ETSI TS 186 018-1-2008 Telecommunications and Internet converged Services and Protocols for Advanced Networking (TISPAN) PSTN ISDN simulation services Malicious Communication Ident.pdf

1、 ETSI TS 186 018-1 V1.0.0 (2008-06)Technical Specification Telecommunications and Internet converged Services andProtocols for Advanced Networking (TISPAN);PSTN/ISDN simulation services;Malicious Communication Identification (MCID);Part 1: Protocol Implementation ConformanceStatement (PICS)ETSI ETSI

2、 TS 186 018-1 V1.0.0 (2008-06) 2 Reference DTS/TISPAN-06042-1-NGN Keywords IMS, MCID, PICS, testing ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous

3、-Prfecture de Grasse (06) N 7803/88 Important notice Individual copies of the present document can be downloaded from: http:/www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between su

4、ch versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subje

5、ct to revision or change of status. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: http:/portal.etsi.org/chaircor/ETSI

6、_support.asp Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2008. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTM, TIPHONTM,

7、 the TIPHON logo and the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 3 Contents Intellectual Property Rights4 For

8、eword.4 1 Scope 5 2 References 5 2.1 Normative references .5 2.2 Informative references6 3 Definitions and abbreviations.6 3.1 Definitions6 3.2 Abbreviations .6 4 Protocol Implementation Conformance Statement proforma.7 4.1 Instructions for completing the PICS proforma7 4.1.1 More detailed instructi

9、ons are given at the beginning of the different clauses of the PICS proforma7 4.1.1.1 Purposes and structure.7 4.1.2 Abbreviations and conventions.7 4.2 Identification of the implementation 8 4.2.1 Date of the statement 8 4.2.2 Implementation Under Test (IUT) identification8 4.2.3 System Under Test

10、(SUT) identification 8 4.2.4 Product supplier 9 4.2.5 Client 9 4.2.6 PICS contact person9 4.3 PICS proforma tables .9 4.3.1 Global statement of conformance .9 4.3.2 Roles and network capabilities .10 5 Additional information for PICS10 History 11 ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 4 Intellectua

11、l Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: “Intellectual Property Rights (IP

12、Rs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards“, which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http:/webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR sear

13、ches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Technical Specification (TS) has been produc

14、ed by ETSI Technical Committee Telecommunications and Internet converged Services and Protocols for Advanced Networking (TISPAN). The present document is part 1 of a multi-part deliverable covering the Malicious Communication Identification (MCID) service, related to PSTN/ISDN simulation services, a

15、s identified below: Part 1: “Protocol Implementation Conformance Statement (PICS)“; Part 2: “Test Suite Structure and Test Purposes (TSS - for informative references. Referenced documents which are not found to be publicly available in the expected location might be found at http:/docbox.etsi.org/Re

16、ference. For online referenced documents, information sufficient to identify and locate the source shall be provided. Preferably, the primary source of the referenced document should be cited, in order to ensure traceability. Furthermore, the reference should, as far as possible, remain valid for th

17、e expected life of the document. The reference shall include the method of access to the referenced document and the full network address, with the same punctuation and use of upper case and lower case letters. NOTE: While any hyperlinks included in this clause were valid at the time of publication

18、ETSI cannot guarantee their long term validity. 2.1 Normative references The following referenced documents are indispensable for the application of the present document. For dated references, only the edition cited applies. For non-specific references, the latest edition of the referenced document

19、(including any amendments) applies. 1 ETSI TS 183 016: “Telecommunications and Internet converged Services and Protocols for Advanced Networking (TISPAN); PSTN/ISDN simulation services; Malicious Communication Identification (MCID); Protocol Specification“. 2 ETSI TS 181 002: “Telecommunications and

20、 Internet converged Services and Protocols for Advanced Networking (TISPAN); Multimedia Telephony with PSTN/ISDN simulation services“. 3 ETSI TS 181 006: “Telecommunications and Internet converged Services and Protocols for Advanced Networking (TISPAN); Direct Communication Service in NGN; Service D

21、escription Endorsement of OMA-ERELD-PoC-V1“. 4 ETSI TR 180 000: “Telecommunications and Internet converged Services and Protocols for Advanced Networking (TISPAN); NGN Terminology“. 5 ISO/IEC 9646-7: “Information technology - Open Systems Interconnection - Conformance testing methodology and framewo

22、rk - Part 7: Implementation Conformance Statements“. 6 IETF RFC 3966: “The tel URI for Telephone Numbers“. ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 6 7 IETF RFC 3986: “Uniform Resource Identifier (URI): Generic Syntax“. 2.2 Informative references The following referenced documents are not essential t

23、o the use of the present document but they assist the user with regard to a particular subject area. For non-specific references, the latest version of the referenced document (including any amendments) applies. Not applicable. 3 Definitions and abbreviations 3.1 Definitions For the purposes of the

24、present document, the terms and definitions given in TS 181 002 2, TS 181 006 3, TR 180 000 4 and the following apply: communication information: information collected and registered by the MCID service identity information: includes all the information (RFC 3966 6 / RFC 3986 7) identifying a user,

25、including trusted (network generated) and/or untrusted (user generated) identities trusted identity: network generated user address information untrusted identity: user generated user address information NOTE: This may contain additional information. 3.2 Abbreviations For the purposes of the present

