ETSI ES 202 488-1-2003 Access and Terminals (AT) Second Generation Transmission Systems for Interactive Cable Television Services - IP Cable Modems Part 1 General (V1 1 1)《接入和终端(AT_1.pdf

1、 ETSI ES 202 488-1 V1.1.1 (2003-09)ETSI Standard Access and Terminals (AT);Second Generation Transmission Systems for InteractiveCable Television Services - IP Cable Modems;Part 1: GeneralETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 2 Reference DES/AT-020043-01 Keywords access, broadband, cable, data, IP

2、, IPcable, modem ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the prese

3、nt document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case o

4、f dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and o

5、ther ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: editoretsi.org Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction ext

6、end to reproduction in all media. European Telecommunications Standards Institute 2003. All rights reserved. DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTMand the TIPHON logo are Trade Marks currently being registered by ETSI for the benefi

7、t of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. ETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 3 Contents Intellectual Property Rights4 Foreword.4 1 Scope 5 2 References 5 3 Definitions and abbreviations.5 3.1 Definitions5

8、3.2 Abbreviations .5 4 Overview of the multi-part ETSI standard .6 4.1 Part 1: General6 4.2 Part 2: Radio frequency interface specification6 4.3 Part 3: Baseline privacy plus interface specification6 Annex A (informative): Bibliography.7 History 8 ETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 4 Intellectu

9、al Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (I

10、PRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR sea

11、rches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document Foreword This ETSI Standard (ES) has been produced by ETSI

12、 Technical Committee Access and Terminals (AT). The present document is part 1 of a multi-part deliverable covering Second Generation Transmission Systems for Interactive Television Services - IP Cable modems, as identified below: Part 1: “General“; Part 2: “Radio frequency interface specification“;

13、 Part 3: “Baseline privacy plus interface specification“. ETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 5 1 Scope The present document is a listing of the parts comprising ES 202 488. 2 References The following documents contain provisions which, through reference in this text, constitute provisions of th

14、e present document. References are either specific (identified by date of publication and/or edition number or version number) or non-specific. For a specific reference, subsequent revisions do not apply. For a non-specific reference, the latest version applies. Referenced documents which are not fo

15、und to be publicly available in the expected location might be found at http:/docbox.etsi.org/Reference. 1 ETSI ES 202 488-2: “Access and Terminals (AT); Second Generation Transmission Systems for Interactive Cable Television Services - IP Cable Modems; Part 2: Radio frequency interface specificatio

16、n“. 2 ETSI ES 202 488-3: “Access and Terminals (AT); Second Generation Transmission Systems for Interactive Cable Television Services - IP Cable Modems; Part 3: Baseline privacy plus interface specification“. 3 Definitions and abbreviations 3.1 Definitions For the purposes of the present document, t

17、he following terms and definitions apply: access node: layer two termination device that terminates the network end of a Second Generation IP Cable Modem System NOTE: It is also called an INA or a CMTS. cable modem: layer two termination device that terminates the customer end of a Second Generation

18、 IP Cable Modem System IPCablecom: ETSI deliverables including an architecture and a series of specifications that enable the delivery of real time services (such as telephony) over the cable television networks using cable modems 3.2 Abbreviations For the purposes of the present document, the follo

19、wing abbreviations apply: BPI+ Baseline Privacy Plus Interface CM Cable Modem CMTS Cable Modem Termination System DOCS Data-Over-Cable System HFC Hybrid Fibre Coax INA Interactive Network Adapter IP Internet Protocol MAC Media Access Control ETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 6 QoS Quality of S

20、ervice 4 Overview of the multi-part ETSI standard 4.1 Part 1: General The present document. 4.2 Part 2: Radio frequency interface specification ES 202 488-2 1 defines the radio-frequency interface specifications for high-speed second generation IP cable modem systems. The intended service will allow

21、 transparent bi-directional transfer of Internet Protocol (IP) traffic, between the cable system headend and customer locations, over an all-coaxial or Hybrid-Fibre/Coax (HFC) cable network. The transmission path over the cable system is realized at the headend by a Cable Modem Termination System (C

22、MTS), and at each customer location by a Cable Modem (CM). There are differences in the cable spectrum planning practices adopted for different networks in the world. Therefore two definitions for physical layer technology are included in this specification, which have equal priority and are not req

23、uired to be inter-operable. One technology definition is based on the downstream multi-programme television distribution that is deployed using 6 MHz channelling, and supports upstream transmission in the region 5 MHz to 42 MHz. The other technology definition is based on the corresponding downstrea

24、m multi-programme television distribution that is deployed using 8 MHz channelling, and supports upstream transmission in the region 5 MHz to 65 MHz. It is the network operators choice of which technology definition to deploy. 4.3 Part 3: Baseline privacy plus interface specification ES 202 488-3 2,

25、 the Baseline Privacy Plus Interface (BPI+), describes MAC layer security services for Second Generation IP Cable Modem Systems CMTS-CM communications. BPI+ security goals are twofold: provide cable modem users with data privacy across the cable network, and provide MSOs with service protection; i.e

26、. prevent unauthorized users from gaining access to the networks RF MAC services. BPI+ provides a level of data privacy across the shared medium cable network equal to or better than that provided by dedicated line network access services (analogue modems or digital subscriber lines). The protected

27、radio frequency MAC data communications services fall into three categories: best-effort, high-speed, IP data services; QoS (e.g. constant bit rate) data services; and IP multicast group services. ETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 7 Annex A (informative): Bibliography ETSI ES 201 488-1: “Acces

28、s and Terminals (AT); Data Over Cable Systems; Part 1: General“. ETSI ES 201 488-2: “Access and Terminals (AT); Data Over Cable Systems; Part 2: Radio Frequency Interface Specification“. ETSI ES 201 488-3: “Access and Terminals (AT); Data Over Cable Systems; Part 3: Baseline Privacy Plus Interface S

29、pecification“. ITU-T Recommendation J.122 (2002): “Second generation transmission systems for interactive cable television services - IP cable modems“. ETSI ETSI ES 202 488-1 V1.1.1 (2003-09) 8 History Document history V1.1.1 June 2003 Membership Approval Procedure MV 20030822: 2003-06-24 to 2003-08-22 V1.1.1 September 2003 Publication