FORD WRS-M1H1240-A1-2016 FABRIC SOLITUDE PATTERN FLAT WOVEN 25 % PIR UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A .pdf

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 01 2016 07 25 N Status Replaced by WRS-M1H1240-A23 D. Murtonen,NA 2013 05 10 Released M. Dumitrescu. NA Controlled document at www.MATS Copyright 2016, Ford Global Technologies, Inc. Page 1 of 2 FABRIC, SOLITUDE PATTERN, FLAT WOVEN WRS-M1

2、H1240-A1 25 % PIR, UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a Jacquard woven face fabric. The fabric is made with 25% PIR (Post Industrial) recycled yarn. 2. APPLICATION This specification was released originally for material used as an interio

3、r trim fabric for F-Series 2016 seat insert. The fabric was approved as backcoated. 3. REQUIREMENTS 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). Materials with re

4、cycled content as defined by WRS-M99P42-A2 (Textile Materials, Identification of Recycled Content) should be used whenever technically feasible. 3.1.1 This specification must contain 25% recycled content as defined by WRS-M99P42-A2. The remaining portion of the material can come from virgin sources

5、3.1.2 In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 340 ends/10 cm Weft 190 picks/10 cm 3.2.2 Fabric Weight, +/-10 % tolerance, (FLTM BN 10

6、6-01) Face fabric 328 g/m2 Backcoat 35 g/m2 Total weight 363 g/m2 3.3 COMPOSITION (ASTM D 629) Fabric 100% Polyester Backcoating Acrylic ENGINEERING MATERIAL SPECIFICATION WRS-M1H1240-A1 Copyright 2016, Ford Global Technologies, Inc. Page 2 of 2 Tolerance as specified in WSS-M8P18-A1/A4 3.4 YARN CON

7、STRUCTION (ASTM D 1244) Warp 167 dtex (solution dye, air texture polyester yarn) x 3 Weft 500 dtex (solution dye, false twist polyester yarn) 650 dtex (solution dye, air texture polyester yarn) 800 dtex (100% PIR solution dye, air texture yarn) 3.5 METHOD OF DYEING Solution dye 3.6 FINISHING OPERATI

8、ONS wash ,heat set, resin treatment, backcoat Or as approved by Materials Engineering 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications. 4.1 Purchase departments will ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only. 5. SUMMARY OF REVISIONS