ETSI TS 155 243-2018 Digital cellular telecommunications system (Phase 2+) (GSM) Specification of the GIA4 integrity algorithm for General Packet Radio Service (GPRS) Design conforo.pdf

1、 ETSI TS 155 243 V15.0.0 (2018-07) Digital cellular telecommunications system (Phase 2+) (GSM); Specification of the GIA4 integrity algorithm for General Packet Radio Service (GPRS); Design conformance test data (3GPP TS 55.243 version 15.0.0 Release 15) TECHNICAL SPECIFICATION GLOBAL SYSTEM FOR MOB

2、ILE COMMUNICATIONSRETSI ETSI TS 155 243 V15.0.0 (2018-07)13GPP TS 55.243 version 15.0.0 Release 15Reference RTS/TSGS-0355243vf00 Keywords GSM,SECURITY ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 74

3、2 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice The present document can be downloaded from: http:/www.etsi.org/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic an

4、d/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in contents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) versio

5、n kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at https:/portal.etsi.org/TB/ETSIDeliverableStat

6、us.aspx If you find errors in the present document, please send your comment to one of the following services: https:/portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photoco

7、pying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyright and the foregoing restriction extend to reproduction in all media. ETSI 2018. All rights reserved. DECTTM, PLUGTESTSTM

8、, UMTSTMand the ETSI logo are trademarks of ETSI registered for the benefit of its Members. 3GPPTM and LTETMare trademarks of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. oneM2M logo is protected for the benefit of its Members. GSMand the GSM logo are trade

9、marks registered and owned by the GSM Association. ETSI ETSI TS 155 243 V15.0.0 (2018-07)23GPP TS 55.243 version 15.0.0 Release 15Intellectual Property Rights Essential patents IPRs essential or potentially essential to normative deliverables may have been declared to ETSI. The information pertainin

10、g to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat

11、. Latest updates are available on the ETSI Web server (https:/ipr.etsi.org/). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the

12、ETSI Web server) which are, or may be, or may become, essential to the present document. Trademarks The present document may include trademarks and/or tradenames which are asserted and/or registered by their owners. ETSI claims no ownership of these except for any which are indicated as being the pr

13、operty of ETSI, and conveys no right to use or reproduce any trademark and/or tradename. Mention of those trademarks in the present document does not constitute an endorsement by ETSI of products, services or organizations associated with those trademarks. Foreword This Technical Specification (TS)

14、has been produced by ETSI 3rd Generation Partnership Project (3GPP). The present document may refer to technical specifications or reports using their 3GPP identities, UMTS identities or GSM identities. These should be interpreted as being references to the corresponding ETSI deliverables. The cross

15、 reference between GSM, UMTS, 3GPP and ETSI identities can be found under http:/webapp.etsi.org/key/queryform.asp. Modal verbs terminology In the present document “shall“, “shall not“, “should“, “should not“, “may“, “need not“, “will“, “will not“, “can“ and “cannot“ are to be interpreted as describe

16、d in clause 3.2 of the ETSI Drafting Rules (Verbal forms for the expression of provisions). “must“ and “must not“ are NOT allowed in ETSI deliverables except when used in direct citation. ETSI ETSI TS 155 243 V15.0.0 (2018-07)33GPP TS 55.243 version 15.0.0 Release 15Contents Intellectual Property Ri

17、ghts 2g3Foreword . 2g3Modal verbs terminology 2g3Foreword . 4g3Introduction 4g31 Scope 5g32 References 5g33 Definitions and abbreviations . 5g33.1 Definitions 5g33.2 Abbreviations . 5g34 Introductory information 5g34.1 Introduction 5g34.2 Notation 5g34.2.1 Radix . 5g34.2.2 Conventions 5g34.2.3 Bit/B

18、yte ordering 6g34.3 List of variables 6g35 Conformance data 7g3Annex A (informative): Change history . 8g3History 9g3ETSI ETSI TS 155 243 V15.0.0 (2018-07)43GPP TS 55.243 version 15.0.0 Release 15Foreword This Technical Specification has been produced by the 3rd Generation Partnership Project (3GPP)

19、. The contents of the present document are subject to continuing work within the TSG and may change following formal TSG approval. Should the TSG modify the contents of the present document, it will be re-released by the TSG with an identifying change of release date and an increase in version numbe

20、r as follows: Version x.y.z where: x the first digit: 1 presented to TSG for information; 2 presented to TSG for approval; 3 or greater indicates TSG approved document under change control. y the second digit is incremented for all changes of substance, i.e. technical enhancements, corrections, upda

21、tes, etc. z the third digit is incremented when editorial only changes have been incorporated in the document. Introduction The present document has been prepared by the 3GPP Task Force, and gives a detailed specification of the 3GPP integrity algorithm GIA4. The present document is the third of thr

22、ee, which between them form the entire specification of the 3GPP Integrity Algorithm GIA4: - 3GPP TS 55.241: “3rd Generation Partnership Project; Technical Specification Group Services and System Aspects; Specification of the GIA4 integrity algorithms for GPRS; GIA4 specification“. - 3GPP TS 55.242:

