DLA MIL-PRF-20 28 D-2011 CAPACITORS FIXED CERAMIC DIELECTRIC (TEMPERATURE COMPENSATING) ESTABLISHED AND NON-ESTABLISHED RELIABILITY STYLES CCR76 AND CC76.pdf

1、AMSC N/A FSC 5910 MIL-PRF-20/28D 21 April 2011 SUPERSEDING MIL-PRF-20/28C 21 June 2001 PERFORMANCE SPECIFICATION SHEET CAPACITORS, FIXED, CERAMIC DIELECTRIC (TEMPERATURE COMPENSATING), ESTABLISHED AND NON-ESTABLISHED RELIABILITY, STYLES CCR76 AND CC76 This specification is approved for use by all De

2、partments and Agencies of the Department of Defense. The requirements for acquiring the capacitors described herein shall consist of this specification sheet and MIL-PRF-20. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Lead diameter shall be .0

3、15 (0.38 mm) to .027 (0.69 mm). 4. Lead length may be a minimum of 1.00 inch (25.4 mm) long for use in tape and reel packaging, when specified in the ordering data. FIGURE 1. Styles CCR76 and CC76 capacitors. INCH-POUND CC76 is inactive for new design after 21 April 2011. Use CCR76. Inches mm .010 0

4、.25 .090 2.29 .250 6.35 1.250 31.75 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-20/28D 2 REQUIREMENTS: Dimensions and configuration: See figure 1. Lead type: Axial. Case type: Tubular, molded. DC rated voltage: See table I. Operating temp

5、erature range: -55C to +125C. Characteristic: CG. Failure rate level (CCR76 only): M (1.0 percent), P (0.1 percent), R (.01 percent) or S (.001 percent). Thermal shock and voltage conditioning (CCR76 only): In accordance with MIL-PRF-20. Capacitance: Within tolerance specified (see table I). Dissipa

6、tion factor: In accordance with MIL-PRF-20. TABLE I. Capacitor characteristics. PIN 1/ 2/ Rated voltage (volts, dc) Nominal capacitance (pF) Capacitance tolerance PIN 1/ 2/ Rated voltage (volts, dc) Nominal capacitance (pF) Capacitance tolerance CC-76CG820- CC-76CG910- CC-76CG101- CC-76CG111- CC-76C

7、G121- CC-76CG131- CC-76CG271- CC-76CG301- CC-76CG331- CC-76CG361- CC-76CG391- 200 200 200 200 200 200 100 100 100 100 100 82 91 100 110 120 130 270 300 330 360 390 FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ CC-76CG431- CC-76CG471- CC-76CG511- CC-76CG561- CC-76CG621- CC-76CG681- CC-76CG751- CC-76CG8

8、21- CC-76CG911- CC-76CG102- 100 100 100 100 100 100 50 50 50 50 430 470 510 560 620 680 750 820 910 1000 FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ FGJ 1/ Complete PIN will include the following: 1st dash - Symbol “R” (for style CCR76) or dash will be deleted (for style CC76). 2nd dash - Applicable capacit

9、ance tolerance symbol. 3rd dash - Applicable failure rate level symbol (CCR76 only) or dash will be deleted (for style CC76). 2/ Capacitors deleted since previous revisions shall be replaced by selecting a capacitor with the nearest parameter. Provided by IHSNot for ResaleNo reproduction or networki

10、ng permitted without license from IHS-,-,-MIL-PRF-20/28D 3 Dielectric withstanding voltage: In accordance with MIL-PRF-20. Body insulation: Test II. Solderability: In accordance with MIL-PRF-20. Resistance to soldering heat: In accordance with MIL-PRF-20. Life: In accordance with MIL-PRF-20, operati

11、ng condition 2. Part or Identifying Number (PIN): In accordance with MIL-PRF-20 and table I. Marking: Method I of MIL-STD-1285, as shown in the following example: JCG - “J” brand (ER only) (J); and characteristic (CG). 820 - Capacitance value. GM1 - Capacitance tolerance (G); FR level, CCR76 only (M

12、); and year code (1 for 2011). ATM - Lot code (A); and trademark (TM). Referenced documents. In addition to MIL-PRF-20, this specification sheet references the following document: MIL-STD-1285 Changes from previous issue: The margins of this specification sheet are marked with vertical lines to indi

13、cate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irresp

14、ective of the marginal notations and relationship to the last previous issue. Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air Force 85 (Project 5910-2011-012) DLA - CC Review activities: Army - AV, MI Navy - AS, MC, OS Air Force 99 NOTE: The activities listed above were interested i

15、n this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-