ETSI TR 103 061-3-2014 Intelligent Transport Systems (ITS) Testing Part 3 Conformance test specifications for Geographical addressing and forwarding for point-to-point and point-to.pdf

1、 ETSI TR 103 061-3 V1.2.1 (2014-04) Intelligent Transport Systems (ITS); Testing; Part 3: Conformance test specifications for Geographical addressing and forwarding for point-to-point and point-to-multipoint communications; GeoNetworking validation report Technical Report ETSI ETSI TR 103 061-3 V1.2

2、.1 (2014-04)2Reference RTR/ITS-00341 Keywords ITS, OTE, testing ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88

3、Important notice The present document can be downloaded from: http:/www.etsi.org The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorizatio

4、n of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be awar

5、e that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: htt

6、p:/portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modifi

7、ed without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2014. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTMand the ETSI logo are Trade Marks of ETSI registered for the benefit of

8、 its Members. 3GPPTM and LTETMare Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. ETSI ETSI TR 103 061-3 V1.2.1 (2014-04)3Contents Intellectual Property Rights 4g3

9、Foreword . 4g3Introduction 4g31 Scope 5g32 References 5g32.1 Normative references . 5g32.1 Informative references 5g33 Abbreviations . 6g34 Validation report 6g34.1 Validation level 6g34.2 Source code evaluation . 6g34.2.1 TTCN-3 version 6g34.2.2 TTCN-3 tools used for compilation 7g34.3 Validation P

10、rocess 7g34.3.1 Test Platforms. 7g34.3.2 SUTs . 7g34.3.3 Validation Status . 8g34.4 Feedback to standardization process 10g34.4.1 Base standard issues 10g34.4.2 Test specification issues 11g34.4.3 Typical SUT issues . 11g3Annex A: Bibliography 12g3History 14g3ETSI ETSI TR 103 061-3 V1.2.1 (2014-04)4

11、Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property

12、 Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/ipr.etsi.org). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches,

13、 has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Report (TR) has been produced by ETSI T

14、echnical Committee Intelligent Transport Systems (ITS). The present document is part 3 of a multi-part deliverable. Full details of the entire series can be found in part 1 i.8. Introduction In response to EC mandate M/453 i.9, ETSI Technical Committee ITS has standardized base and test specificatio

15、ns for ITS protocols. In a next step a prototype TTCN-3 test system was built and validated. The present document and its related TR 103 099 i.5 (Architecture of Conformance Validation Framework), describe the validation and design of the prototype TTCN-3 test system. The action described in the pre

16、sent document has supported the implementation of ITS standards by: Making available validated and standardized test specifications and thus enabling the application of reliable certification schemes. Executing conformance validation framework against real Implementations Under Test (IUTs) from indu

17、stry and thus providing these companies with a conformance assessment of their implementations. During the lifetime of this action, the conformance validation framework was as well provided at ITS Cooperative Mobility Services Interoperability events. Releasing all software as open source and thus a

18、llowing industry to build and run their own conformance validation framework. ETSI ETSI TR 103 061-3 V1.2.1 (2014-04)51 Scope The present document is the validation report of the GeoNetworking conformance tests defined in TS 102 871-3 i.2 derived from EN 302 636-4-1 (V1.2.0) i.1. It provides statist

19、ics of executed and validated GeoNetworking conformance tests. The information provided has been produced by validation against at least two prototype implementations from industry. 2 References References are either specific (identified by date of publication and/or edition number or version number

20、) or non-specific. For specific references, only the cited version applies. For non-specific references, the latest version of the reference document (including any amendments) applies. Referenced documents which are not found to be publicly available in the expected location might be found at http:

21、/docbox.etsi.org/Reference. NOTE: While any hyperlinks included in this clause were valid at the time of publication, ETSI cannot guarantee their long term validity. 2.1 Normative references The following referenced documents are necessary for the application of the present document. Not applicable.

22、 2.1 Informative references The following referenced documents are not necessary for the application of the present document but they assist the user with regard to a particular subject area. i.1 ETSI EN 302 636-4-1 (V1.2.0): “Intelligent Transport Systems (ITS); Vehicular Communications; GeoNetwork

23、ing; Part 4: Geographical addressing and forwarding for point-to-point and point-to-multipoint communications; Sub-part 1: Media-Independent Functionality“. i.2 ETSI TS 102 871-3 (V1.1.1): “Intelligent Transport Systems (ITS); Testing; Conformance test specifications for GeoNetworking ITS-G5; Part 3

24、: Abstract Test Suite (ATS) and Protocol Implementation eXtra Information for Testing (PIXIT)“. i.3 ETSI TS 102 871-3 (V1.2.1): “Intelligent Transport Systems (ITS); Testing; Conformance test specifications for GeoNetworking ITS-G5; Part 3: Abstract Test Suite (ATS) and Protocol Implementation eXtra

