FORD WRS-M1H1233-A1-2011 FABRIC FIFTH AVENUE PATTERN KNIT 100% PIR+PCR UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《第五大道模式编织100%聚三聚氰酸脂+聚合酶链反应的非层压织物 与福特WSS-M99P1111-A 一起使用》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 00 2011 09 20 Activated M. Dumitrescu, NA Controlled document at www.MATS Copyright 2011, Ford Global Technologies, LLC Page 1 of 2 FABRIC, FIFTH AVENUE PATTERN, KNIT, WRS-M1H1233-A1 100% PIR+PCR, UNLAMINATED 1. SCOPE The material defined

2、 is a Fifth Avenue pattern, a warp knit polyester face fabric. The fabric is made with 100% PIR and PCR (post industrial and post consumer) recycled yarn 2. APPLICATION This specification was released originally for material used as an interior trim fabric for C346N BEV 2012 seat bolster. The fabric

3、 was originally approved as trilaminated with foam and backing fabric/scrim. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part pr

4、oducers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). This material contains 100% recycled content as defined by WRS-M99P42-A2 (Textile Materials, Identification Of Recycled Content). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, -5 /+10 % tolerance (AST

5、M D 3775) Wales 138 / 10 cm Courses 154 / 10 cm 3.2.2 Fabric Weight, -5 / +10 % tolerance 325 g/m2 (FLTM BN 106-01) 3.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Face 167 dtex f96 (polyester 100% PIR texturized yarn) Middle 78 dtex f34 (polyester 100% PIR tex

6、turized yarn) ENGINEERING MATERIAL SPECIFICATION WRS-M1H1233-A1 Controlled document at www.MATS Copyright 2011, Ford Global Technologies, LLC Page 2 of 2 Back 167 dtex f96 (polyester 100% PIR texturized yarn) 111 dtex f36 (polyester 100% PIR and PCR yarn) 3.5 METHOD OF DYEING Piece Dyed or as approv

7、ed by Materials Engineering 3.6 FINISHED OPERATIONS Dye, tenter pad (resin), heatset, inspect, Or as approved by Materials Engineering 4. GENERAL INFORMATION This information given below is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications 4.1 Purchase departments will ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only.