FORD WSS-M1H723-A-2008 FABRIC DOLOMITI JACQUARD WOVEN TO BE USED WITH FORD WSS-M99P1111-A 《DOLOMITI图案的提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE2003 03 20 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.18, 3.19, 4 deleted 1996 07 29 Activated N. Komatsu Printed copies are unco

2、ntrolled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, DOLOMITI, JACQUARD WOVEN WSS-M1H723-A NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for

3、 material used as an interior trim fabric for the 1998 MY BE91. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric/laminate shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part produc

4、ers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 300 ends/10 cm Weft 170 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 290 - 330 g/m23.5 COMPOSITION (ASTM D 629

5、) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H723-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 630 +/- 50 dtex f132- 144 (polyester, dull, round, air texturised) Weft 630 +/- 50 dtex f132- 144 (polyester, dull, round, air

6、texturised) 3.7 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification. 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.