23、 “3rd Generation Partnership Project; Technical Specification Group Services and System Aspects; Specification of the GIA4 integrity algorithms for GPRS; Implementers test data“. - 3GPP TS 55.243: “3rd Generation Partnership Project; Technical Specification Group Services and System Aspects; Specifi

24、cation of the GIA4 integrity algorithms for GPRS; Design conformance test data“. ETSI ETSI TS 155 243 V15.0.0 (2018-07)53GPP TS 55.243 version 15.0.0 Release 151 Scope The present document defines the Design conformance test data for the 3GPP integrity algorithm GIA4. 2 References The following docu

25、ments contain provisions which, through reference in this text, constitute provisions of the present document. - References are either specific (identified by date of publication, edition number, version number, etc.) or non-specific. - For a specific reference, subsequent revisions do not apply. -

26、For a non-specific reference, the latest version applies. In the case of a reference to a 3GPP document (including a GSM document), a non-specific reference implicitly refers to the latest version of that document in the same Release as the present document. 1 3GPP TR 21.905: “Vocabulary for 3GPP Sp

27、ecifications“. 2 3GPP TS 55.241: “Specification of the GIA4 encryption algorithms for GPRS; GIA4 specification“. 3 Definitions and abbreviations 3.1 Definitions For the purposes of the present document, the terms and definitions given in 3GPP TR 21.905 1 and the following apply. A term defined in th

28、e present document takes precedence over the definition of the same term, if any, in 3GPP TR 21.905 1. 3.2 Abbreviations For the purposes of the present document, the abbreviations given in 3GPP TR 21.905 1 and the following apply. An abbreviation defined in the present document takes precedence ove

29、r the definition of the same abbreviation, if any, in 3GPP TR 21.905 1. 4 Introductory information 4.1 Introduction The integrity algorithm GIA4 computes a 32-bit MAC (Message Authentication Code) of a given input message using integrity key KI128. The approach adopted uses KASUMI 2 in a form of CBC

30、-MAC mode. 4.2 Notation 4.2.1 Radix The prefix “0x“ is used to indicate hexadecimal numbers. 4.2.2 Conventions The assignment operator “=“, is used as in several programming languages. So the following: = ETSI ETSI TS 155 243 V15.0.0 (2018-07)63GPP TS 55.243 version 15.0.0 Release 15means that assum

31、es the value that had before the assignment took place. For instance: x = x + y + 3 means: (new value of x) becomes (old value of x) + (old value of y) + 3. 4.2.3 Bit/Byte ordering All data variables in the present document are presented with the most significant bit (or byte) on the left hand side

32、and the least significant bit (or byte) on the right hand side. Where a variable is broken down into a number of sub-strings, the left most (most significant) sub-string is numbered 0, the next most significant is numbered 1 and so on through to the least significant. For example an n-bit MESSAGE is

33、 subdivided into 64-bit substrings MB0,MB1MBiso for the following message: 0x0123456789ABCDEFFEDCBA987654321086545381AB594FC28786404C50A37 MB0= 0x0123456789ABCDEF MB1= 0xFEDCBA9876543210 MB2= 0x86545381AB594FC2 MB3= 0x8786404C50A37 In binary this would be: 0000000100100011010001010110011110001001101

34、01011110011011110111111111110 with MB0= 0000000100100011010001010110011110001001101010111100110111101111 MB1= 1111111011011100101110101001100001110110010101000011001000010000 MB2= 1000011001010100010100111000000110101011010110010100111111000010 MB3= 10000111100001100100000001001100010100001010001101

35、11 4.3 List of variables A, B are 64-bit registers that are used within the function to hold intermediate values. BLOCKS an integer variable indicating the number of successive applications of KASUMI that need to be performed. CONSTANT-F a 32-bit parameter which is constant for any given FRAMETYPE i

36、nput. DIRECTION a 1-bit input indicating the direction of transmission (uplink or downlink). FRAMETYPE an 8-bit input to the function indicating the type of frame to be protected. INPUT-I a 32-bit time variant input to the function. KI128 the 128-bit integrity key. KM a 128-bit constant that is used

37、 to modify a key. M an input to the function which specifies the number of octets of message to be MACd (1-65536). MAC the 32-bit message authentication code (MAC) produced by the function. MESSAGE the input octet stream of length M octets that is to be processed by the function. PS is the input pad

38、ded string processed by the function. ETSI ETSI TS 155 243 V15.0.0 (2018-07)73GPP TS 55.243 version 15.0.0 Release 155 Conformance data This clause only available under licence. See http:/www.etsi.org/about/what-we-do/security-algorithms-and-codes/cellular-algorithm-licences. ETSI ETSI TS 155 243 V1

39、5.0.0 (2018-07)83GPP TS 55.243 version 15.0.0 Release 15Annex A (informative): Change history Change history Date Meeting TDoc CR Rev Cat Subject/Comment New version 2017-03 SA#75 SP-170089 Presented for approval 2.0.0 2017-03 SA#75 Upgrade to change control version 13.0.0 2017-03 SA#75 - - - Promotion to Release 14 without technical change 14.0.0 2018-06 - - - - - Update to Rel-15 version (MCC) 15.0.0 ETSI ETSI TS 155 243 V15.0.0 (2018-07)93GPP TS 55.243 version 15.0.0 Release 15History Document history V15.0.0 July 2018 Publication