The margins of this specification are marked wi

7、th vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on

8、the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. In addition to MIL-P-642, this document references the following: FED-STD-H28 NASM35214 CONCLUDING MATERIAL Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Fo

9、rce 85 (Project 5935-2013-168) DLA - CC Review activities: Army - AR, CR4, MI Navy - AS, MC, OS, SH NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-