ECMA 399-2011 Procedure for the Registration of Assigned Numbers for ECMA-398《ECMA-398分配号码注册程序(第1版)》.pdf

1、 Reference numberECMA-399:2011Ecma International 2011ECMA-399 1stEdition / June 2011 Procedure for the Registration of Assigned Numbers for ECMA-398 COPYRIGHT PROTECTED DOCUMENT Ecma International 2011 Ecma International 2011 iContents Page 1 Scope 1 2 Normative references 1 3 Terms and definitions

2、. 1 4 International Register 1 4.1 Specifier ID . 1 5 Registration Authority . 2 5.1 Appointment 2 5.2 Duties 2 5.2.1 Maintenance of International Register 2 5.2.2 Publication of public content of International Register 2 5.2.3 Inform the requestor of the decision . 2 6 Registration requests 2 7 Reg

3、istration procedure . 2 8 Withdrawal procedure . 2 9 Amendment procedure . 3 10 Appeal procedure 3 ii Ecma International 2011 Ecma International 2011 iiiIntroduction This Ecma Standard specifies the registration procedures for the Specifier ID register used in ECMA-398. Entries in this register are

4、likely to be added over time. Therefore, these contents are implemented as register rather than as table in the base standard. This Ecma Standard has been adopted by the General Assembly of June 2011. iv Ecma International 2011“DISCLAIMER This document and possible translations of it may be copied a

5、nd furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published, and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this section are included on al

6、l such copies and derivative works. However, this document itself may not be modified in any way, including by removing the copyright notice or references to Ecma International, except as needed for the purpose of developing any document or deliverable produced by Ecma International (in which case t

7、he rules applied to copyrights must be followed) or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by Ecma International or its successors or assigns. This document and the information contained herein is pro

8、vided on an “AS IS“ basis and ECMA INTERNATIONAL DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY OWNERSHIP RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.“ Pr

9、ocedure for the Registration of Assigned Numbers for ECMA-398 1 Scope This Standard specifies the procedure to be followed by a Registration Authority in preparing, maintaining and publishing International Register of assigned numbers and associated descriptions for entries specified in 4, for use w

10、ith ECMA-398. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ECMA-398, Cl

11、ose Proximity Electric Induction Wireless Communications ISO/IEC 8859-1:1998, Information technology - 8-bit single-byte coded graphic character sets - Part 1: Latin alphabet No. 1 ISO/IEC Directives, Part 1, 2011 3 Terms and definitions In addition to the terms defined herein, the terms defined in

12、Annex H of the ISO/IEC Directives, Part 1, 2011 apply. 3.1 bit binary digit with value ZERO or ONE 3.2 string sequence of at least one and at most 50 characters encoded in ISO/IEC 8859-1 3.3 octet sequence of eight bits 4 International Register 4.1 Specifier ID The Specifier ID is a twenty bit value

13、 that uniquely identifies the owner of any Specifier ID as specified in Annex A.1.1 of ECMA-398. Requestors shall specify a unique string for registration. Ecma International 2011 15 Registration Authority 5.1 Appointment Ecma International shall be the Registration Authority for the International R

14、egister defined in 4. 5.2 Duties 5.2.1 Maintenance of International Register The Registration Authority shall maintain the International Register specified in 4.1 due to Registration as specified in 7, withdrawal (as specified in 8) or amendment (as specified in 9) of assigned strings for allocated

15、Specifier ID values. 5.2.2 Publication of public content of International Register The Registration Authority shall publish the assigned values and associated strings from the International Register for public access at http:/www.ecma-international.org/publications/standards/EIWC_specifier_id.htm at

16、 no cost. 5.2.3 Inform the requestor of the decision The Registration Authority shall inform the requestor of the decision to register, reject, withdraw or amend. 6 Registration requests Using the form at the International Specifier ID Register, implementers of ECMA-398 may request registration of a

17、 unique string for a value in the International Register specified in 4.1. 7 Registration procedure The Registration Authority shall: a) Review registration requests as specified in 6; b) Ascertain that registration requests are in accordance with this Standard; c) If required, indicate to the reque

18、stor the changes needed to meet the requirements of this Standard; d) Approve or reject the registration request; e) In case of approval, allocate and add the Specifier ID value to the International Register with the assigned string; f) Inform the requestor of the registration or rejection within 15

19、 business days. 8 Withdrawal procedure The requestor may declare withdrawal of its support for its entry in an International Register by using the form accessible from http:/www.ecma-international.org/publications/standards/eiwc_id_request_form.php, if so desired accompanied with the reason. 2 Ecma

20、International 2011 Ecma International 2011 3Withdrawal shall not change the registered string and allocated value in the International Register; the Registration Authority shall mark the entry as withdrawn with the withdrawal date and inform the requestor accordingly. 9 Amendment procedure The reque

21、stor may request amendment of the strings in one of its entries in an International Register by using the form accessible at http:/www.ecma-international.org/publications/standards/eiwc_id_request_form.php. Only when the RA confirms the mistake or in case of name changes, the Registration Authority

22、is permitted to correct the string in the International Register and shall inform the requestor accordingly. The Registration Authority may periodically query the requestor to validate its assigned entry and amend or withdraw it as needed. 10 Appeal procedure Appeals shall be filed using the form ac

23、cessible at http:/www.ecma-international.org/publications/standards/eiwc_id_request_form.php within 20 business days of receipt of the decision from the Registration Authority. The Registration Authority shall respond to the appeal within 20 business days after receipt of the appeal. Ecma International 2011