FORD ESB-M12G76-A-2012 BATT GLASS FIBER - VINYL COATED TO BE USED WITH FORD WSS-M99P1111-A 《乙烯基涂层玻璃纤维垫 与福特WSS-M99P1111-A 一起使用》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 02 2012 01 18 N Status No replacement named N. Benipal, NA 2006 08 24 Revised Inserted 3.0; Deleted 3.1, 3.9 and 4 1983 09 13 Released CLN1-C5N1-ED 453436-1 Controlled document at www.MATS Copyright 2012, Ford Global Technologies, LLC Pag

2、e 1 of 2 BATT, GLASS FIBER - VINYL COATED ESB-M12G76-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is made of glass fibers, molded with an inert thermosetting resin and spray coated with vinyl on one side. 2. APPLICATION This specification was released originall

3、y for material used as a molded sound absorber and heat insulator for the engine compartment of the 1984 Mark VII, Continental and medium trucks. 3. REQUIREMENTS Material specification requirements are to be used for initial qualification of materials. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERI

4、ALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 CONSTRUCTION 3.2.1 Fiberglass The fiberglass used for this specification shall meet the requirements of and be currently approved to ESB-M12G62-A, Fiberglass, M

5、olded-High Density. 3.2.2 Protective Coating Shall be a vinyl compound suitable for application to glass fiber insulation products. It shall be sprayed on the fiberglass at the rate of 97 +/- 22 g/m2 (dry weight). 3.3 COLOR 3.3.1 Glass Fiber Batt Amber or black 3.3.2 Vinyl Coating Black 3.4 COMPRESS

6、ION AND RECOVERY (FLTM BN 015-01, except use 2.3 kg load) 3.4.1 Compression, max 40% 3.4.2 Recovery, min 90% ENGINEERING MATERIAL SPECIFICATION ESB-M12G76-A Copyright 2012, Ford Global Technologies, LLC Page 2 of 2 3.5 COLD FLEXIBILITY No cracking or delamination of the vinyl coating Test Method: Cu

7、t two 50 x 150 mm samples. Condition samples for 4 h at -23 C. Bend 180 around a temperature conditioned 25 mm mandrel, vinyl side up. 3.6 HEAT RESISTANCE No softening, dripping or deteriorating of vinyl coating Test Method: Expose two 100 x 100 mm samples in a mechanical convection oven maintained

8、at 135 +/- 3 C for 1 h. 3.7 THERMAL CONDUCTIVITY, max 0.035 W/m/ K (ASTM C 177, 24 C mean temperature) 3.8 FLAMMABILITY, max 101 mm/min (FLTM BN 024-02, without the lot sampling plan) In addition, the test specimen shall not exhibit any flashing or sudden flaming on either surface in excess of the above maximum value.