ETSI GSM 09 03-1996 Digital Cellular Telecommunications System Signalling Requirements on Interworking between the Integrated Services Digital Network (ISDN) or Public Switched Tel.pdf

1、GSM ic GSM 09.03 December 1996 Version 5.0.0 Source: ETSI TC-SMG Reference: TS/SMG-O30903Q ICs: 33.020 Key words: Digital cellular telecommunications system, Global System for Mobile communications (GSM) GLOBAL SYSTEM FOR MOBILE COMMUNICATIONS Digital cellular telecommunications system; Signalling r

2、equirements on interworking between the Integrated Services Digital Network (ISDN) or Public Switched Telephone Network (PSTN) and the Public Land Mobile Network (PLMN) (GSM 09.03) ETSI European Telecommunications Standards Institute ETSI Secretariat Postal address: F-O6921 Sophia Antipolis CEDEX -

3、FRANCE Office address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE X.400: c=fr, a=atlas, p=etsi, s=secretariat - Internet: secretariatOetsi.fr Tel.: +33 4 92 94 42 O0 - Fax: +33 4 93 65 47 16 Copyright Notification: No part may be reproduced except as authorized by written permissi

4、on. The copyright and the foregoing restriction extend to reproduction in all media. O European Telecommunications Standards Institute 1996. All rights resewed. STDmETSI GSM 07.03-ENGL L77b M 3400855 OL532Lb L4T Page 2 GSM 09.03 version 5.0.0: December 1996 Whilst every care has been taken in the pr

5、eparation and publication of this document, errors in content, typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to “ETSI Editing and Committee Support Dept.“ at the address shown on the title page. STD-ETSI GSM 09.03-ENGL L99b 3q00855 0153217 O8b Page

6、 3 GSM 09.03 version 5.0.0: December 1996 Contents Foreword . 5 1 Scope 7 2 Normative references 7 3 Abbreviations . 8 4 General signalling requirements 8 4.1 Requirements for the mobile network 8 5 Impact of the off-air call Set-up (OACSU) on the interworking 9 5.1 Definition of OACSU 9 5.2 Outgoin

7、g call from a mobile station . 9 5.3 Incoming call to a mobile station 9 History 10 STD-ETSI GSM 07*03-ENGL L99b 3q00855 CIL53218 TL2 Page 4 GSM 09.03 version 5.0.0: December 1996 Blank page STD-ETSI GSM 07*03-ENGL L77b m 3400855 OL532L7 757 m Page 5 GSM 09.03 version 5.0.0: December 1996 Foreword T

8、his Global System for Mobile communications Technical Specification (GTS) has been produced by the Special Mobile Group (SMG) Technical Committee (TC) of the European Telecommunications Standards Institute (ETSI). This GTS defines the signalling aspects of the interworking within the digital cellula

9、r telecommunications system. The contents of this GTS are subject to continuing work within TC-SMG and may change following formal TC-SMG approval. Should TC-SMG modify the contents of this GTS it will then be republished by ETSI with an identifying change of release date and an increase in version

10、number as follows: Version 5.x.y where: y the third digit is incremented when editorial only changes have been incorporated in the specification; x the second digit is incremented for all other types of changes, .e. technical enhancements, corrections, updates, etc. The specification from which this

11、 GTS has been derived was originally based on CEPT documentation, hence the presentation of this GTS may not be entirely in accordance with the ETSVPNE rules. STDSETSI GSM 07-03-ENGL L97b 3400855 0353220 b70 Page 6 GSM 09.3 version 5.0.0: December 1996 Blank page STDnETSI GSM 09-03-ENGL 177b 3LiOU85

12、5 0153221 507 Page 7 GSM 09.03 version 5.0.0: December 1996 1 Scope The purpose of this Global System for Mobile communications Technical Specification (GTS) is to present the general requirements for the Public Switched Telephone Network (PSTN) and the Integrated Services Digital Network (ISDN) as

13、well as for the mobile network to be met in order to ensure a correct integration of the mobile service in the fixed network. This technical specification covers only the signalling aspects of the interworking. The service requirements are covered in a specific specification: only the signalling imp

14、acts are dealt with here. 2 Normative references This GTS incorporates by dated and undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments

15、 to or revisions of any of these publications apply to this GTS only when incorporated in it by amendment or revision. For undated references, the latest edition of the publication referred to applies. 11 1 31 141 GSM O1 .O4 (ETR 350): “Digital cellular telecommunications system (Phase 2+); Abbrevia

16、tions and acronyms“. GSM 03.01 : “Digital cellular telecommunications system (Phase 2+); Network functions“. CCIlT Recommendation (2.701 : “Functional description of the message transfer part (MTP) of Signalling System No.7“. CCITT Recommendation (2.702: “Specifications of Signalling System No. 7 -

17、Signalling data link“. 51 CCITT Recommendation (2.703: “Signalling link“. te1 CCIlT Recommendation Q.704: “Signalling network functions and messages“. 71 CCITT Recommendation Q.705: “Signalling network structure“. 191 CCITT Recommendation Q.706: “Message transfer part signalling performance“. CCITT

