ETSI TR 105 174-2-1-2009 Access Terminals Transmission and Multiplexing (ATTM) Broadband Deployment - Energy Efficiency and Key Performance Indicators Part 2 Network sites Sub-part_1.pdf

1、 ETSI TR 105 174-2-1 V1.1.1 (2009-10)Technical Report Access, Terminals,Transmission and Multiplexing (ATTM); Broadband Deployment - Energy Efficiency and Key Performance Indicators; Part 2: Network sites; Sub-part 1: Operator sites ETSI ETSI TR 105 174-2-1 V1.1.1 (2009-10) 2Reference DTS/ATTM-02005

2、-1-2 Keywords access, cable, optical, site engineering ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important

3、 notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Por

4、table Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Informati

5、on on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:/portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part m

6、ay be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2009. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the ETSI logo are Trade

7、Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. LTE is a Trade Mark of ETSI currently being registered for the benefit of its Members and of the 3GPP Organizational Partners. GS

8、M and the GSM logo are Trade Marks registered and owned by the GSM Association. ETSI ETSI TR 105 174-2-1 V1.1.1 (2009-10) 3Contents Intellectual Property Rights 4g3Foreword . 4g3Introduction 4g31 Scope 5g32 References 5g32.1 Normative references . 5g32.2 Informative references 6g33 Definitions and a

9、bbreviations . 6g33.1 Definitions 6g33.2 Abbreviations . 6g34 Overview of operator sites . 7g35 Energy efficiency in areas containing network telecommunications equipment . 8g36 Energy efficiency in areas containing information technology equipment 8g3History 10g3ETSI ETSI TR 105 174-2-1 V1.1.1 (200

10、9-10) 4Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual P

11、roperty Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation,

12、including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Report (TR) has

13、been produced by ETSI Technical Committee Access, Terminals, Transmission and Multiplexing (ATTM). The present document is part 2-1 of a multi-part deliverable. Full details of the entire series can be found in part 1 i.3. Introduction The increasing interaction between the different elements of the

14、 Information Communication Technology (ICT) sector (hardware, middleware, software and services) supports the concept of convergence in which: multi-service packages can be delivered over a common infrastructure; a variety of infrastructures is able to deliver these packages; a single multi-service-

15、package may be delivered over different infrastructures. As a result of this convergence, the development of new services, applications and content has resulted in an increased demand for bandwidth, reliability, quality and performance, with a consequent increase in the demand for power which has im

16、plications for cost and, in some cases, availability. It is therefore important to maximize the energy efficiency of all the network elements necessary to deliver the required services. New technologies and infrastructure strategies are expected to enable operators to decrease the energy consumption

17、, for a given level of service, of their existing and future infrastructures thus decreasing their costs. This requires a common understanding among market participants that only standards can produce. The present document is part 2-1 of a multi-part deliverable which has been produced by ETSI Techn

18、ical Committee Access, Terminals, Transmission and Multiplexing (ATTM) in close collaboration with CENELEC via the Co-ordination Group on Installations and Cabling (CGIC). It offers a contribution to the required standardization process by establishing an initial basis for work on ICT networks and t

19、ransmission engineering, with active collaboration from a number of other ETSI and CENELEC Technical Bodies. When complete, the multi-part deliverable contains information that has been jointly evolved to present developments in installations and transmission implementation, and describing their pro

20、gress towards energy efficiency in Next Generation Networks (NGN). In order to monitor the implementation and operation of energy efficient broadband deployment, the present document also discusses Key Performance Indicators (KPI) for energy efficiency and focus on the possible consequences of stand

21、ardization of installations, cabling techniques and equipment. In particular, the study will investigate possibilities and suggest solutions for development of processes for optimization in installation techniques and energy consumption. ETSI ETSI TR 105 174-2-1 V1.1.1 (2009-10) 51 Scope The present

22、 document details measures which may be taken to improve the energy efficiency within operators sites for broadband deployment. Clauses 2 and 3 contain references, definitions and abbreviations which relate to this part; similar information will be included in the corresponding clauses of the other

23、parts, thus ensuring that each document can be used on a “stand-alone“ basis. Within the present document: clause 4 introduces operator sites concepts; clause 5 details the approaches that may be employed to improve energy efficiency within the areas of the operator site containing network telecommu

24、nications equipment; clause 6 details the approaches that may be employed to improve energy efficiency within the areas of the operator site containing information telecommunications equipment. This will enable the proper implementation of services, applications and content on an energy efficient in

25、frastructure, though it is not the goal of this multi-part deliverable to provide detailed standardized solutions for network architecture. The present document focuses on energy efficiency. The CO2footprint is not taken in account in the present document. 2 References References are either specific

26、 (identified by date of publication and/or edition number or version number) or non-specific. For a specific reference, subsequent revisions do not apply. Non-specific reference may be made only to a complete document or a part thereof and only in the following cases: - if it is accepted that it wil

27、l be possible to use all future changes of the referenced document for the purposes of the referring document; - for informative references. Referenced documents which are not found to be publicly available in the expected location might be found at http:/docbox.etsi.org/Reference. NOTE: While any h

28、yperlinks included in this clause were valid at the time of publication ETSI cannot guarantee their long term validity. 2.1 Normative references The following referenced documents are indispensable for the application of the present document. For dated references, only the edition cited applies. For

