ETSI EN 300 113-2-2011 Electromagnetic compatibility and Radio spectrum Matters (ERM) Land mobile service Radio equipment intended for the transmission of data (and or speech) usin_1.pdf

1、 ETSI EN 300 113-2 V1.5.1 (2011-11) Electromagnetic compatibility and Radio spectrum Matters (ERM); Land mobile service; Radio equipment intended for the transmission of data (and/or speech) using constant or non-constant envelope modulation and having an antenna connector; Part 2: Harmonized EN cov

2、ering the essential requirements of article 3.2 of the R Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/ipr.etsi.org). Pursuant to the ETSI IPR Policy,

3、no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Harmoniz

4、ed European Standard (EN) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM). The present document has been produced by ETSI in response to a mandate from the European Commission issued under Council Directive 98/34/EC i.2 as amended by Direc

5、tive 98/48/EC i.5. The title and reference to the present document are intended to be included in the publication in the Official Journal of the European Union of titles and references of Harmonized Standard under the Directive 1999/5/EC i.1. See article 5.1 of Directive 1999/5/EC i.1 for informatio

6、n on presumption of conformity and Harmonised Standards or parts thereof the references of which have been published in the Official Journal of the European Union. The requirements relevant to Directive 1999/5/EC i.1 are summarised in annex A. The present document is part 2 of a multi-part deliverab

7、le covering the Electromagnetic compatibility and Radio spectrum Matters (ERM); Land mobile service; Radio equipment intended for the transmission of data (and/or speech) using constant or non-constant envelope modulation and having an antenna connector, as identified below: Part 1: “Technical chara

8、cteristics and methods of measurement“; Part 2: “Harmonized EN covering the essential requirements of article 3.2 of the R mobile station (equipment fitted with an antenna connector, normally used in a vehicle or as a transportable); and those hand portable stations: a) fitted with an antenna socket

9、; or b) without an external antenna socket, but fitted with a permanent internal or a temporary internal 50 Radio Frequency (RF) connector which allows access to the transmitter output and the receiver input. Hand portable equipment without an external or internal RF connector and without the possib

10、ility of having a temporary internal 50 RF connector is not covered by the present document. The present document is intended to cover the provisions of article 3.2 of Directive 1999/5/EC i.1 (R Land mobile service; Radio equipment intended for the transmission of data (and/or speech) using constant

11、 or non-constant envelope modulation and having an antenna connector; Part 1: Technical characteristics and methods of measurement“. 2.2 Informative references The following referenced documents are not necessary for the application of the present document but they assist the user with regard to a p

12、articular subject area. i.1 Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity (R A guide to the production of Harmonized Standards for application under the R U

13、ncertainties in the measurement of mobile radio equipment characteristics“. i.5 Directive 98/48/EC of the European Parliament and of the Council of 20 July 1998 amending Directive 98/34/EC laying down a procedure for the provision of information in the field of technical standards and regulations. 3

14、 Definitions, symbols and abbreviations 3.1 Definitions For the purposes of the present document, the terms and definitions given in the R ETSI ETSI EN 300 113-2 V1.5.1 (2011-11) 13 the value of the measurement uncertainty for the measurement of each parameter shall be included in the test report; t

15、he value of the measurement uncertainty shall be, for each measurement, equal to or lower than the figures given in clause 10 (table 11) in EN 300 113-1 1. For the test methods, according to the present document, the measurement uncertainty figures shall be calculated in accordance with TR 100 028 i

16、.4 and shall correspond to an expansion factor (coverage factor) k = 1,96 or k = 2 (which provide confidence levels of respectively 95 % and 95,45 % in the case where the distributions characterizing the actual measurement uncertainties are normal (Gaussian). The particular expansion factor used for

17、 the evaluation of the measurement uncertainty shall be stated. 5.3 Essential radio test suites Essential test suites are referred to in annex III of R it provides a statement of all the test procedures corresponding to those requirements by cross reference to (a) specific clause(s) in the present d

18、ocument or to (a) specific clause(s) in (a) specific referenced document(s); it qualifies each requirement to be either: - Unconditional: meaning that the requirement applies in all circumstances; or - Conditional: meaning that the requirement is dependant on the manufacturer having chosen to suppor

19、t optional functionality defined within the schedule. in the case of Conditional requirements, it associates the requirement with the particular optional service or functionality; it qualifies each test procedure to be either: - Essential: meaning that it is included with the Essential Radio Test Su

20、ite and therefore the requirement shall be demonstrated to be met in accordance with the referenced procedures; - Other: meaning that the test procedure is illustrative but other means of demonstrating compliance with the requirement are permitted. Table A.1: HS Requirements and conformance Test spe

21、cifications Table (HS-RTT) Harmonized Standard EN 300 113-2 The following requirements and test specifications are relevant to the presumption of conformity under the article 3.2 of the R those designated “O“ make up the Other Test Suite; for those designated “X“ there is no test specified correspon

22、ding to the requirement. The completion of all tests classified “E“ as specified with satisfactory outcomes is a necessary condition for a presumption of conformity. Compliance with requirements associated with tests classified “O“ or “X“ is a necessary condition for presumption of conformity, altho

23、ugh conformance with the requirement may be claimed by an equivalent test or by manufacturers assertion supported by appropriate entries in the technical construction file. Clause Number Identification of clause(s) defining the test specification in the present document unless another document is re

24、ferenced explicitly Where no test is specified (that is, where the previous field is “X“) this field remains blank. ETSI ETSI EN 300 113-2 V1.5.1 (2011-11) 17Annex B (informative): The EN title in the official languages The enlargement of the European Union (EU) resulted in a requirement from the EU

25、 for a larger number of languages for the translation of the titles of Harmonized Standards and mandated ENs that are to be listed in the Official Journal to support the implementation of this legislation. For this reason the title translation concerning the present document can be consulted via the

26、 e-approval application. ETSI ETSI EN 300 113-2 V1.5.1 (2011-11) 18Annex C (informative): Bibliography Directive 2004/108/EC of the European Parliament and of the Council of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility and repealing

27、 Directive 89/336/EEC (EMC Directive). Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits (LV Directive). ETSI ETSI EN 300 113-2 V1.5.

28、1 (2011-11) 19History Document history V1.1.1 March 2001 Publication V1.2.1 April 2002 Publication V1.3.1 December 2003 Publication V1.4.1 July 2007 Publication V1.4.2 November 2009 Publication V1.5.1 May 2011 Public Enquiry PE 20110903: 2011-05-06 to 2011-09-05 V1.5.1 September 2011 Vote V 20111120: 2011-09-21 to 2011-11-21 V1.5.1 November 2011 Publication