FORD WRS-M1H1234-A1-2011 FABRIC WAVELENGTH PATTERN KNIT 100% PIR AND PCR LAMINATED EMBOSSED TO BE USED WITH FORD WSS-M99P1111-A 《波长模式编织100%聚三聚氰酸脂和聚合酶链反应的非层压有浮雕模式的织物 与福特WSS-M99P1.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 00 2011 09 20 Activated M. Dumitrescu, NA Controlled document at www.MATS Copyright 2011, Ford Global Technologies, LLC Page 1 of 2 FABRIC, WAVELENGTH PATTERN, KNIT WRS-M1H1234-A1 100% PIR AND PCR LAMINATED, EMBOSSED 1. SCOPE The material

2、 defined by this specification is a warp knit polyester face fabric, laminated with foam and scrim and roller embossed with Wavelength pattern. The fabric is made with 100% PIR and PCR (post industrial and post consumer) recycled yarn 2. APPLICATION This specification was released originally for mat

3、erial used as an interior trim fabric for C346N BEV 2012 seat bolster. The fabric was originally approved as Tri-laminated with foam and backing fabric/scrim. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable.

4、 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). This material must contain 100% recycled content as defined by WRS-M99P42-A2 (Textile Materials, Identification Of R

5、ecycled Content). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, -5 /+10 % tolerance (ASTM D 3775) Wales 154 / 10 cm Courses 142 / 10 cm 3.2.2 Fabric Weight, -5 / +10 % tolerance 307 g/m2 (FLTM BN 106-01) 3.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Face 167 dt

6、ex f96 (polyester 100% PIR texturized yarn) Middle 78 dtex f34 (polyester 100% PIR texturized yarn) ENGINEERING MATERIAL SPECIFICATION WRS-M1H1234-A1 Controlled document at www.MATS Copyright 2011, Ford Global Technologies, LLC Page 2 of 2 Back 167 dtex f96 (polyester 100% PIR texturized yarn) 111 d

7、tex f36 (polyester 100% PIR and PCR yarn) 3.5 METHOD OF DYEING Piece Dyed or as approved by Materials Engineering 3.6 FINISHED OPERATIONS Dye, tenter pad (resin), heatset, inspect, laminated, embossed, inspect, Or as approved by Materials Engineering 4. GENERAL INFORMATION The information given belo

8、w is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications. 4.1 Purchase departments will ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only.