FORD WSS-M1H745-A-2008 FABRIC CHRISTO PATTERN WOVEN JACQUARD UNLAMINATED TO BE USED WITH FORD WSS-M99P1111-A 《CHRISTO图案的不分层提花机织织物 与标准FORD WSS-M99P1111-A一起使用 》.pdf

1、 ENGINEERING MATERIAL SPECIFICATIONDate Action Revisions 2008 02 06 N-STATUS No replacement named M. Dumitrescu 2003 03 24 Revised Para 3.0 inserted ; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1997 10 28 Activated N.J. Komatsu Printed copies are uncontrolled Copyright 2008, Ford Global Technologies,

2、 LLC Page 1 of 2 FABRIC, CHRISTO PATTERN, WOVEN JACQUARD, WSS-M1H745-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was released originally for material used as an interior t

3、rim fabric for 1999 MY BE 146. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard

4、Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 10% tolerance (ASTM D 3775) Warp 242 ends/10 cm Weft 150 picks/10 cm 3.4.2 Fabric Weight, range +/- 15% (FLTM BN 106-01) 285 - 320 g/m23.5 COMPOSITION (ASTM D 629) Fabric 100% polyester ENGINEERIN

5、G MATERIAL SPECIFICATIONWSS-M1H745-A Printed copies are uncontrolled Copyright 2008, Ford Global Technologies, LLC Page 2 of 2 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 760 dtex f192 (polyester, round, air texturized, semi-dull) *730 dtex f144 (polyester, trilobal, air texturized, bright) * Chris col

6、or version only Weft 760 dtex f192 (polyester, round, air texturized, semi-dull) 3.7 METHOD OF DYEING Yarn dyed and spun or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not re

7、quired on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification: 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.