DLA MS25919 REV E-2006 RELAYS ELECTROMAGNETIC TYPE I 10 AMPERES 4 PDT《I型4 PDT 10安培电磁继电器》.pdf

1、 AMSC N/A FSC 5945 INCH-POUND MS25919E 20 June 2006 SUPERSEDING MS25919D 14 February 2001 DETAIL SPECIFICATION SHEET RELAYS, ELECTROMAGNETIC, TYPE I, 10 AMPERES, 4 PDT This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring

2、the relay described herein shall consist of this specification and the latest issue of MIL-PRF-6106. -1 (SOLDER TERMINALS -2 (POTTED LEADS) -1 (SOLDER TERMINALS) -2 (POTTED LEADS) FIGURE 1. Dimensions and configurations.INACTIVE FOR NEW DESIGN AFTER 2 MARCH 1987. NO SUPERSEDING STANDARD. FOR NEW DES

3、IGN USE MIL-PRF-83536/15, MIL-PRF-83536/16, MIL-PRF-83536/17. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25919E 2 NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Terminal numbers do not appe

4、ar on the relay header. There shall be affixed to the relay a suitable legible circuit diagram that identifies each terminal location specified. Circuit diagram shown above is the terminal view. 4. In the event of a conflict between the text of this standard and the references cited herein, the text

5、 of this standard shall take precedence. 5. Referenced Government documents of the issue listed are available online at http:/assist.daps.dla.mil/quicksearch/ or http:/assist.daps.dla.mil/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.

6、Specified in the solicitation form a part of this document to the extent specified herein. 6. For details see table I. 7. Unless otherwise specified, tolerance is .010 (0.25 mm). FIGURE 1. Dimensions and configurations - Continued. Inches mm Inches mm .005 0.13 1.000 25.40 .010 0.25 1.187 30.15 .062

7、 1.57 1.218 30.94 .125 3.18 1.765 44.83 .138 3.51 2.250 57.15 .152 3.86 2.656 67.46 .375 9.53 6.000 152.40 .625 15.88 24.000 609.60 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25919E 3 REQUIREMENTS: Dimensions and configuration: See figure 1. W

8、eight: -1 .5 pounds (227 grams). -2 .80 pounds (363 grams). Contact requirements: Load ratings: High level (relay case grounded). Resistive: 10 amperes at 28 V dc, 115 V ac (400 Hz). Inductive: 7 amperes at 28 V dc, 115 V ac (400 Hz). Motor: 6 amperes at 28 V dc, 115 V ac (400 Hz). 4 amperes at 115/

9、200 V ac (400 Hz, 3 phase). Mixed loads: Applicable. Coil requirements: Nominal coil voltage: 28 V dc. Pick up voltage: 18 V dc (over the temperature range). Hold voltage: 7.0 V dc (over the temperature range). Dropout voltage: 1.5 V dc (over the temperature range). Coil current: 0.25 ampere maximum

10、. Electrical requirements: Insulation resistance (minimum): Initial: 100 megohms. After life or environmental test: 50 megohms. Dielectric strength: Sea level (V rms) Altitude (V rms) Initial After life 80,000 feet -1 -2 Coil to case: 1,000 1,000 350 500 All of the points: 1,250 1,000 350 500 Provid

11、ed by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS25919E 4 Environmental requirements: Temperature range: -65C to +120C. Life test requirements: 50,000 cycles minimum. Qualification by similarity: See MIL-PRF-6106. Group B and Group C inspections are not a

12、pplicable. Group A acceptance reports shall be submitted to the qualifying activity on a yearly basis in order to retain qualification for this detail specification sheet. Part or identifying number: (PIN): MS25919-1 for solder terminals or MS25919-2 for potted leads. NOTES: Referenced documents. In

13、 addition to MIL-PRF-6106, this document references the following: NASM35338 MIL-DTL-8777 MIL-PRF-8516 Changes from previous issue: Marginal notations are mark with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assu

14、mes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodian: Preparing activity: Navy

15、 - AS DLA - CC Air Force - 11 DLA - CC (Project 5945-2006-018) NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-