ETSI TS 145 015-2017 Digital cellular telecommunications system (Phase 2+) (GSM) GSM EDGE Release independent Downlink Advanced Receiver Performance (DARP) Implementation guideline.pdf

1、 ETSI TS 145 015 V14.0.0 (2017-04) Digital cellular telecommunications system (Phase 2+) (GSM); GSM/EDGE Release independent Downlink Advanced Receiver Performance (DARP); Implementation guidelines (3GPP TS 45.015 version 14.0.0 Release 14) TECHNICAL SPECIFICATION GLOBAL SYSTEM FOR MOBILE COMMUNICAT

2、IONSRETSI ETSI TS 145 015 V14.0.0 (2017-04)13GPP TS 45.015 version 14.0.0 Release 14Reference RTS/TSGR-0645015ve00 Keywords GSM ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non

3、 lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice The present document can be downloaded from: http:/www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of

4、the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific ne

5、twork drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at https:/portal.etsi.org/TB/ETSIDeliverableStatus.aspx If you find err

6、ors in the present document, please send your comment to one of the following services: https:/portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm exc

7、ept as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2017. All rights reserved.

8、 DECTTM, PLUGTESTSTM, UMTSTMand the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE are Trade Marks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the

9、GSM Association. ETSI ETSI TS 145 015 V14.0.0 (2017-04)23GPP TS 45.015 version 14.0.0 Release 14Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly availab

10、le for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server

11、(https:/ipr.etsi.org/). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become,

12、essential to the present document. Foreword This Technical Specification (TS) has been produced by ETSI 3rd Generation Partnership Project (3GPP). The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or GSM identities. These should be int

13、erpreted as being references to the corresponding ETSI deliverables. The cross reference between GSM, UMTS, 3GPP and ETSI identities can be found under http:/webapp.etsi.org/key/queryform.asp. Modal verbs terminology In the present document “shall“, “shall not“, “should“, “should not“, “may“, “need

14、not“, “will“, “will not“, “can“ and “cannot“ are to be interpreted as described in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of provisions). “must“ and “must not“ are NOT allowed in ETSI deliverables except when used in direct citation. ETSI ETSI TS 145 015 V14.0.0 (2017

15、-04)33GPP TS 45.015 version 14.0.0 Release 14Contents Intellectual Property Rights 2g3Foreword . 2g3Modal verbs terminology 2g3Foreword . 4g31 Scope 5g32 References 5g33 Definitions and abbreviations . 5g33.1 Abbreviations . 5g34 Void 5g35 DARP Phase II MS Independent of Release 5g35.1 RF Requiremen

16、ts 6g35.2 Signalling Requirements 6g3Annex A (informative): Change history . 7g3History 8g3ETSI ETSI TS 145 015 V14.0.0 (2017-04)43GPP TS 45.015 version 14.0.0 Release 14Foreword This Technical Specification has been produced by the 3rdGeneration Partnership Project (3GPP). The contents of the prese

17、nt document are subject to continuing work within the TSG and may change following formal TSG approval. Should the TSG modify the contents of the present document, it will be re-released by the TSG with an identifying change of release date and an increase in version number as follows: Version x.y.z

18、 where: x the first digit: 1 presented to TSG for information; 2 presented to TSG for approval; 3 or greater indicates TSG approved document under change control. y the second digit is incremented for all changes of substance, i.e. technical enhancements, corrections, updates, etc. z the third digit

19、 is incremented when editorial only changes have been incorporated in the document. ETSI ETSI TS 145 015 V14.0.0 (2017-04)53GPP TS 45.015 version 14.0.0 Release 141 Scope The present document specifies requirements on MSs supporting Downlink Advanced Receiver Performance (DARP) that are independent

20、of release. TSG GERAN has agreed that the standardisation of DARP be independent of a release. However, in order to implement an MS that conforms to a particular release but supports DARP, which is specified in a later release, it is necessary to specify some extra requirements. DARP - phase II is c

21、ontained in the Release 7 specifications. In order to implement an MS conforming to Release 5 but supporting DARP phase II, it is necessary for the MS to additionally conform to some parts of the Release 7 specifications, such as the radio frequency requirements for DARP and some signalling extensio

22、ns relating to the MS Classmark and radio access capabilities. 2 References The following documents contain provisions which, through reference in this text, constitute provisions of the present document. References are either specific (identified by date of publication, edition number, version numb

23、er, etc.) or non-specific. For a specific reference, subsequent revisions do not apply. For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a non-specific reference implicitly refers to the latest version of that documen

