ETSI TS 102 936-1-2011 eCall Network Access Device (NAD) conformance specification Part 1 Protocol test specification (V1 1 1)《eCall网络接入设备(NAD)一致性规范 第1部分 协议测试规范(版本1 1 1)》.pdf

1、 ETSI TS 102 936-1 V1.1.1 (2011-04)Technical Specification eCall Network Access Device (NAD)conformance specification;Part 1: Protocol test specificationETSI ETSI TS 102 936-1 V1.1.1 (2011-04)2Reference DTS/MSG-00eCall01-1 Keywords cellular, conformance, ecall, emergency, GSM, mobile, testing, UMTS

2、ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the present document can b

3、e downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the re

4、ference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documen

5、ts is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:/portal.etsi.org/chaircor/ETSI_support.asp Copyright Notification No part may be reproduced except as authorized by written permis

6、sion. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2011. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM, the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members

7、. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. LTE is a Trade Mark of ETSI currently being registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned

8、 by the GSM Association. ETSI ETSI TS 102 936-1 V1.1.1 (2011-04)3Contents Intellectual Property Rights 4g3Foreword . 4g3Introduction 4g31 Scope 6g32 References 6g32.1 Normative references . 6g32.2 Informative references 7g33 Definitions and abbreviations . 7g33.1 Definitions 7g33.2 Abbreviations . 7

9、g34 General aspects of eCall conformance testing 7g34.1 Types of eCall capable UE - Unrestricted and Restricted 8g34.2 Establishment of eCalls by the UE under test 8g34.3 Establishment of eCall test and reconfiguration calls . 8g35 UMTS network access eCall NAD conformance tests . 8 g35.1 eCall Emer

10、gency Call Procedures 8g35.1.1 eCall with USIM . 8g35.1.1.1 Void. 9g35.1.1.2 Test call using eCall capable UE with eCall only subscription on USIM . 9g35.1.1.3 Manually initiated eCall using eCall capable UE with eCall only subscription on USIM 9g35.1.1.4 Reconfiguration call using eCall capable UE

11、with eCall only subscription 9g35.1.1.5 Manually initiated eCall using eCall capable UE with eCall and non eCall subscription on USIM . 9g35.1.1.6 eCall Inactivity State after T3242 expires . 9g35.1.1.7 Automatically initiated eCall 9g35.2 Applicability of eCall NAD tests for UMTS network access . 9

12、g36 GSM network access eCall NAD conformance tests . 9g36.1 eCall Emergency Call Procedures 10g36.1.1 eCall with USIM . 10g36.1.1.1 Void. 10g36.1.1.2 Test call using eCall capable MS with eCall only subscription on USIM . 10g36.1.1.3 Manually initiated eCall using eCall capable MS with eCall only su

13、bscription on USIM 10g36.1.1.4 Manually initiated eCall using eCall capable MS with eCall capable USIM 10g36.1.1.5 eCall Inactivity State after T3242 expires . 10g36.1.1.6 Automatically initiated eCall 10g36.1.1.7 Reconfiguration call using eCall capable MS with eCall only subscription 10g36.2 Appli

14、cability of eCall NAD tests for GSM network access . 10g3Annex A (informative): Bibliography . 11g3History 12g3ETSI ETSI TS 102 936-1 V1.1.1 (2011-04)4Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaini

15、ng to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretaria

16、t. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the

17、updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Specification (TS) has been produced by ETSI Technical Committee Mobile Standards Group (MSG). The present document is part 1 of a multi-part deliverable covering eCall Net

18、work Access Device (NAD) conformance specification as identified below: Part 1: “Protocol test specification“; Part 2: “Test suites“. The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or GSM identities. These should be interpreted as b

19、eing references to the corresponding ETSI deliverables. The cross reference between GSM, UMTS, 3GPP and ETSI identities can be found under http:/webapp.etsi.org/key/queryform.asp. Introduction Following a decision of the European Parliament, and a request by the European Commission to ETSI, ETSI TC

20、MSG was tasked with managing the technical specification and creation of open standards for the Pan-European eCall emergency service. An eCall is an emergency voice call, initiated manually or automatically from a vehicle to a Public Safety Answering Point (PSAP), supplemented by up to 140 bytes of

21、incident related data. The Minimum Set of Data (MSD) has been defined by CEN Technical Committee 278 and includes the GNSS derived location and direction of travel of the vehicle, the Vehicle Identification Number (VIN) and other information to enable the emergency response teams to quickly locate a

22、nd provide medical and other life saving assistance to the accident victims. eCall has been designed to operate over any PLMN that supports emergency voice calls, specifically TeleService 12. Should the MSD not be transmitted or received for any reason, or if the PSAP is not equipped with the necess

23、ary eCall equipment (eCall modem / server), the accident victims and PSAP operator may still converse using the In-Vehicle System (IVS) audio equipment. The 3rdGeneration Partnership Project (3GPP) has specified the eCall service requirements, data transmission protocols and network signaling aspect

