DLA MS25127 REV L-2005 SWITCHES TOGGLE UNSEALED AND SEALED TOGGLE GENERAL SPECIFICATION FOR《非密封和密封触发器开关的一般规格》.pdf

1、ASMC N/A FSC 5930 MS25127L 15 December 2005 SUPERSEDING MS25127K 15 November 1980 DETAIL SPECIFICATION SHEET SWITCHES, TOGGLE, UNSEALED AND SEALED TOGGLE GENERAL SPECIFICATION FOR This specification is approved for use by all Departments and Agencies of the Department of Defense. The complete requir

2、ements for acquiring the switch described herein shall consist of this specification and the latest issue of MIL-DTL-83731. FIGURE 1 Dimensions and configurations INCH-POUND INACTIVE FOR NEW DESIGN AFTER 16 SEPTEMBER 1969 Provided by IHSNot for ResaleNo reproduction or networking permitted without l

3、icense from IHS-,-,-MS25127L 2FIGURE 1 Dimensions and configurations Continued NOTES: 1. All dimensions are in inches. 2. For hardware and terminal screw detail specifications see supplement of MIL-DTL-83731. 3. Unless otherwise specified, tolerance is .020 on two place decimals and .005 on three pl

4、ace decimals. 4. Example of part NO. MS25127-B1-On, off, on, toggle seal, locked in center position. 5. Locking means optional. 6. For design feature purposed, this standard takes precedence over procurement documents referenced herein. Provided by IHSNot for ResaleNo reproduction or networking perm

5、itted without license from IHS-,-,-MS25127L 3REQUIREMENTS: All switches on this standard are designed so that the movement of the switch mechanism is opposite to that of the toggle lever. Locking Arrangement: Positive locking shall be accomplished and shall prevent motion of the toggle lever until t

6、he locking mechanism is manually released. The force required to release the locking mechanism shall be 3 to 5 pounds. Maximum weight is .19 lb. Electrical Endurance: 10,000 Cycles. Mechanical Endurance: 20,000 Cycles Referenced documents shall be of the issue in effect on the date of invitation for

7、 bid. Electrical rating: Table I Table I Detail Requirement Current Capacity (Amperes Per Pole) Circuit with Toggle Lever In 28 Volts Direct current 115 Volts Alternating Current 400 Hertz MS part No. Former Ms Part No. Opposite keying side center Keying side Lamp- load Circuit Resistive circuit Ind

8、uctive Circuit Lamp- load Circuit Resistive circuit Inductive Circuit MS25127-1 A,B,C,D,E Off On MS25127 -2 Off MS25127-3 C,E None On MS25127-4 B,J Off MS25127-5 Mom. Off None 5 20 12 4 20 15 MS25127-6 L On None MS25127-7 F,H Mom-On MS25127-8 K None Off Mom. On 4 18 10 2 11 5 MS25127-9 On Mom. Off 5

9、 20 12 4 20 15 MS25127-10 L Off None MS25127-11 G,K,M,N On Off Mom. On 4 18 10 2 11 5 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25127L 4Referenced documents MIL-DTL-83731 Marginal notations are not used in this revision to identify changes wi

10、th respect to the previous issue due to the extent of the changes. Custodians: Preparing activity: Army CR DLA CC Navy AS Air Force 11 Project (5930-2005-013) DLA CC Review activities: Army AR, AV, MI Navy EC, MC Air Force 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil/. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-