EN 15922-2011 en Fertilizers - Extraction of soluble phosphorus according to Petermann at ambient temperature《肥料 按照皮特曼室温的可溶磷的萃取》.pdf

1、raising standards worldwideNO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Standards PublicationBS EN 15922:2011Fertilizers Extraction ofsoluble phosphorus accordingto Petermann at ambienttemperatureBS EN 15922:2011 BRITISH STANDARDNational forewordThis British Standard is

2、the UK implementation of EN 15922:2011. Itsupersedes DD CEN/TS 15922:2009 which is withdrawn.The UK participation in its preparation was entrusted to TechnicalCommittee CII/37, Fertilisers and related chemicals.A list of organizations represented on this committee can beobtained on request to its se

3、cretary.This publication does not purport to include all the necessaryprovisions of a contract. Users are responsible for its correctapplication. BSI 2011ISBN 978 0 580 72729 0ICS 65.080Compliance with a British Standard cannot confer immunity fromlegal obligations.This British Standard was publishe

4、d under the authority of theStandards Policy and Strategy Committee on 30 June 2011.Amendments issued since publicationDate Text affectedBS EN 15922:2011EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 15922 June 2011 ICS 65.080 Supersedes CEN/TS 15922:2009English Version Fertilizers - Extractio

5、n of soluble phosphorus according to Petermann at ambient temperature Engrais - Extraction du phosphore soluble selon Petermann temprature ambiante Dngemittel - Extraktion des lslichen Phosphors nach Petermann bei Raumtemperatur This European Standard was approved by CEN on 29 April 2011. CEN member

6、s are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application

7、 to the CEN-CENELEC Management Centre or to any CEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Managemen

8、t Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands

9、, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels 2011 CEN All rights of exploitation in any

10、 form and by any means reserved worldwide for CEN national Members. Ref. No. EN 15922:2011: EBS EN 15922:2011EN 15922:2011 (E) 2 Contents Page Foreword 3 1 Scope 4 2 Normative references 4 3 Terms and definitions .4 4 Principle 4 5 Sampling .4 6 Reagents .5 7 Apparatus .6 8 Procedure .6 Bibliography

11、 7 BS EN 15922:2011EN 15922:2011 (E) 3 Foreword This document (EN 15922:2011) has been prepared by Technical Committee CEN/TC 260 “Fertilizers and liming materials”, the secretariat of which is held by DIN. This European Standard shall be given the status of a national standard, either by publicatio

12、n of an identical text or by endorsement, at the latest by December 2011, and conflicting national standards shall be withdrawn at the latest by December 2011. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC sha

13、ll not be held responsible for identifying any or all such patent rights. This document supersedes CEN/TS 15922:2009. This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association. According to the CEN/CENELEC Internal Regulations, th

14、e national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Nether

15、lands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. BS EN 15922:2011EN 15922:2011 (E) 4 1 Scope This document specifies the procedure for the extraction of phosphorus soluble in cold alkaline ammonium citrate. The method is applicable for

16、disintegrated phosphates exclusively. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendment

17、s) applies. EN 1482-2, Fertilizers and liming materials Sampling and sample preparation Part 2: Sample preparation EN 12944-1:1999, Fertilizers and liming materials and soil improvers Vocabulary Part 1: General terms EN 12944-2:1999, Fertilizers and liming materials and soil improvers Vocabulary Par

18、t 2: Terms relating to fertilizers EN 15475, Fertilizers Determination of ammoniacal nitrogen CEN/TS 15959, Fertilizers Determination of extracted phosphorus 3 Terms and definitions For the purposes of this document, the terms and definitions given in EN 12944-1:1999 and EN 12944-2:1999 apply. 4 Pri

19、nciple Extraction of phosphorus at ambient temperature about 20 C with an alkaline solution of ammonium citrate (Petermanns solution) under the specified conditions. 5 Sampling Sampling is not part of the method specified in this document. A recommended sampling method is given in EN 1482-1. Sample

20、preparation shall be carried out in accordance with EN 1482-2. Grinding of the laboratory sample is recommended for homogeneity reasons. BS EN 15922:2011EN 15922:2011 (E) 5 6 Reagents 6.1 Water, distilled or demineralized having the same characteristics as distilled water. 6.2 Petermanns solution 6.

21、2.1 Characteristics of the Petermanns solution citric acid (C6H8O7. H2O): 173 g/l; ammonia: 42 g/l of ammoniacal nitrogen; pH between 9,4 and 9,7. 6.2.2 Preparation from diammonium citrate Dissolve 931 g of diammonium citrate (molecular mass 226,19) in about 3 500 ml of water (6.1), in a 5 l standar

22、d flask. Stand in a bath of running water, mix and cool and add in small amounts ammonia. For example, for d20= 0, 906 g/ml.corresponding to a level of 20,81 % by mass of ammoniacal nitrogen, it is necessary to use 502 ml of ammonia solution. Adjust the temperature to 20 C, make up to volume with wa

23、ter (6.1) and mix. 6.2.3 Preparation from citric acid and ammonia Dissolve 865 g of citric acid monohydrate in about 2 500 ml of water (6.1) in a container of about 5 l capacity. Place the container in an ice bath, and add in small amounts, shaking constantly, ammonia solution using a funnel, the st

24、em of which is immersed in the citric acid solution. For example, for d20= 0, 906 g/ml.corresponding to a level of 20,81 % by mass of ammoniacal nitrogen, it is necessary to add 1 114 ml of ammonia solution. Adjust the temperature to 20 C, transfer to a 5 l standard flask, make up to the mark with w