24、s for Release 8. The in-band modem used to transfer the MSD from the vehicle to the PSAP, following the establishment of a TS12 emergency voice call, has been specified by 3GPP TSG SA WG 4. Once an eCall is invoked, initiated manually by the vehicle occupants or automatically as the result of an acc

25、ident, the eCall call set-up and clear-down procedures (RR, CC, and MM) are automatically controlled by the eCall in-vehicle system (IVS) and its associated network access device (NAD). Once initiated the system requires no MMI intervention and does not permit the user to intervene at any stage duri

26、ng call management. It is important, therefore, that the eCall system works autonomously and reliably when faced with a wide range of probable network access events. ETSI ETSI TS 102 936-1 V1.1.1 (2011-04)5The present document specifies the eCall applicable tests required to ensure eCall NAD conform

27、ance when accessing Digital cellular telecommunications system (Phase 2+) and Universal Mobile Telecommunications System (UMTS) mobile networks. The present document includes references to existing ETSI technical specifications including TS 151 010-1 6 and TS 134 123-1 3 that contain the necessary d

28、etailed eCall and generic UE conformance tests. The eCall in-band modem conformance test protocols are as specified in TS 126 269 2. A guide to the applicability of ETSI GSM and UMTS mobile station harmonised standards EN 301 908 parts 1 8 and 2 9 and EN 301 511 10 to the ETSI specified eCall NAD, f

29、or the purpose of demonstrating compliance with R LTE; Service aspects; Service principles (3GPP TS 22.101)“. 2 ETSI TS 126 269: “Digital cellular telecommunications system (Phase 2+); Universal Mobile Telecommunications System (UMTS); eCall data transfer; In-band modem solution; Conformance testing

30、 (3GPP TS 26.269)“. 3 ETSI TS 134 123-1: “Universal Mobile Telecommunications System (UMTS); User Equipment (UE) conformance specification; Part 1: Protocol conformance specification (3GPP TS 34.123-1)“. 4 ETSI TS 134 123-2: “Universal Mobile Telecommunications System (UMTS); User Equipment (UE) con

31、formance specification; Part 2: Implementation conformance statement (ICS) proforma specification (3GPP TS 34.123-2)“. 5 ETSI TS 134 123-3: “Universal Mobile Telecommunications System (UMTS); User Equipment (UE) conformance specification; Part 3: Abstract Test Suites (ATSs) (3GPP TS 34.123-3)“. 6 ET

32、SI TS 151 010-1: “Digital cellular telecommunications system (Phase 2+); Mobile Station (MS) conformance specification; Part 1: Conformance specification (3GPP TS 51.010-1)“. 7 ETSI TS 151 010-2: “Digital cellular telecommunications system (Phase 2+); Mobile Station (MS) conformance specification; P

33、art 2: Protocol Implementation Conformance Statement (PICS) proforma specification (3GPP TS 51.010-2)“. 8 ETSI EN 301 908-1: “IMT cellular networks; Harmonized EN covering the essential requirements of article 3.2 of the R Part 1: Introduction and common requirements“. 9 ETSI EN 301 908-2: “IMT cell

34、ular networks; Harmonized EN covering the essential requirements of article 3.2 of the R Part 2: CDMA Direct Spread (UTRA FDD) User Equipment (UE)“. 10 ETSI EN 301 511: “Global System for Mobile communications (GSM); Harmonized EN for mobile stations in the GSM 900 and GSM 1800 bands covering essent

35、ial requirements under article 3.2 of the R Guidelines on applicability of GSM and UMTS mobile station harmonized standards to eCall Network Access Device (NAD)“. i.2 Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal

36、equipment and the mutual recognition of their conformity (R Universal Mobile Telecommunications System (UMTS); LTE; Mobile radio interface Layer 3 specification; Core network protocols; Stage 3 (3GPP TS 24.008)“. ETSI TS 127 007: “Digital cellular telecommunications system (Phase 2+); Universal Mobi

37、le Telecommunications System (UMTS); LTE; AT command set for User Equipment (UE) (3GPP TS 27.007)“. ETSI TS 131 102: “Universal Mobile Telecommunications System (UMTS); LTE; Characteristics of the Universal Subscriber Identity Module (USIM) application (3GPP TS 31.102)“. ETSI TS 134 108: “Universal

38、Mobile Telecommunications System (UMTS); LTE; Common test environments for User Equipment (UE); Conformance testing (3GPP TS 34.108)“. ETSI TS 134 109: “Universal Mobile Telecommunications System (UMTS); LTE; Terminal logical test interface; Special conformance testing functions (3GPP TS 34.109)“. ETSI TS 102 936-2: “Mobile systems; eCall Network Access Device (NAD) conformance specification Part 2: Test suites“. ETSI ETSI TS 102 936-1 V1.1.1 (2011-04)12History Document history V1.1.1 April 2011 Publication