DLA MS77074 REV B-2003 TERMINAL LUG SOLDER TYPE PHOSPHOR BRONZE STAMPING INSULATION GRIP LOCKING TYPE《联轴型绝缘手柄磷青铜冲压片 焊料型终端接线片》.pdf

1、 AMSC N/A FSC 5940 INCH-POUND MS77074B 17 December 2003 SUPERSEDING MS77074A 15 December 1989 DETAIL SPECIFICATION SHEET TERMINAL, LUG, SOLDER TYPE, PHOSPHOR BRONZE STAMPING, INSULATION GRIP, LOCKING TYPE Inactive for new design after 27 October 1999. This specification sheet is approved for use by

2、all departments and agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification sheet and MIL-DTL-15659. Contour indicated by phantom linesmay vary from that shown to suitindividual manufacturers design.332DiaA1818D.018 .003B

3、1132CFIGURE 1. Terminal dimensions.Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS77074B 2 TABLE I. Dash numbers and dimensions. A Dash no. Screw size Min. Max. B C D AWG1size 1 4 0.115 0.127 25/32 5/16 11/64 2 6 0.141 0.153 25/32 5/16 11/64 3 8 0

4、.167 0.179 25/32 5/16 11/64 4 10 0.193 0.205 51/64 11/32 5/32 5 8 0.167 0.179 7/8 1/2 11/64 6 10 0.193 0.205 7/8 1/2 11/64 7 1/4 0.258 0.285 7/8 1/2 11/64 12 to 20 1American Wire Gauge. REQUIREMENTS: 1. Material: Phosphor bronze strip alloy C50500 (1.3 percent tin), in accordance with ASTM B 508 (Do

5、D adopted) having a minimum temper of H02. As an alternative material, copper strip alloy C42500 in accordance with ASTM B 591 (DoD adopted) having a minimum temper of H02 may be used. 2. Finish: Tinned; electrodeposited over entire surface in accordance with ASTM B 545 (DoD adopted) and ASTM B 339

6、(DoD adopted). Minimum thickness 0.0005 inches. NOTES: 1. Dimensions are in inches. 2. Unless otherwise specified, tolerance is 0.015, angles 2 degrees. 3. Remove all burrs. 4. Referenced documents of issue in effect on date of invitation for bids shall apply. 5. In the event of a conflict between t

7、he text of this document and the references cited herein, the text of this document shall take precedence. 6. The part or identifying number (PIN) consists of the letters MS, the specification sheet number, and a dash number taken from table I. MS 77074 - 3 Dash number Specification sheet number MS

8、prefix Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS77074B 3 CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Custodians: Preparing Activity: Army - AV Navy - SH Air Force - 11 DLA - GS2 (Project 5940-1441) Review Activities: Navy - AS, MC Air Force - 99 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-