DLA MS51841 REV D-1987 ELBOW TUBE TO BOSS BOSS ON BRANCH O-RING FLARELESS TYPE HYDRAULIC [Refer To SAE J514 SAE J514 SAE J514 SAE J514 SAE J514]《液压非扩口式O形圈轴套转移三岔管》.pdf

1、E-/?- 05 I FED. SUP. CLASS I SLEEVE-MS51825 FITTING END i (SEE O-RINC-MS2877k NOTE 9) IN ACCORDANCE WITH MC51889 c I I IJ I 4730 I I I NOTES: 1. MATERIAL: Steel, carbon in accordance with procurement specification. 2. PROTECTIVE COATIIG: Cadmium plated in accordance with procurement specification. S

2、teel, corrosion-resisting-in accordance with procurement specification, Zinc plated in accordance with procurement specification. Phosphate coating in accordance with procurement specification. Passivation treatment in accordance with procurement specification. 3. DIMENSIONS AND TOLERANCES: Dimensio

3、ns and tolerances not shown shall be in accordance with THREADS: Threads shall be in accordance with bcreu-Thread Standards for Federal Services, PART NUMBER: The MS parL number consists of the HC number, plus the dash number and (for SAE Standard for Flareless Tube Fittings (SAE 5514). e)&. a5. FED

4、-STD-H2. complete assembly) the applicable MS51825 sleeve style designator. A. For complete assembly (with nuts and sleeves), cadmium plated, use the MS number, plus the assembly dash number and the sleeve style designator. Example: MS51841-IA or tIC5141-18. B. For body only, cadmium plated, use the

5、 MC number and the body dash number. Example: NS5184l-21. C. For zinc coating add “Z“ and (for complete assembly) the sleeve style designator to the dash number. Example: FS5141-1ZA or S51841-128 or 5184 1-21 2. D. For phosphate coating add “P“.and (for complete assembly) the sleeve style designator

6、 .to the dash number. E. For corrosion-resisting steel add “SS“ and (for complete assembly) Lhe sleeve style designator to the dash number. Example: NS51841-ISSA or MS51841-1SS or MS51841-21SS. Example: MS5184-IPA or MS51841-1P8 or MSII-LIP. 6. i. Reference documents shall be of the issue in effect

7、on date of invitations for bid. J?. 9. 10, For design feature purposes, this standard takes precedence over procurement documents refer- enced herein. The illustration is for identification and is not intended to restrict designs or shapes not dimensioned. Procure the O-Ring separately and install i

8、mmediately before installation of the fitting. After 9 July 1973, bodies will be used for production only and SHALL NOT be stocked for main- tenance. Existing stock of bodies should be used until depleted. ¬ea change Q ._ TITLE M Il IT ARY SV AN DA RD .A. AK #her Cuit 99 TEE,TUBE TO BOSS, 8cS ON BRANCH, O-RING, FLARELESS TYPE, HYDRAULIC I I SHEET 1 OF 1 ROCUREYENT SPECIFICATIDN SUPERSEDES: MIL-F-18866 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-