DLA MIL-PRF-27 147 E-2009 TRANSFORMERS AND INDUCTORS (AUDIO POWER AND HIGH-POWER PULSE) INDUCTORS AUDIO HIGH Q.pdf

1、AMSC N/A FSC 5950 INCH-POUND MIL-PRF-27/147E 29 September 2009 SUPERSEDING MIL-PRF-27/147D 20 July 1993 PERFORMANCE SPECIFICATION SHEET TRANSFORMERS AND INDUCTORS (AUDIO, POWER, AND HIGH-POWER PULSE), INDUCTORS, AUDIO, HIGH Q This specification is approved for use by all Depart- ments and Agencies o

2、f the Department of Defense. The requirements for acquiring the transformer described herein shall consist of this specification sheet and MIL-PRF-27. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Marking shall be on the side of the case. 4. Unl

3、ess otherwise specified, tolerances on all dimensions shall be .015 inch (0.38 mm). 5. Electrical values shall be marked as specified in table I, as applicable. FIGURE 1. Dimensions and configurations 2.562 .030 “X“ mA“X“ OHMSW V (PK) 350 V(SEE TABLE I FOR VALUE OF “X“ ).266 .0302.812.437 .030 2.062

4、 .015ST-1708 TERMINALOR EQUIVALENT2 REQD.6871.188 .030.138-32 UNC-2BINSERT 4 REQD“X“ HCIRCUIT DIAGRAM AND MARKING12Inches mm .015 0.38 .030 0.76 .138 3.51 .266 6.76 .437 11.10 .687 17.45 1.188 30.18 2.062 52.37 2.562 65.07 2.812 71.42 Provided by IHSNot for ResaleNo reproduction or networking permit

5、ted without license from IHS-,-,-MIL-PRF-27/147E 2 TABLE I. Electrical ratings. 1/ Dash No. Inductance 2/ H 2% (1-2) DC 3/ current mA (1-2) DC resistance ohms 20% (1-2) Quality factor (min) Temperature stability (-55C to +105C) Working voltage (peak) V Voltage (1-2) 01 0.010 400 0.30 180 at 3 kHz 2%

6、 350 1 V at 500 Hz 02 0.030 250 0.90 180 at 3 kHz 2% 350 1 V at 500 Hz 03 0.070 170 2.2 200 at 3 kHz 2% 350 1 V at 500 Hz 04 0.12 120 3.6 200 at 3 kHz 2% 350 1 V at 500 Hz 05 0.50 60 16 200 at 3 kHz 2% 350 1 V at 500 Hz 06 1.0 40 28 190 at 3 kHz 2% 350 1 V at 500 Hz 07 2.0 30 64 165 at 2 kHz 2% 350

7、1 V at 500 Hz 08 3.5 22 101 135 at 1.5 kHz 2% 350 1 V at 500 Hz 09 7.5 16 230 110 at 1 kHz 2% 350 1 V at 500 Hz 10 12 11 373 100 at 1 kHz 2% 350 1 V at 500 Hz 11 18 9.0 463 85 at 700 Hz 2% 350 1 V at 500 Hz 12 25 8.0 680 75 at 700 Hz 2% 350 1 V at 500 Hz 13 40 6.0 1075 65 at 400 Hz 2% 350 1 V at 400

8、 Hz 14 60 4.0 1670 65 at 400 Hz 2% 350 1 V at 400 Hz 1/ Qualification testing and approval to M27/147-14 shall be sufficient to grant qualification approval to M27/147-01 through M27/147-13. For partial qualification, testing to one particular inductance value shall be sufficient to grant qualificat

9、ion approval to any smaller inductance value than what was qualified. 2/ The inductance is measured with 0 A dc applied to (1-2) and at the specified voltage across (1-2). 3/ The amount of dc current that will reduce the inductance a maximum of 8 percent. REQUIREMENTS: (When numbers in parentheses,

10、such as (1-2) are used, they indicate the winding and the extreme terminals of the winding.) Electrical ratings: See table I. Design and construction: Dimensions and configuration: See figure 1. Duty cycle: Continuous. Case: Metal encased. Terminals: Solder terminal, ST-1708 or equivalent. Provided

11、by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-PRF-27/147E 3 Terminal height: .266 .030 inch (6.76 0.76 mm). Weight: 550 grams, maximum. Altitude: 70,000 feet, maximum. Operating temperature range: -55C to +105C. Terminal strength: MIL-STD-202, method 21

12、1, test condition A, 5 pounds. Vibration (high frequency): MIL-STD-202, method 204. Dielectric withstanding voltage (at sea level): 1,000 volts rms. Marking location: See figure 1. Part or Identification Number (PIN): M27/147-(dash number from table I). Changes from previous issue. The margins of th

13、is specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requireme

14、nts of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Referenced documents. In addition to MIL-PRF-27, this document references the following: MIL-STD-202 Custodians: Preparing activity: Army - CR DLA - CC Navy - EC Air F

15、orce - 85 (Project 5950-2009-018) DLA - CC Review activities: Army - AR, CR4, MI Navy - AS, MC, OS, SH Air Force - 19, 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-