DLA MS25471 REV F-2011 WIRE ELECTRICAL SILICONE-INSULATED COPPER 600 VOLT 200 DEG C POLYESTER JACKET.pdf

1、AMSC N/A FSC 6145 MS25471F 19 October 2011 SUPERSEDING MS25471E 06 December 2004 DETAIL SPECIFICATION SHEET WIRE, ELECTRICAL, SILICONE-INSULATED, COPPER, 600 VOLT, 200 DEG. C, POLYESTER JACKET This specification is approved for use by all Departments and Agencies of the Department of Defense. The re

2、quirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-8777. FIGURE 1. Cable. INCH-POUND Inactive for new design after 1 June 1998. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25471F 2 TABLE

3、I. Performance details. Abrasion test Flaws test Insulation and surface resistance Life cycle and cold bend Wire size Resistance,inchesoftape min.Tension load lbs.WeightsupportbracketWeight lbs. Min ac voltage 60 Hz rms Humidityresistance megohmsper200 feetmin.Insulation resistance megohmsper50 feet

4、min.Surface resistance megohminchesminMandrel diameter inches max Testload life cycle cold bend lbsPrimaryinsulationFinished wireLifecycleCold bend22 22 1 A 1 2000 5000 500 100 5.0 4.5 3 .75 20 22 1 A 1 2000 5000 500 100 5.0 4.5 3 .75 18 22 1 A 1 2000 5000 500 100 5.0 4.5 3 1.0 16 30 2 A 1 2000 5000

5、 500 100 5.0 6.5 3 1.0 14 13 2 B 3 2000 5000 500 100 5.0 6.5 6 1.0 12 17 2 B 3 2000 5000 500 100 5.0 6.5 6 3.0 10 20 2 B 3 3000 5000 10 6 3.0 8 25 2 B 3 3000 5000 10 6 3.0 6 25 2 C 3 4000 5000 10 10 6.0 4 33 2 C 4.25 4000 5000 10 10 6.0 2 34 2 C 4.25 4000 5000 10 10 6.0 1 35 2 C 4.25 4000 5000 10 18

6、 6.0 0 48 2 C 4.25 4000 5000 10 18 10.0 00 48 2 C 4.25 4000 5000 10 18 10.0 TABLE II. Finished wire construction. Dash Wire size Number of strands Max diameter of stranded conductor Max resistance at 20C (68F) ohms/1000 ft Diameter Max. weight lbs/1000 ft 22 22 19 .033 15.2 .085 .005 5.8 20 20 19 .0

7、41 9.42 .095 .005 7.8 18 18 19 .052 6.03 .110 .005 10.8 16 16 19 .060 4.76 .125 .005 13.5 14 14 19 .074 2.99 .143 .007 20.0 12 12 19 .093 1.88 .163 .007 29.0 10 10 49 .128 1.16 .193 .007 45.0 8 8 133 .176 .70 .248 .007 72.0 6 6 133 .218 .436 .303 .007 107.0 4 4 133 .272 .274 .360 .010 165.0 2 2 665

8、.345 .179 .425 .010 262.0 1 1 817 .384 .144 .460 .010 317.0 01 0 1045 .432 .114 .535 .015 390.0 02 00 1330 .490 .090 .585 .015 500.0 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25471F 3 TABLE III. Dimensions. Inches mm Inches mm Inches mm Inche

9、s mm .005 .13 .074 1.88 .163 4.14 .360 9.14 .007 .18 .085 2.16 .176 4.47 .384 9.75 .010 .25 .093 2.36 .193 4.90 .425 10.79 .015 .38 .095 2.41 .218 5.54 .432 10.97 .033 .84 .110 2.79 .248 6.30 .460 11.68 .041 1.04 .125 3.18 .272 6.91 .490 12.45 .052 1.32 .128 3.25 .303 7.70 .535 13.59 .060 1.52 .143

10、3.63 .345 8.76 .585 14.86 REQUIREMENTS The procurement specification for this specification sheet is MIL-DTL-8777. Dimensions are in inches. Metric equivalents are given for information only. Tensile strength (minimum): 800 psi before aging; 600 psi after aging. Elongation (minimum): 1.5 inches (38

11、mm) 2 inch (51 mm) specimen stretched to 3.5 (89 mm) inches before and after aging. Insulation shrinkage: During and following the thermal shock or flash test, the primary insulation shall not shrink greater then .060 inch (1.52 mm) for all wire sizes. Dimensions and configuration: See figure 1 and

12、tables I, II and III. Part or Identifying Number (PIN) example: MS25471 - 10 MS specification sheet number Dash number Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Referenced doc

13、ument. This document references MIL-DTL-8777. CONCLUDING MATERIAL Custodians: Preparing activity: Army - AV DLA - CC Navy - AS Air Force - 85 (Project 6145-2011-032) DLA - CC NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-