ETSI EG 201 730-4-2006 Terminals- access to Public Telecommunications Networks Application of the Directive 1999 5 EC (R&TTE) article 4 2 Guidelines for the publication of interfac.pdf

1、 ETSI EG 201 730-4 V2.1.1 (2006-07)ETSI Guide Terminals access to Public Telecommunications Networks;Application of the Directive 1999/5/EC (RGuidelines for the publication of interface specifications;Part 4: Broadband multimedia cable network interfacesETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 2 Refe

2、rence REG/AT-020049 Keywords access, broadband, cable, digital, interface, IP, ISDN, multimedia, POTS, PSTN, terminal, regulation ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but n

3、on lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived dif

4、ference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware

5、that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:

6、/portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2006. All rights reserved. DECTTM,

7、PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTMand the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizati

8、onal Partners. ETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 3 Contents Intellectual Property Rights5 Foreword.5 Introduction 5 1 Scope 7 2 References 7 3 Definitions and abbreviations.8 3.1 Definitions8 3.2 Abbreviations .9 4 Position of the interface9 5 Parameters to be specified10 5.1 Cable Modem-Netwo

9、rk (RF) interface characteristics to be specified.10 5.1.1 Physical characteristics .11 5.1.1.1 Network Termination Point (NTP) .11 5.1.1.2 Connection method .11 5.1.1.3 Connection arrangements11 5.1.1.4 Sizing constraints/dimensioning the installation.11 5.1.2 Electrical or optical characteristics

10、.11 5.1.2.1 Power feed conditions .11 5.1.2.2 Signal characteristics.11 5.1.3 Transmission characteristics .11 5.1.3.1 RF channel transmission characteristics11 5.1.3.2 Frequency plan11 5.1.3.3 Transmission levels.11 5.1.3.4 Frequency conversion .11 5.1.3.5 Synchronization 12 5.1.3.6 Other transmiss

11、ion characteristics.12 5.1.4 Physical layer12 5.1.4.1 Upstream physical media dependent sub-layer .12 5.1.4.2 Downstream physical media dependent sub-layer 12 5.1.4.3 Downstream transmission convergence sub-layer 12 5.1.4.4 Fault isolation impact on services .12 5.1.4.5 Other aspects .12 5.1.5 Data

12、link layer.13 5.1.5.1 Media Access Control.13 5.1.5.2 QoS and fragmentation .13 5.1.5.3 CM interaction with CMTS 13 5.1.5.4 Communication protocols .13 5.1.5.5 Basic coding structure .13 5.1.5.6 Other aspects .13 5.1.6 Network layer .13 5.1.6.1 IGMP management .13 5.1.6.2 Other aspects .13 5.1.7 IP

13、Multimedia time critical services .14 5.1.7.1 Voice services .14 5.1.7.2 Other aspects .14 5.1.8 Additional features14 5.1.8.1 Charging information14 5.1.8.2 “Supplementary“ services and optional user facilities 14 5.1.8.3 Presentation aspects 14 5.1.9 Other aspects and characteristics 14 5.1.9.1 Hi

14、gher Network Layers.14 5.1.9.2 Coexistence with other services 14 5.1.9.3 Downloading new Operating Software .15 ETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 4 5.1.9.4 Protocol elements and procedures for signalling.15 5.2 Cable Modem-User interface characteristics to be specified15 Annex A (informative)

15、: List of most useful standards 16 A.1 General .16 A.2 RF and basic signal aspects16 A.3 Communications protocols.16 A.4 Additional documents.16 Annex B (informative): Bibliography.17 History 18 ETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 5 Intellectual Property Rights IPRs essential or potentially esse

16、ntial to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notif

17、ied to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can

18、 be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This ETSI Guide (EG) has been produced by ETSI Technical Committee Access and Terminals (AT). The pre

19、sent document is part 4 of a multi-part deliverable covering Terminals access to Public Telecommunications Networks; Application of the Directive 1999/5/EC (R Guidelines for the publication of interface specifications, as identified below: Part 1: “General and common aspects“; Part 2: “Analogue narr

20、ow-band wireline interfaces“; Part 3: “Digital wireline interfaces“; Part 4: “Broadband multimedia cable network interfaces“. Introduction The Radio Equipment and Telecommunications Terminal Equipment (R Application of the Directive 1999/5/EC (R Guidelines for the publication of interface specificat

