FORD WSS-M1H1152-A1-2012 FABRIC ULTIMATE PATTERN DOBBY WOVEN UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A .pdf

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev. 0 2012 09 04 Released M. Montgomery, FOE Controlled document at www.MATS Copyright 2012, Ford Global Technologies, LLC Page 1 of 3 FABRIC, ULTIMATE PATTERN, DOBBY WOVEN WSS-M1H1152-A1 UNLAMINATED 1. SCOPE The material defined is a dobby

2、woven polyester face fabric embossed. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for B299 MCA 2013.5 MY seat insert. The fabric was originally approved as trilaminated with foam and backing fabric/scrim. 3. REQUIREMENTS 3.1 STANDARD REQUIRE

3、MENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.1.1 WSS-M1H1152-A1. This specification is based on virgin materials. 3.1.2 In addition to the requirements listed herein, the fabric sh

4、all meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10 % tolerance (ASTM D 3775) warp 270 / 10 cm weft 180/ 10 cm 3.2.2 Fabric Weight, +/- 10 % tolerance 315 g/m2 (FLTM BN 106-01) 3.3 COMPOSITION (ASTM D 629) Fabric 100% polyester 3.4 YAR

5、N CONSTRUCTION* (ASTM D 1244) Warp 600dtexf144(polyester,semi-dull,air texturized, round section) Weft 600dtex f144(polyester, semi-dull, air texturized, round section) ENGINEERING MATERIAL SPECIFICATION WSS-M1H1152-A1 Copyright 2012, Ford Global Technologies, LLC Page 2 of 2 3.5 METHOD OF DYEING So

6、lution Dyed or as approved by Materials Engineering, 3.6 FINISHED OPERATIONS Washing, Drying, Framing or as approved by Materials Engineering. 3.7 SPECIFIC OPERATIONS Deep embossing after lamination 4. GENERAL INFORMATION The information given below is provided for clarification and assistance in me

7、eting the requirements of this specification. Contact for questions concerning Engineering Material Specifications. 4.1 Purchase departments will ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only. 4.2 If yarn is locally sourced it must meet the above fabric construction, composition and yarn construction. The fabric must also meet the requirements of WSS-M8P18-A1/A2/A3/A4. 4.3 Global strategy for this fabric is to use tri-laminate/foam & scrim construction in all regions.