FORD WSS-M1H1114-A-2007 SAVANA MEDIUM DK GRAPHITE PLAIN WOVEN - TO BE USED WITH FORD WSS-M99P1111-A 《SAVANA MEDIUM DK GRAPHITE图案的平纹机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2007 08 22 Activated L. Neves Printed copies are uncontrolled Copyright 2007, Ford Global Technologies, LLC Page 1 of 2 SAVANA MEDIUM DK GRAPHITE, PLAIN WOVEN WSS-M1H1114-A 1. SCOPE The material defined by this specification is a plain woven p

2、olyester fabric. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for F-250 MY 2007. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIR

3、EMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements for Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 11 yarn/cm Fill 11 yarn/cm 3.2.2 Fabric Weight, (FLTM B

4、N 106-01) Seat (laminated to 3.0 mm foam) 570 g/m2+/- 10% 3.3 COMPOSITION (ASTM D 629) Fabric 100% Polyester Foam - Seat PUR/Polyether - D28 - 5.0mm +/-0.5mm Backing Fabric (Seats only) 100% Polyester - 45g/m2+/-10% ENGINEERING MATERIAL SPECIFICATIONWSS-M1H1114-A Printed copies are uncontrolled Copy

5、right 2007, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM D 1244) Warp 1300 dtex f240 Semi Dull, Round, Air Textured Polyester Fill 1300 dtex f240 Semi Dull, Round, Air Textured Polyester 3.5 METHOD OF DYEING Warp Yarn Dyed Fill Yarn Dyed 3.6 FINISHING OPERATIONS Heat Set 3.7

6、 THICKNESS, mm, range (ASTM D 1777) Seat (laminated to 3.0 mm foam + backing fabric) 3.1 - 4.8 mm 3.8 TRIMMABILITY PROPERTIES 3.8.1 Stretch, %, range (SAE J855) Seat Warp 3.0 - 10% Fill 2.0 7.0% 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 4.1 Purchase departments will ensure that material defined in this specification and shipped to anyone assembly plant will be produced by one supplier only.