21、ions Later new parts may be created and this will be reflected in the present document. The present document was produced in the context of the integration of all ETSI deliverables published with the aim of facilitating the application of the R Broadband access to the Public Telecommunications Netwo

22、rk; Publication of interface specification under Directive 1999/5/EC, art. 4.2; Guidelines for describing Multimedia Cable Network Interfaces“. NOTE: A more complete introductory text is offered in EG 201 730-1 4. ETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 7 1 Scope The purpose of the present document

23、is to assist the Public Network Operators and Public Service Providers sharing the Telecommunications physical support with Broadcast systems based on cable technologies in producing publications that describe their public interfaces in accordance with article 4.2 of the Radio Equipment and Telecomm

24、unications Terminal Equipment (R Application of the Directive 1999/5/EC (R Guidelines for the publication of interface specifications; Part 1: General and common aspects“. ETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 8 3 Definitions and abbreviations 3.1 Definitions For the purposes of the present docume

25、nt, the terms and definitions given in EG 201 730-1 4 and the following apply: Cable Modem Termination System (CMTS): located at the cable television system headend or distribution hub, which provides complementary functionality to the cable modems to enable data connectivity to wide-area network se

26、rvices Cable Modem Termination System - Network Side Interface (CMTS-NSI): interface, between a CMTS and the equipment on the access network side direct access: access for TE to services provided by a PNO or PSP exclusively via the infrastructure of that PNO or PSP Distribution Hub: location in a ca

27、ble television network which performs the functions of a Headend for customers in its immediate area, and which receives some or all of its television program material from a Master Headend in the same metropolitan or regional area headend: central location on the cable network that is responsible f

28、or injecting broadcast video and other signals in the downstream direction NOTE: See also Master Headend, Distribution Hub. indirect access: access for TE to services provided by a PNO or PSP via the infrastructure of another PNO or PSP master headend: headend which collects television program mater

29、ial from various sources by satellite, microwave, fibre and other means, and distributes this material to Distribution Hubs in the same metropolitan or regional area NOTE: A Master Headend may also perform the functions of a Distribution Hub for customers in its own immediate area. Network Equipment

30、 (NE): equipment forming the Public Operators Network up to and including NTP, relevant for the provision of Telecommunications services Open Systems Interconnection (OSI): framework of ISO standards for communication between different systems made by different vendors, in which the communications p

31、rocess is organized into seven different categories that are placed in a layered sequence based on their relationship to the user NOTE: Each layer uses the layer immediately below it and provides a service to the layer above. Layers 7 through 4 deal with end-to-end communication between the message

32、source and destination, and layers 3 through 1 deal with network functions. Public Telecommunications Network (PTN): Telecommunications Network used to provide publicly available Telecommunications Services Radio Frequency (RF): in cable television systems, this refers to electromagnetic signals in

33、the range 5 MHz to 1 000 MHz Telecommunication Terminal Equipment (TE): according to R in accordance with Article 17 of Directive 2002/21/EC“. ETSI TS 101 909 (series): “Digital Broadband Cable Access to the Public Telecommunications Network; IP Multimedia Time Critical Services“. ETSI TR 102 083: “

34、Human Factors (HF); Supplementary service codes for use in public network services“. ETSI EG 201 973 (series): “Access and Terminals (AT); Public Switched Telephone Network; Support of legacy terminals by Broadband IP networks and equipment“. ETSI ES 201 488 (series): “Access and Terminals (AT); Dat

35、a Over Cable Systems“. ETSI ES 202 488 (series): “Access and Terminals (AT); Second Generation Transmission Systems for Interactive Cable Television Services - IP Cable Modems“. ETSI ES 200 800: “Digital Video Broadcasting (DVB); DVB interaction channel for Cable TV distribution systems (CATV)“. ETS

36、I TR 101 857: “Access and Terminals (AT); Broadband access to the Public Telecommunications Network; Publication of interface specification under Directive 1999/5/EC, art. 4.2; Guidelines for describing Multimedia Cable Network Interfaces“. ETSI TR 102 083: “Human Factors (HF); Supplementary service codes for use in public network services“. ETSI ETSI EG 201 730-4 V2.1.1 (2006-07) 18History Document history V1.1.1 January 2000 Publication as TR 101 730 V2.1.1 May 2006 Membership Approval Procedure MV 20060707: 2006-05-09 to 2006-07-07 V2.1.1 July 2006 Publication