25、 Information for Testing (PIXIT)“. i.4 ETSI TS 102 871-2 (V1.1.1): “Intelligent Transport Systems (ITS); Testing; Conformance test specifications for GeoNetworking ITS-G5; Part 2: Test Suite Structure and Test Purposes (TSS Architecture of conformance validation framework“. i.6 ETSI EG 201 015 (V1.1

26、.1): “Methods for Testing and Specification (MTS); Specification of protocols and services; Validation methodology for standards using SDL; Handbook“. i.7 ETSI ES 201 873-1 (V4.5.1): “Methods for Testing and Specification (MTS); The Testing and Test Control Notation version 3; Part 1: TTCN-3 Core La

27、nguage“. i.8 ETSI TR 103 061-1: “Intelligent Transport Systems (ITS); Testing; Part 1: Conformance test specifications for Co-operative Awareness Messages (CAM); CAM validation report“. ETSI ETSI TR 103 061-3 V1.2.1 (2014-04)6i.9 EC mandate M/453: “Standardisation mandate addressed to CEN, CENELEC a

28、nd ETSI in the field of Information and Communication Technologies to support the interoperability of co-operative Systems for Intelligent Transport in the European Community“. 3 Abbreviations For the purposes of the present document, the following abbreviations apply: ASN.1 Abstract Syntax Notation

29、 One ATS Abstract Test Suite CAM Co-operative Awareness Message CBF Contention Based Forwarding DENM Decentralized Environmental Notification Messages basic service DEPV Destination Position Vector EC European Commission GAC Geographically-scoped AnyCast GN GeoNetworking ITS Intelligent Transportat

30、Systems IUT Implementation Under Test LS Location Service PICS Protocol Implementation Conformance Statement SCF Store Carry the complete suite of tests has been implemented and executed on more than one test platform; the complete suite of tests has been executed against SUTs from a range of differ

31、ent suppliers; the operation and output traces of all the tests have been validated. 4.2 Source code evaluation 4.2.1 TTCN-3 version The GeoNetworking abstract test suite is based on ES 201 873-1 (V4.5.1) i.7. ETSI ETSI TR 103 061-3 V1.2.1 (2014-04)74.2.2 TTCN-3 tools used for compilation The test s

32、uite has been compiled using two different TTCN-3 tools, as detailed in table 1. Table 1: TTCN-3 tools used for compilation Supplier Tool name Version Settings Compilation result TestingTech TTworkbench 1.1.16 Support for very large integers ASN.1-Language-Support-v1.1.4 No error, no warning ElviorT

33、MTestCast T3TM6.7.2.1 No error, no warning NOTE: This information is given for the convenience of users of the present document and does not constitute an endorsement by ETSI of these products. 4.3 Validation Process 4.3.1 Test Platforms The validation test platform has been built as described in co

34、nformance validation framework TR 103 099 i.5 using the components as described in table 2. Table 2: Validation test platform components TTCN-3 Tool TestingTech TTworkbench v17 with ASN.1 support plugin Test Adapter The applicable software tag is: http:/forge.etsi.org/websvn/listing.php?repname=ITS.

35、ITS Vehicular communications; GeoNetworking; Part 4: Geographical addressing and forwarding for point-to-point and point-to-multipoint communications; Sub-part 1: Media-Independent Functionality“. ETSI TS 102 869-1 (V1.1.1): “Intelligent Transport Systems (ITS); Testing; Conformance test specificati

36、on for Decentralized Environmental Notification Messages (DENM); Part 1: Test requirements and Protocol Implementation Conformance Statement (PICS) proforma“. ETSI TS 102 869-2 (V1.1.1): “Intelligent Transport Systems (ITS); Testing; Conformance test specification for Decentralized Environmental Not

37、ification Messages (DENM); Part 2: Test Suite Structure and Test Purposes (TSS Testing; Conformance test specification for Decentralized Environmental Notification Messages (DENM); Part 3: Abstract Test Suite (ATS) and Protocol Implementation eXtra Information for Testing (PIXIT)“. ETSI ES 201 873-1

38、 (V4.3.1): “Methods for Testing and Specification (MTS); The Testing and Test Control Notation version 3; Part 1: TTCN-3 Core Language“. ETSI EG 202 798 (V1.1.1): “Intelligent Transport Systems (ITS); Testing; Framework for conformance and interoperability testing“. ETSI ETSI TR 103 061-3 V1.2.1 (20

39、14-04)13List of tables Table 1: TTCN-3 tools used for compilation . 7g3Table 2: Validation test platform components . 7g3Table 3: SUTs used for validation 7g3Table 4: Testcase validation status . 8g3ETSI ETSI TR 103 061-3 V1.2.1 (2014-04)14History Document history V1.1.1 November 2012 Publication V1.2.1 April 2014 Publication