FORD WSB-M1H589-A-2009 FABRIC NOBLE PATTERN KNIT TO BE USED WITH FORD WSS-M99P1111-A 《NOBLE图案的针织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2009 01 06 N-STATUS No Replacement B. Haggart, FNA 2003 01 22 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.10, 3.11, 4 deleted 1993 12 14 Released NB00I10043054305 B. Chen AJS BCF Printed copies are uncontro

2、lled Page 1 of 2 Copyright 2009, Ford Global Technologies, Inc. FABRIC, NOBLE PATTERN, KNIT WSB-M1H589-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a Noble pattern knit bodycloth of good quality and uniform composition. 2. APPLICATION This specification was

3、released originally for material used as an interior trim fabric for the 1995 Towncar. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSB-M8P1-H. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must co

4、nform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.3 FABRIC CONSTRUCTION 3.3.1 Fabric Count, +/- 5 % tolerance (ASTM D 3887) Wales 14.6 wales/cm Courses 25.6 courses/cm 3.3.2 Fabric Weight, min 435.0 g/m2(FLTM BN 106-01) ENGINEERING MATERIAL SPECIFICATION WSB-M1

5、H589-A Page 2 of 2 Copyright 2009, Ford Global Technologies, Inc. 3.4 COMPOSITION (ASTM D 629) Tolerance as specified in WSB-M8P1-H Fabric 78 % Polyester 22 % Nylon 3.5 YARN CONSTRUCTION (ASTM D 1244) Face 11.1 tex f33 (polyester, textured, semi-dull, round) Middle 7.7 tex f20 (nylon, semi-dull, rou

6、nd) Back (F) 7.7 tex f33 (polyester, semi-dull, round) (G) 7.7 tex f33 (polyester, semi-dull, round) 3.6 METHOD OF DYEING Piece dyed 3.7 FINISHING OPERATIONS Dye, dry, nap, shear, heatset 3.8 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute 3.9 STRETCH AND SET, %, range (SAE J855) Fabri

7、cs outside this range may be accepted provided they have been approved jointly by the Materials Engineering activity and the affected Design Engineering and Development activity. Stretch, range Wales Courses 6 - 30 10 - 35 Set, max* Wales Courses 12 14 *At no time shall the set exceed 40 % of the measured stretch unless approved jointly by the Materials Engineering activity and the affected Design Engineering and Development activity.