18、Recommendation Q.707: “Specifications of Signalling System No. 7 - Testing and maintenance“. CCITT Recommendation (2.71 1 : “Functional description of the signalling connection control part“. 111 CCITT Recommendation Q.712: “Definition and function of SCCP messages“. t121 CCITT Recommendation Q.713:

19、 “SCCP formats and codes“. i 31 11 51 CCITT Recommendation Q.714: “Signalling connection control part procedures“. CCITT Recommendation (2.771 : “Specifications of Signalling System N0.7; Functional description of transaction capabilities“. CCITT Recommendation (2.772 (1 988): Specifications of Sign

20、alling System No.7; Transaction capabilities information element definitions“. CCITT Recommendation Q.773 (1 988): “Specifications of Signalling System N0.7; Transaction capabilities formats and encoding“. STD-ETSI GSM 07-03-ENGL L99b 3400855 0153222 443 Page 8 GSM 09.03 version 5.0.0: December 1996

21、 11 71 81 CCIlT Recommendation (2.774 (1 988): “Specifications of Signalling System No.7; Transaction capabilities procedures“. ETS 300 303: “Integrated Services Digital Network (ISDN); ISDN - Global System for Mobile communications (GSM) Public Land Mobile Network (PLMN) signalling interface“. 3 Ab

22、breviations Abbreviations used in this GTS are listed in GSM 01.04. 4 General signalling requirements 4.1 Requirements for the mobile network In order to be integrated in the fixed network the PLMN must comply with the following requirements: The Mobile Application Part (MAP) which supports informat

23、ion exchanges between the nodes of the mobile service uses the facilities of Transactions Capabilities (TC) of Signalling System No. 7 (SS7). Therefore the equipments of the mobile network must comply with the specifications of the interface between TC and the application user. If TC functions are i

24、ntegrated in the mobile network equipments, the latter must comply with the relevant specifications (CCITT Recommendations Q.771 to Q.774). For MAP messages routing purpose, the mobile nodes must provide the Signalling Connection Control Part (SCCP) via TC with an address complying with the relevant

25、 specifications (CCilT Recommendations Q.711 to Q.714). For call Set-up, the Mobile-services Switching Centres (MSCs) must interface with the fixed exchanges. In the detailed interworking specifications, the fixed network signalling considered are the SS7 and its User Parts (Telephone User Part (TUP

26、) or Integrated Services Digital Network User Part (ISUP). The MSCs must comply with the same signalling interface specifications as the fixed exchanges. The Public Land Mobile Network (PLMN) and the signalling on the radio path must provide the information needed to ensure a correct interworking wi

27、th the fixed network. The interworking in the MSCs must occur with a minimum loss of information. The PLMN nodes must interface with the SS7 signalling network. For that, they must comply with the Message Transfer Part (MTP) specifications (CCITT Recommendations (3.701 to Q.707). The signalling inte

28、rface between ISDN and PLMN is described in ETS 300 303. STD*ETSI GSM 07.03-ENGL 177b W 3400655 0353223 38T Page 9 GSM 09.03 version 5.0.0: December 1996 5 Impact of the off-air call set-up (OACSU) on the interworking The use of OACSU in the PLMN has an impact on the interworking with the fixed netw

29、ork. Both outgoing and incoming calls have to be considered: the consequences are not the same. The use of the OACSU procedure is optional and must be limited to national telephone calls only (see GSM 03.01). 5.1 Definition of OACSU To save the radio resources, the radio traffic channel may be alloc

30、ated to the communication only when both calling and called parties are present, .e. at the answer instant. This method called “Off-Air Call Set-up“ (OACSU) has some implication on the interworking with the fixed network. But the consequences are not the same whether the mobile subscriber is the cal

31、ling or the called party. 5.2 Outgoing call from a mobile station Upon initiation of an outgoing call, a traffic channel is allocated to the communication when the called subscribers answer is received in the MSC. In some cases, no idle traffic channel may be available when necessary. Therefore an a

32、ppropriate announcement must be given to the called party when no idle traffic channel is available within a certain intetval upon receipt of the called partys answer. Whenever the announcement is used, it must always be played through in its entirety, even if a traffic channel becomes available bef

33、ore it is completed, except if the called party clears, in which case the call should be cleared forward. If the ADDRESS COMPLETE message (ACM) indicates that there will possibly be no ANSWER message upon the connection of the called party (e.g. ACM without any information), the radio path must be e

34、stablished immediately upon receipt of the ACM. This applies in all cases on receipt of the ADDRESS COMPLETE message in TUP and ISUP (e.g. also in case the value “subscriber free“ is received. Due to interworking constraints coming from the characteristics of the different signalling systems used in

35、 the countries, the OACSU technique should only be used for national calls. 5.3 Incoming call to a mobile station For incoming calls, the impact is not so important, but some rules must be applied in order to limit the influence on the service quality. Concerning the sending instant of the answer me

36、ssage, the normal operating rules apply. If the call is successfully Set-up to the mobile station, the answer message must be sent to the originating exchange only when the traffic channel is established upon recognition of the called party connection. STD-ETSI GSM 07*03-ENGL 177L 3100855 015322q 21b Page 10 GSM 09.03 version 5.0.0: December 1996 December 1996 History Publication of GSM 09.03 version 5.0.0 Document history ISBN 2-7437-1 208-2 Dpt lgal : Dcembre 1996