24、t in the same Release as the present document. 1 (void) 2 (void) 3 3GPP TS 45.005: “Radio transmission and reception (Release 7)“. 4 3GPP TS 24.008: “Mobile radio interface Layer 3 specification; Core Network protocols; Stage 3 (Release 7)“. 3 Definitions and abbreviations Unless listed below, all d

25、efinitions and abbreviations used in the present document are listed in documents referenced in clause 2. 3.1 Abbreviations For the purposes of the present document, the following abbreviations apply: DARP Downlink Advanced Receiver Performance SAIC Single Antenna Interference Cancellation, also kno

26、wn as DARP - phase I MSRD Mobile Station Receive Diversity, also known as DARP - phase II 4 Void 5 DARP Phase II MS Independent of Release MSs that conform to Release 5 and support DARP - phase II shall support the following requirements in Release 7. ETSI ETSI TS 145 015 V14.0.0 (2017-04)63GPP TS 4

27、5.015 version 14.0.0 Release 145.1 RF Requirements The MS shall comply with the RF requirements for DARP - phase II specified in 3. These requirements are: Section 6.2: Reference sensitivity level. Section 6.3: Reference interference level. 5.2 Signalling Requirements The MS shall support the follow

28、ing information elements specified in 4: Section 10.5.1.7 Mobile Station Classmark 3, with the following exceptions: - Fields T-GSM 400 Bands Supported / T-GSM 400 Associated Radio Capability, T-GSM 900 Associated Radio Capability, DTM GPRS High Multi Slot Class / Offset required / DTM EGPRS High Mu

29、lti Slot Class, GSM 710 Associated Radio Capability, T-GSM 810 Associated Radio Capability, and Multislot Capability Reduction for Downlink Dual Carrier shall be indicated as not present since they are not defined in Release 5. This is done by setting the related indication bit to 0. - Parameter DTM

30、 Enhancement Capability, Repeated ACCH Capability and Ciphering Mode Setting Capability shall be indicated as not supported since it is not defined in Release 5. This is done by setting the bit value 0 for this parameter. Section 10.5.5.12a MS Radio Access Capability, with the following exceptions:

31、- Fields DTM GPRS High Multi Slot Class / DTM EGPRS High Multi Slot Class, Multislot Capability Reduction for Downlink Dual Carrier, and Downlink Dual Carrier for DTM Capability shall be indicated as not present since they are not defined in Release 5. This is done by setting the related indication

32、bit to 0. - Parameters Multiple TBF Capability, Extended RLC/MAC Control Message Segmentation Capability, DTM Enhancements Capability, PS Handover Capability, and DTM Handover Capability shall be indicated as not supported since they are not defined in Release 5. This is done by setting the bit valu

33、e 0 for each of these parameters. - In addition, for Access Technology Type, the values 1001 through to 1101 shall not be used since GSM T 380, GSM T 410, GSM T 900, GSM 710 and GSM T 810 are not supported in Release 5. NOTE: The lack of one or more of the fields following the Downlink Advanced Rece

34、iver Performance field in Mobile Station Classmark 3 IE or MS Radio Access Capability IE should not be considered as an error by the network. In this case the meaning “not supported“ or “not present“ should be assumed as indicated above. ETSI ETSI TS 145 015 V14.0.0 (2017-04)73GPP TS 45.015 version

35、14.0.0 Release 14Annex A (informative): Change history Change history Date TSG # TSG Doc. CR Rev Subject/Comment Old New 2004-11 22 GP-042854 Version for Release 5 5.0.0 2006-01 28 GP-060330 0004 2 Release independent DARP Implementation guidelines update 5.0.0 5.1.0 2007-05 34 GP-071051 0005 1 Rele

36、ase independent DARP Implementation guidelines update 5.1.0 5.2.0 2007-05 34 GP-07105 0006 1 Release independent DARP Implementation guidelines update 5.2.0 6.1.0 2007-08 35 Version for Release 7 6.1.0 7.0.0 2008-12 40 Version for Release 8 7.0.0 8.0.0 2009-12 44 Version for Release 9 8.0.0 9.0.0 20

37、11-03 49 Version for Release 10 9.0.0 10.0.0 2012-09 55 Version for Release 11 10.0.0 11.0.0 2014-09 63 Version for Release 12 (frozen at SP-65) 11.0.0 12.0.0 2015-12 68 Version for Release 13 (frozen at SP-70) 12.0.0 13.0.0 Change history Date Meeting TDoc CR Rev Cat Subject/Comment New version 2017-03 75 Version for Release 14 (frozen at TSG-75) 14.0.0 ETSI ETSI TS 145 015 V14.0.0 (2017-04)83GPP TS 45.015 version 14.0.0 Release 14History Document history V14.0.0 April 2017 Publication