25、ater (6.1) and mix. 6.2.4 Checking of the ammoniacal nitrogen content Transfer 25 ml of the solution into a 250 ml standard flask and make up to volume with water (6.1) and mix. Determine the ammoniacal content on 25 ml of this solution according to EN 15475. If the solution is correct, an amount of

26、 15 ml of c = 0,25 mol/l H2SO4 shall be used. If the strength of ammoniacal nitrogen is greater than 42 g/l, NH3can be expelled by a stream of inert gas or by moderate heating to bring back the pH to 9,7. Carry out a second determination. If the strength of ammoniacal nitrogen is less than 42 g/l, i

27、t will be necessary to add a mass M in grams of ammonia solution: 20,815002,8)(42 = nM (1) n is the volume of the sulfuric acid c=0,25 mol/l, in millilitres or a volume, V, at 20 C: 0,906MV = (2) If V is less than 25 ml, add it directly to the 5 l flask with a mass of V 0,173 g powdered citric acid.

28、 BS EN 15922:2011EN 15922:2011 (E) 6 If V is greater than 25 ml, it will be convenient to prepare a new litre of reagent in the following way. Weigh 173 g of citric acid. Dissolve it in 500 ml of water. And, taking the precautions indicated, add not more than 225 + V 1 206 ml of ammonia solution whi

29、ch was used to prepare the 5 l of reagent. Make up to volume with water and mix. Mix this litre with the 4 975 ml previously prepared. 7 Apparatus 7.1 Common laboratory equipment and glassware, in particular equipment according to 7.2 to 7.3. 7.2 250 ml graduated flask, e.g. Stohmann. 7.3 Rotary sha

30、ker, 35 to 40 turns per minute. 8 Procedure 8.1 Test portion Weigh, to the nearest 0,001 g, 2,5 g of the prepared sample and place it in a 250 ml graduated flask (7.2). 8.2 Extraction Add a little amount of Petermanns solution (6.2) at 20 C, shake very hard in order to stop the formation of lumps an

31、d to prevent any of the substance adhering to the side of the flask. Make up to the graduation mark with Petermanns solution and close the flask with a rubber stopper. Shake for 2 h in the rotary shaker (7.3). Filter immediately through a dry pleated filter, free from phosphate, into a dry container

32、, discarding the first portion of the filtrate. Continue the filtering until a sufficient quantity of filtrate is obtained to carry out the phosphorus determination according to CEN/TS 15959. BS EN 15922:2011EN 15922:2011 (E) 7 Bibliography 1 EN 1482-1, Fertilizers and liming materials Sampling and

33、sample preparation Part 1: Sampling 2 Regulation (EC) No 2003/2003 of the European Parliament and of the Council of 13 October 2003 relating to fertilisers, Official Journal L 304, 21/11/2003, P. 0001-0194, Annex IV, method 3.1.5.2 This page deliberately left blankThis page deliberately left blankBS

34、I is the independent national body responsible for preparing British Standardsand other standards-related publications, information and services. It presents the UK view on standards in Europe and at the international level. It is incorporated by Royal Charter.British Standards Institution (BSI)rais

35、ing standards worldwideBSI Group Headquarters389 Chiswick High Road London W4 4AL UKTel +44 (0)20 8996 9001Fax +44 (0)20 8996 Standards are updated by amendment or revision. Users of British Stan-dards should make sure that they possess the latest amendments or editions.It is the constant aim of BS

36、I to improve the quality of our products and serv-ices. We would be grateful if anyone finding an inaccuracy or ambiguity whileusing this British Standard would inform the Secretary of the technical com-mittee responsible, the identity of which can be found on the inside frontcover.Tel: +44 (0)20 89

37、96 9001 Fax: +44 (0)20 8996 7001BSI offers Members an individual updating service called PLUS which ensuresthat subscribers automatically receive the latest editions of standards.Tel: +44 (0)20 8996 7669 Fax: +44 (0)20 8996 7001Email: Buying standardsYou may buy PDF and hard copy versions of standar

38、ds directly using acredit card from the BSI Shop on the website addition all orders for BSI, international and foreign standards publicationscan be addressed to BSI Customer Services.Tel: +44 (0)20 8996 9001 Fax: +44 (0)20 8996 7001Email: In response to orders for international standards, it is BSI

39、 policy tosupply the BSI implementation of those that have been publishedas British Standards, unless otherwise requested.Information on standardsBSI provides a wide range of information on national, Europeanand international standards through its Knowledge Centre.Tel: +44 (0)20 8996 7004 Fax: +44 (

40、0)20 8996 7005Email: Various BSI electronic information services are also available whichgive details on all its products and services. Tel: +44 (0)20 8996 7111 Fax: +44 (0)20 8996 7048Email: BSI Subscribing Members are kept up to date with standardsdevelopments and receive substantial discounts on

41、the purchase priceof standards. For details of these and other benefits contact Membership Ad-ministration. Tel: +44 (0)20 8996 7002 Fax: +44 (0)20 8996 7001 Email: Information regarding online access to British Standards via BritishStandards Online can be found at information about BSI is availab

42、le on the BSI website at www.bsi- subsists in all BSI publications. BSI also holds the copyright,in the UK, of the publications of the international standardization bodies. Ex-cept as permitted under the Copyright, Designs and Patents Act 1988 no ex-tract may be reproduced, stored in a retrieval sys

43、tem or transmitted in anyform or by any means electronic, photocopying, recording or otherwise without prior written permission from BSI. This does not preclude the freeuse, in the course of implementing the standard of necessary details such assymbols, and size, type or grade designations. If these details are to be usedfor any other purpose than implementation then the prior written permissionof BSI must be obtained. Details and advice can be obtained from the Copy-right & Licensing Manager.Tel: +44 (0)20 8996 7070Email: