DLA MS28932 REV B-2009 FELT STRIP PACKING GLAND.pdf

1、AMSC N/A FSC 5330 MS28932B 23 APRIL 2009 SUPERSEDING MS28932A 26 SEPTEMBER 1977 DETAIL SPECIFICATION SHEET FELT STRIP, PACKING GLAND This specification sheet is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the product described herein

2、shall consist of this specification sheet and procurement specification C-F-206. 60 5.125 .014.188+.016-.000FOR USE CUT LENGTH TO SUIT PERIPHERY OF ROD. ENDS TO OVERLAPAT APPROXIMATELY 45 ANGLE AS INDICATED BELOW FOR CUT STOCK.FIGURE 1. Bulk stock. 4545.188L.125 .014+.016-.000FIGURE 2. Cut stock.INC

3、H-POUNDInactive for new design after 16 JUNE 1997.Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS28932B 2TABLE I. Dash numbers and dimensions. (2) DASH NUMBER FORM -1 BULK STOCK (3) C-L CUT STOCK Notes: 1. Material shall be in accordance with proc

4、urement specification C-F-206, Type I, Class 12R1. 2. Example of part number: MS28932 C-01-08 = Felt strip cut to 1.500 inches in length Fractions of an inch in sixteenths (.063) Inches Cut MS number MS28932C-09-06 = Felt strip cut to 9 3/8 (9.375) inches in length. MS28932C-15-13 = Felt strip cut t

5、o 15 13/16 (15.813) inches in length. MS28932-1 = Felt strip bulk material 60 inches in length. 3. Dimension “L” shall be length of cut stock with a tolerance of +.500, -.000 inches. 4. Dimensions in inches. Unless otherwise specified, tolerances: Decimals .016, Angles 5. 5. Service activities shoul

6、d procure bulk only. Manufacturers shall specify bulk stock in parts and shall furnish spares as bulk stock. 6. For design purposes, this standard takes precedence over procurement specification referenced here-in. 7. Changes from previous issue. Marginal notations are not used in this revision to i

7、dentify changes with respect to the previous issue due to the extent of the changes. Custodians: Preparing Activity: Navy -AS DLA -IS Air Force 99 (Project 5330-2009-011) NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-