26、 document, the following abbreviations apply: AS Application server HOLD communication HOLD IMS IP Multimedia Subsystem IP Internet Protocol ISDN Integrated Service Digital Network IUT Implementation Under Test MCID Malicious Call Identification MGCF Media Gateway Control Function NGN Next Generatio

27、n Network PSTN Public Switched Telephone Network SDP Session Description Protocol SIP Session Initiation Protocol SUT System Under Test UE User Equipment URI Uniform Resource Identifier ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 7 4 Protocol Implementation Conformance Statement proforma Notwithstanding

28、 the provisions of the copyright clause related to the text of the present document, ETSI grants that users of the present document may freely reproduce the PICS proforma in this clause so that it can be used for its intended purposes and may further publish the completed PICS. 4.1 Instructions for

29、completing the PICS proforma 4.1.1 More detailed instructions are given at the beginning of the different clauses of the PICS proforma The supplier of the implementation shall complete the PICS proforma in each of the spaces provided. If necessary, the supplier may provide additional comments separa

30、tely in clause 5. 4.1.1.1 Purposes and structure The purpose of this PICS proforma is to provide a mechanism whereby a supplier of an implementation of the requirements defined in reference specifications 1 to 7 may provide information about the implementation in a standardized manner. The PICS prof

31、orma is subdivided into clauses for the following categories of information: instructions for completing the PICS proforma; identification of the implementation; identification of the reference protocol specification; PICS proforma tables (containing the global statement of conformance). 4.1.2 Abbre

32、viations and conventions The PICS proforma is composed of an information in tabular form in accordance with the guidelines presented in ISO/IEC 9646-7 5. Item column It contains a number that identifies the item in the table. Item description column It describes each respective item (e.g. parameters

33、, timers, etc.). Reference column It gives reference to the MCID specification 1, except where explicitly stated otherwise. Status column The following notations, defined in ISO/IEC 9646-7 5, are used for the status column: m mandatory - the capability is required to be supported. n/a not applicable

34、 - in the given context, it is impossible to use the capability. No answer in the support column is required. o optional - the capability may be supported or not. ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 8 o.i qualified optional - for mutually exclusive or selectable options from a set. “i“ is an int

35、eger which identifies a unique group of related optional items and the logic of their selection which is defined immediately following the table. ci conditional - the requirement on the capability (“m“, “o“ or “n/a“) depends on the support of other optional or conditional items. “i“ is an integer id

36、entifying a unique conditional status expression that is defined immediately following the table. For nested conditional expressions, the syntax “IF . THEN (IF . THEN . ELSE.) ELSE .“ shall be used to avoid ambiguities. If an ELSE clause is omitted, “ELSE n/a“ shall be implied. NOTE: Support of a ca

37、pability means that the capability is implemented in conformance to the specification(s) 1 to 7. Support column The support column shall be filled in by the supplier of the implementation. The following common notations, defined in ISO/IEC 9646-7 5, are used for the support column: Y or y supported

38、by the implementation. N or n not supported by the implementation. N/A or n/a - no answer required (allowed only if the status is N/A, directly or after evaluation of a conditional status). 4.2 Identification of the implementation Identification of the Implementation Under Test (IUT) and the system

39、in which it resides - the System Under Test (SUT) should be filled in so as to provide as much detail as possible regarding version numbers and configuration options. The product supplier information and client information should both be filled in if they are different. A person who can answer queri

40、es regarding information supplied in the PICS should be named as the contact person. 4.2.1 Date of the statement Date of the statement: 4.2.2 Implementation Under Test (IUT) identification IUT name: IUT version: 4.2.3 System Under Test (SUT) identification SUT name: Hardware configuration: Operating

41、 system: ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 9 4.2.4 Product supplier Name: Address: Telephone number: Facsimile number: Additional information: 4.2.5 Client Name: Address: Telephone number: Facsimile number: Additional information: 4.2.6 PICS contact person Name: Telephone number: Facsimile num

42、ber: Additional information: 4.3 PICS proforma tables 4.3.1 Global statement of conformance (Yes/No) Are all mandatory capabilities implemented? ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 104.3.2 Roles and network capabilities Table 1: Roles and network capabilities Item Item description Reference Stat

43、us Support 1 UE Is the invocation of the MCID service provided? 4.5.2.12.1 o 2 UE Is the invocation of the MCID service using the XML MIME body mcid provided? 4.5.2.12.1 o 3 Is the MCID service in permanent case provided? 4.5.2.5 o1 4 Is the MCID service case by case provided? 4.5.2.5 o1 5 Is the in

44、vocation of MCID by sending XML-MIME with XML mcid body MCID XML Request schema containing a McidRequestIndicator set to 1 provided? 4.5.2.12.1 c.1 6 MGCF Is the interworking between MCID XML MIME body and ISUP IDR/IRS provided? 4.7.1 o 7 MGCF Is the interworking of the “Holding indicator“ provided

45、(for national use)? 4.7.1.1 o 8 Is a missing or incomplete originating ID requested? 4.5.2.5.3 c.1 c.1: IF 1/3 THEN o ELSE n/a. o.1: For this service, it is mandatory to support at least one of these items. 5 Additional information for PICS ETSI ETSI TS 186 018-1 V1.0.0 (2008-06) 11History Document history V1.0.0 June 2008 Publication