ECA EIA-364-43C-2013 TP-43C Cable Clamping (Bending Moment) Test Procedure for Electrical Connectors.pdf

1、 EIA STANDARD TP-43C Cable Clamping (Bending Moment) Test Procedure for Electrical Connectors EIA-364-43C (Revision of EIA 364-43B) July 2013 EIA-364-43CANSI/EIA-364-43C-2013 Approved: June 30, 2000 Revised: July 29, 2013 NOTICE EIA Engineering Standards and Publications are designed to serve the pu

2、blic interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for his particular need. Existence of such Standards and

3、 Publications shall not in any respect preclude any member or nonmember of ECIA from manufacturing or selling products not conforming to such Standards and Publications, nor shall the existence of such Standards and Publications preclude their voluntary use by those other than ECIA members, whether

4、the standard is to be used either domestically or internationally. Standards and Publications are adopted by ECIA in accordance with the American National Standards Institute (ANSI) patent policy. By such action, ECIA does not assume any liability to any patent owner, nor does it assume any obligati

5、on whatever to parties adopting the Standard or Publication. This standard is based upon the major technical content of International Electrotechnical Commission standard 60512-17-1, cable clamp robustness, 2010, edition 1.0 . It conforms in all essential respects to this IEC standard This Standard

6、does not purport to address all safety problems associated with its use or all applicable regulatory requirements. It is the responsibility of the user of this Standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before its use. (

7、From Standards Proposal No. 5252.09, formulated under the cognizance of the CE-2.0 Committee on EIA National Connector and Sockets Standards.) Published by Electronic Components Industry Association 2013 EIA Standards see figure 1 5.2 Special mounting instruction, if any 5.3 The number of specimens

8、to be tested 5.4 Acceptance criteria 5.5 Number of load applications 5.6 Load orientation, if other than specified EIA-364-43C Page 4 6 Test documentation Documentation shall contain the details specified in clause 5, with any exceptions, and the following: 6.1 Title of test 6.2 Specimen description

9、, including fixturing and point of application 6.3 Test equipment used, and date of last and next calibration 6.4 Test procedure 6.5 Name of operator and start/finish date(s) of test ECIA Document Improvement Proposal If in the review or use of this document, a potential change is made evident for s

10、afety, health or technical reasons, please fill in the appropriate information below and mail or FAX to: Electronic Components Industry Association EIA Standards & Technology Department 2214 Rock Hill Rd., Suite 170 Herndon, VA 20170 FAX: (571-323-0245) Document No.: Document Title: Submitters Name:

11、 Telephone No.: FAX No.: e-mail: Address: Urgency of Change: Immediate: At next revision: Problem Area: a. Clause Number and /or Drawing: b. Recommended Changes: c. Reason/Rationale for Recommendation: Additional Remarks: Signature: Date: FOR ECIA USE ONLY Responsible Committee: Chairman: Date comme

12、nts forwarded to Committee Chairman: Revision History Revision letter Project number Additions, changes and deletions C SP-5252.09 Revised to correct editorial errors in paragraph 2.1.3 and 5.1. Added paragraph 6.5. Electronic Components Industry Association 2214 Rock Hill Road, Suite 170 * Herndon, VA 20170 * tel 571-323-0294 * fax 571-323-0245