FORD WSS-M1H1157-A2-2013 FABRIC LC TWILL WOVEN JACQUARD UNLAMINATED WITH ANTI SOILING COATING TO BE USED WITH FORD WSS-M99P1111-A (Shown on FORD WSS-M1H1157-A1).pdf

1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev 00 2013 09 25 Released M. Montgomery, EU Controlled document at www.MATS Copyright 2013, Ford Global Technologies, LLC Page 1 of 2 FABRIC, LC TWILL, WOVEN JACQUARD, WSS-M1H1157-A1 UNLAMINATED FABRIC, LC TWILL, WOVEN JACQUARD, WSS-M1H1157-

2、A2 UNLAMINATED, WITH ANTI SOILING COATING 1. SCOPE A1 - The material defined by this specification is a woven jacquard polyester face fabric. A2 The material defined by this specification is a woven dobby polyester face fabric that has been treated with an anti-soiling coating to meet the stain resi

3、stance requirement of the fabric performance specification. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for use in the 2014 Model Year B car. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requiremen

4、ts of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10 ends-picks/10 cm tolera

5、nce (ASTM D 3775) Warp 245 ends/10 cm Weft 125 picks/10 cm 3.2.2 Fabric Weight, +/- 7 % tolerance (FLTM BN 106-01) 350 g/m2 3.3 COMPOSITION (ASTM D 629) Fabric 100% polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H1157-A1/A2 Copyright 2013, Ford Global Technologies, LLC Page 2 of 2 3.4 YARN CONST

6、RUCTION (ASTM D 1244) Warp 890dtex, 192f, (Air textured, semi-dull) Weft 890dtex, 192f, (Air textured, semi-dull) 3.5 METHOD OF DYEING Package dyed or as approved by Materials Engineering 3.6 FINISHED OPERATIONS As approved by Materials Engineering - Washing (open width) - Stentering 4. GENERAL INFO

7、RMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications. 4.1 Purchase departments will ensure that the material defined in this specification and shipped

8、to any one assembly plant will be produced by one supplier only. 4.2 If yarn is locally sourced it must meet the above fabric construction, composition and yarn construction. The fabric must also meet the requirements of WSS-M8P18-A1/A2/A3/A4. 4.3 Global strategy for this fabric is to use tri-laminate/foam & scrim construction in all regions