FORD WSS-M1H1086-A-2006 FABRIC SAGRES PATTERN WOVEN JACQUARD TO BE USED WITH FORD WSS-M99P1111-A 《SAGRES图案的提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2006 06 12 Activated L. Neves Printed copies are uncontrolled Copyright 2006, Ford Global Technologies, LLC Page 1 of 2 FABRIC, SAGRES PATTERN, WOVEN JACQUARD WSS-M1H1086-A 1. SCOPE The material defined by this specification is a woven jacquar

2、d polyester fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for BV 226 - 2008 Model Year Low Series. 3. REQUIREMENTS Material specification requirements are to be used for initial qualification of materials. In addition to the requiremen

3、ts listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements for Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCT

4、ION 3.2.1 Fabric Count, range (ASTM D 3775) Warp 27 - 29 yarn/cm Fill 18 - 20 yarn/cm 3.2.2 Fabric Weight, range (FLTM BN 106-01) Seat (laminated to 4 mm foam + backing fabric) 360 - 450 g/m 3.3 COMPOSITION (ASTM D 629) Fabric 100% Polyester Foam PUR/Polyether Backing Fabric 100% Polyamide ENGINEERI

5、NG MATERIAL SPECIFICATIONWSS-M1H1086-A Printed copies are uncontrolled Copyright 2006, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 384 dtex, f 96, Semi Dull, Round, Textured Polyester Fill 570 dtex, f 144, Semi Dull, Round, Air Textured Polyester 3.5 METHOD OF

6、DYEING Warp Solution Dyed Fill Yarn Dyed 3.6 FINISHING OPERATIONS Heat Set 3.7 THICKNESS, mm, range (ASTM D 1777) Seat (laminated to 4 mm foam + backing fabric) 2.0 3.15 mm 3.8 TRIMMABILITY PROPERTIES 3.8.1 Stretch, %, range (SAE J855) Seat and Door Panel Warp 2.0 6.0% Fill 1.5 4.0% 3.9 FLAMMABILITY

7、 (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that material defined in this specification and shipped to anyone assembly plant will be produced by one supplier only.