FORD WSS-M1H1055-A-2008 FABRIC “LATTICE” WOVEN JACQUARD (FLAT) UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《层压机织提花(平)格子布(同FORD WSS-M99P1111-A一起使用)》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 03 19 Activated M. Montgomery Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 1 of 2 FABRIC, “LATTICE”, WOVEN JACQUARD (FLAT), UNLAMINATED WSS-M1H1055-A 1. SCOPE The material defined by this specificatio

2、n is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for use in the V227 MCA. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4

3、as applicable. Tested with 4mm foam lamination. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 7% tolerance (ASTM D

4、3775) Warp 140 ends/10 cm Weft 140 picks/10 cm 3.2.2 Fabric Weight, +/- 3% tolerance (FLTM BN 106-01) 403 g/m23.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 1330dtex (real dtex 1300-1360 dtex),282f,(ATY Air textured, Semi Dull) Weft 1330dtex (real dtex 13

5、00-1360 dtex),282f,(ATY Air textured, Semi Dull) ENGINEERING MATERIAL SPECIFICATIONWSS-M1H1055-APrinted copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.5 METHOD OF DYEING Package dyeing/bobbin dyeing: Fixation of the textured yarn at 100 (autoclave). Winding the t

6、extured yarn from the “standard” cops to the perforated dyeing core. Package dyeing at 135. Centrifuge HF drying 3.6 FINISHED OPERATIONS Open width washing line at 90 (water & soap) Calendaring process at 180 (upside down on the hot cylinder) Stentering/thermofixation at 180 Flame lamination Final i

7、nspection Dispatch 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.