29、 non-specific references, the latest edition of the referenced document (including any amendments) applies. Not applicable. ETSI ETSI TR 105 174-2-1 V1.1.1 (2009-10) 62.2 Informative references The following referenced documents are not essential to the use of the present document but they assist th

30、e user with regard to a particular subject area. For non-specific references, the latest version of the referenced document (including any amendments) applies. i.1 ETSI EN 300 019-1-3: “Environmental Engineering (EE); Environmental conditions and environmental tests for telecommunications equipment;

31、 Part 1-3: Classification of environmental conditions; Stationary use at weatherprotected locations“. i.2 ETSI TR 102 489: “Environmental Engineering (EE); European telecommunications standard for equipment practice; Thermal Management Guidance for equipment and its deployment“. i.3 ETSI TS 105 174-

32、1: “Access, Terminals, Transmission and Multiplexing (ATTM); Broadband Deployment - Energy Efficiency and Key Performance Indicators; Part 1: Overview, common and generic aspects“. i.4 ETSI TS 105 174-2-2: “Access, Terminals, Transmission and Multiplexing (ATTM); Broadband Deployment - Energy Effici

33、ency and Key Performance Indicators; Part 2: Network sites; Sub-part 2: Data centres“. 3 Definitions and abbreviations 3.1 Definitions For the purposes of the present document, the following terms and definitions apply: data centre: centralized repository for the storage, management, and disseminati

34、on of data and information organized around a particular body of knowledge or pertaining to a particular business energy efficiency: search in existing DC, or for new future DC, of all tracks and actions allowing minimizing energy needs and costs, the key drivers are economic, decreasing the energy

35、bill by increasing the efficiency of all equipment and minimize power loss information technology equipment: equipment such as computers, servers, mainframes, calculators and all storage devices as arrays, libraries, tape robots together with routers and switches within the local area networks netwo

36、rk telecommunications equipment: equipment providing direct connection to core and/or access networks including switches, DSLAM, BTS operator site: premises accommodating network telecommunications equipment providing direct connection to the core and access networks and which may also accommodate i

37、nformation technology equipment 3.2 Abbreviations For the purposes of the present document, the following abbreviations apply: BTS Base Transceiver Station CP Customer Premises DC Data Centre DSLAM Digital Subscriber Line Access Multiplexer ICT Information Communication TechnologyKPI Key Performance

38、 Indicator NGN Next Generation Network OS Operator Site ETSI ETSI TR 105 174-2-1 V1.1.1 (2009-10) 74 Overview of operator sites As shown in figure 1, an operator site is the network sub-system in the core network that enables the connectivity between network data centres and customer premises over w

39、hich the required services can be delivered, using the access network. In turn, operator sites also enable indirect connectivity between customer premises. Operator sites will almost invariably each serve many thousands of customer connections. Each customer connection may be comprised of multiple c

40、ommunication paths and serve a variety of applications. Core network 1OSDCDCDCCore network 2CPCPCPCPCPCPOSOSOSOSOSCustomer premises connected to two operator sitesfor resilienceCustomer premisesconnected to twooperator networksAccess network 1Access network 2Figure 1: Network sub-systems of broadban

41、d deployment An operator site is designed to accommodate, as a primary function, network telecommunications equipment which provides connections via the core network to other operator sites and network data centres and via the access network to customer premises. The operator site may also accommoda

42、te information technology equipment associated with the core and customer network connections. In some cases the operator site may have sufficient information technology equipment to allow it to be considered to be a network data centre as described in TS 105 174-2-2 i.4 but with augmented network t

43、elecommunication connectivity. Historically, operator sites are typically located in urban areas. These buildings and their infrastructure were designed to accommodate network telecommunications equipment which had a considerable lower power requirements lower than the modern network telecommunicati

44、ons equipment that has replaced it. Network telecommunications equipment has also reduced in terms of physical volume allowing the installation of additional network telecommunications and information technology equipment - often from multiple operators and also in support of multiple access network

45、 architectures (such as combined wired and wireless operator sites). The primary power supply to these locations was often not designed for the high levels of energy usage required by the technology now employed. The process of evolution within operator sites rarely allows complete refurbishment due

46、 to the need to maintain service to the access network. Therefore, the opportunity for the significant rebuilding of environmental control or power distribution systems is limited. Hence it is unlikely that the overall energy efficiency of operator sites could ever be made to approach that of purpos

47、e-built complexes housing data centres. As energy costs continue to rise and concerns regarding its availability increase, it will become even more necessary to employ new generation hardware with greater energy efficiency. ETSI ETSI TR 105 174-2-1 V1.1.1 (2009-10) 8The approaches applied to the imp

48、rovement of energy efficiency that are applied to data centres as described in TS 105 174-2-2 i.4 are not expected to be equally applicable to operator sites but may be applied effectively to certain areas within the operator site. Clause 5 reviews the applicability of the approaches applied to the

49、areas allocated to network telecommunications equipment. Clause 6 reviews the applicability of the approaches applied to the areas allocated to information technology equipment. 5 Energy efficiency in areas containing network telecommunications equipment The four principal methods of addressing energy efficiency in network data centres described in TS 105 174-2-2 i.4 address: the information technology infrastructure; the environmental control systems; the physical infrastructure of the buildings; the power distribution system. Within