FORD FLTM BB 101-18-2001 INSULATION ADHESION OF AUTOMOTIVE ELECTRICAL CABLE《汽车电缆的绝缘层粘附力》.pdf

1、 FORD LABORATORY TEST METHOD BB 101-18 Date Action Revisions 2001 03 02 Revised Editorial no technical change A. Cockman 1995 08 30 Printed copies are uncontrolled Page 1 of 3 Copyright 2001, Ford Global Technologies, Inc. INSULATION ADHESION OF AUTOMOTIVE ELECTRICAL CABLE Application This method de

2、termines the adhesion of the insulation sheath to the conductor of automotive electrical cable. Apparatus Required Sheet Metal Plate Having holes as required to perform test procedure Tensile Test Machine Conditioning and Test Conditions All test values indicated herein are based on material conditi

3、oned in a controlled atmosphere of 23 +/- 2 C and 50 +/- 5 % relative humidity for not less than 24 h prior to testing and tested under the same conditions unless otherwise specified. Procedure 1. Prepare test specimen as required by the relevant Engineering Materials Specification. 2. Remove the in

4、sulation from one end of the test specimen to a distance of 100 mm. 3. Feed the bare conductor through a sheet metal plate having a suitable hole diameter. The diameter to be equal to the diameter of the cable conductor plus a maximum of 0.1 mm. 4. Hang the conductor vertically in a tensile test mac

5、hine and load at a rate of 50 mm/minute (see Figure 1). 5. Record the force in Newtons required to remove the insulation sheath and compare to Table 1. The force must not be greater than that specified in Table 1. Chemicals, materials, parts, and equipment referenced in this document must be used an

6、d handled properly. Each party is responsible for determining proper use and handling in its facilities. FORD LABORATORY TEST METHOD BB 101-18 Page 2 of 3 Copyright 2001, Ford Global Technologies, Inc. Table 1 RETENTION OF CORE Nominal Removal Force Cross Section (mm sq) (N) 0.35 3 - 30 0.5 - 1.0 5 - 40 1.5 - 3.0 10 - 80 4.0 - 6.0 15 - 120 10.0 25 - 200 16.0 25 250 FORD LABORATORY TEST METHOD BB 101-18 Page 3 of 3 Copyright 2001, Ford Global Technologies, Inc. INSULATION ADHESION OF AUTOMOTIVE ELECTRICAL CABLE